Pre-formulation studies for water-dispersible powdered beverages using contact angles and wetting properties

Optimization of the Multienzyme-Assisted Extraction Procedure of Bioactive Compounds Extracts from Common Buckwheat (Fagopyrum esculentum M.) and Evaluation of Obtained Extracts

Optimization of the extraction procedure using a multienzymes cocktail for common buckwheat (Fagopyrum esculentum M.) is important due to the yield, fermentable sugars, oligosaccharides and bioactive compounds for creating higher added value products. This study was undertaken to find out the optimum multienzymes-water extraction on yield and total phenolic compounds for common Buckwheat using response surface methodology (RSM). Three independent variables, time (2, 13, and 24 h), temperature (60 °C, 70 °C, 80 °C), and non-starch polysaccharide (NSP) enzymes mixture (0.10, 0.55, and 1.00 mL), were analyzed to optimize the response variables. NSP hydrolyzing enzymes, cellulase, xylanase, and β-glucanase, were produced by Trichoderma reesei. Estimated optimum conditions for F. esculentum were found: time-2 h, temperature-65 °C, and cellulase activity-8.6 CellG5 Units/mL. Different optimization run samples were collected and lyophilized for further analysis until the hydrophilic property using the water contact angle methodology and rutin content using HPLC was determined. Results indicated NSP enzymes activity did not differ between water contact angles after 13 h of enzymatic water extraction. However, longer fermentation time (24 h) decreased static water contact angle by approximately 3-7° for lyophilized water extract and 2-7° for solid fraction after fermentation. It implies enzymatic hydrolysis during water extraction increased hydrophilic properties in solid fraction and decreased hydrophilicity in water fraction due to the enzymes cleaved glycosidic bonds releasing water-soluble compounds.

Development, characterization and optimization of biopolymers films based on starch and flour from jabuticaba (Myrciaria cauliflora) peel

In this study, the influence of the concentration of flour from jabuticaba peel (FJP) and the concentration of glycerol (CG) on the physicochemical, barrier, mechanical, optical, spectroscopic and biodegradability properties of corn starch films was evaluated using response surface methodology. The increase in the concentrations of FJP and CG enhanced the thickness and permeability to water vapor, and made the films more hydrophilic. In addition to that, the interaction between the two variables caused reduction in the solubility of the films. High concentrations of FJP and CG reduced the maximum tensile strength, and increased CG increased the elongation and decreased the young's modulus of the films. Among the tests studied, the T1 film (15.80% FJP and 15.80% CG) was biodegradable, presenting the best mechanical and barrier properties such as low water vapor permeability, solubility and water holding capacity, showing great potential to be used as biodegradable packaging system.