Thermal properties of epoxy resin nanocomposites based on hydrotalcites

Synthesis, characterization, and properties of thermoplastic polyimides derived from 4,4’-(hexafluoroisopropylidene)diphthalic anhydride in diethylene glycol dimethyl ether

By regulating the order of monomer addition, four kinds of copolymer polyimides (PIs) were prepared using diethylene glycol dimethyl ether (DEGDE) and N, N-dimethylacetamide (DMAc) as the solvents. The molecular weights of polyamide acids (PAAs) ranged from 3.8 × 105 to 9.2 × 105. All of the films displayed high glass transition temperatures ( Tgs) ranging from 313°C to 346°C. The polymer films show excellent thermal stabilities with 5% weight loss at temperatures of 505–524°C and char yields at 800°C were as high as 55% under nitrogen. The peel strengths of flexible copper (Cu) clads were in the range from 0.337 N cm−1 to 0.598 N cm−1. Compared to the molecular weight and peel strength of fresh PAA, those of PAAs prepared using DMAc significantly decreased after storage for 3 months at 0°C. However, when DEGDE was used as the solvent, the molecular weights of the PAAs and the thermal properties of the PIs were maintained after long storage time.

Studying the Effects of Adding Silica Sand Nanoparticles on Epoxy Based Composites

The research about the preparation of submicron inorganic particles, once conducted in the past decade, is now leading to prepare polymer matrix composite (PMC) reinforced with nanofillers. The objective of present research is to study the modified effects of reinforcement dispersion of nanoparticle silica in epoxy resin on the physical properties, mechanical and thermal behaviour, and the microstructure of resultant composites. Stirrer mixing associated with manual mixing of silica sand nanoparticles (developed in our earlier research) (Ahmad and Mamat, 2012) into epoxy was followed by curing being the adopted technique to develop the subject nanocomposites. Experimental values showed that 15 wt.% addition of silica sand nanoparticles improves Young’s modulus of the composites; however, a reduction in tensile strength was also observed. Number of holes and cavities produced due to improper mixing turn out to be the main cause of effected mechanical properties. Addition of silica sand nanoparticles causes a reduction in degree of crystallinity of the nanocomposites as being observed in differential scanning calorimetry (DSC) analysis.