Densification, microstructure evolution and fatigue behavior of Ti-13Nb-13Zr alloy processed by selective laser melting

On the Role of ZrN Particles in the Microstructural Development in a Beta Titanium Alloy Processed by Laser Powder Bed Fusion

Additive manufacturing of titanium alloys usually ends up with large columnar grains due to the steep thermal gradients within melt pools during solidification. In this study, ZrN particles were added into a beta titanium alloy, Ti-10V-2Fe-3Al, with the aim of promoting columnar-to-equiaxed grain transition during laser bed powder fusion (L-PBF). It was found that the addition of ZrN leads to the development of alternate layers of equiaxed grains and refined columnar grains, which is in sharp contrast to the dominant large columnar grains formed in the pure L-PBF-processed titanium alloy. An investigation on single laser melted tracks revealed that the sample with added ZrN showed fine equiaxed grains in the upper regions of solidified melt pools and columnar grains in the lower regions, whereas the solidified melt pools of the pure titanium alloy were dominated by large columnar grains due to epitaxial growth from the previous layer. The formation of equiaxed grains in the former sample is attributed to multiple factors including an increased gradient of liquidus temperature due to the solution of N and a reduced actual melt temperature gradient due to the melting of high-melting-point ZrN particles, which would have expanded constitutional undercooling, a grain growth restriction effect induced by the segregation of N along grain boundaries and the accumulation of unmelted ZrN particles in the upper regions of melt pools. The addition of ZrN also resulted in significant α precipitation, which showed strong variant selection and was found to be driven by laser reheating and the N solution in the matrix.