Physico-chemical properties of new composite polymer for heat resistance with thin-film form through the blending of m-aramid and polyurethane (PU)

Properties of Luffa Cylindrica Mats Reinforced Castor Oil-Based Polyurethane Composite as an Alternative for Oriented Strand Board

The main objective of this work was to produce and characterize a novel ecofriendly castor oil-based polyurethane (COPU) matrix composite reinforced by Luffa cylindrica mats, luffa for short, to be used as panels, as an alternative to oriented strand board (OSB). To do so, the mechanical behavior was evaluated by tree point flexural, perpendicular o surface tensile, screw pullout, and impact tests that were carried on the novel composite along with the neat matrix. Furthermore, the physical characteristics, the thermomechanical behavior, and the functional groups of the materials were observed by water absorption and thickness swelling tests along with dilatometry and Fourier transform infrared spectroscopy (FTIR). A comparison with commercialized OSB was also performed for control. The luffa/COPU composite was prepared by hand lay-up with 48 vol% of luffa mats incorporated as the maximum allowed by the mold under the available resources for manufacturing. The luffa fibers acted as a good reinforcement for the COPU matrix, where the flexural strength and modulus of elasticity were increased by more than 23 and 10 times, respectively, and the other mechanical properties more than doubled for the composites compared to the neat COPU resin. In general, the composite presented a lower performance compared to the commercial OSB, with the impact results being the exception. The water absorption and thickness swallowing results showed an already-expected behavior for the studied materials, where the better performance was found for the hydrophobic neat resin. The FTIR revealed that there was little interaction between luffa and COPU resin, which can be translated to a weak interface between these materials. However, the mechanical behavior, together with the other results presented by the luffa/COPU composite, confirm it is more than enough to be used as civil construction panels such as OSB.

Chlorination Treatment of Meta-Aramid Fibrids and Its Effects on Mechanical Properties of Polytetramethylene Ether Glycol/Toluene Diisocyanate (PTMEG/TDI)-Based Polyurethane Composites

Meta-aramid fibrids (MAF) have attracted much attention. However, it is difficult for this high mechanical performance fiber to form sufficient interface adhesion between the MAF and polyurethane (PU) matrix due to the chemical inertness of its surface. Thus, the surface activity of MAF should be improved to obtain a high-performance MAF/PU composite. A novel methodology to modify the surface of MAF with a sodium dichloroisocyanurate solution (DCCNa) was developed to obtain chlorinated MAF (MAFC) in this study. A series of MAFC/PU composites was prepared by in situ polymerization processes. The results of Fourier-transform infrared spectroscopy (FTIR) and X-ray photoelectron spectroscopy (XPS) demonstrated that the chlorine-contained chemical groups were introduced onto the MAF surfaces after chlorination. Dynamic contact angle analysis (DCAA) revealed that the surface wettability and the surface free energy of the MAFC were significantly improved, which allowed for strong chemical bonding to PU. Scanning electron microscopy (SEM) showed a uniform distribution of MAFC and good interfacing bonding between the MAFC and PU. With the incorporation of 1.5 wt% MAFC into the polyurethane matrix, the tensile and tear strength values of MAFC/PU were 36.4 MPa and 80.1 kN·m⁻¹ respectively, corresponding to improvements of approximately 43.3% and 21.1%, as compared to those of virgin PU as 25.4 MPa and 66.1 kN·m⁻¹, respectively.