Experimental study on the preparation method of coal-like materials based on similarity of material properties and drilling parameters

Study on the Solution and Variation Law of Diffusion Coefficient Based on the Numerical Simulation Optimization Method

Since the diffusion coefficient is a key parameter to characterize the diffusion rate of methane molecules, its measurement and solution have always been a research hotspot. The diffusion coefficient is normally solved through analytical solutions of theoretical models, which is complex and poorly applicable. In comparison, the numerical simulation optimization method can seek a solution easily and quickly, providing a clue for solving such problem. In this paper, first, gas desorption experiments were conducted on coal samples with different initial gas equilibrium pressures, coal particle sizes, and metamorphic degrees. Combined with existing theoretical models, the numerical simulation optimization method was adopted to solve the diffusion coefficient of the coal particle. Furthermore, the applicability and advantages of the numerical simulation optimization method were discussed. Finally, the variation law of the diffusion coefficients was analyzed. The results demonstrate that the numerical simulation optimization method can not only solve the diffusion coefficient easily and quickly but also reveal the law of diffusion concentration with time. The d values between the solution results and the experimental data under different conditions are all smaller than 0.2, which proves the effectiveness and accuracy of the simulation optimization method. The diffusion coefficient of gas from coal particles is unrelated to the initial gas equilibrium pressure, yet it has a Z-shaped relationship with the coal particle size and a V-shaped relationship with the metamorphic degree.

Temperature Variation Law of Core Tube Wall during Coring in Different Strength Coal Seams: Experiment and Modelling

Temperature is the primary factor affecting the law of coal gas desorption. When the core method is used to measure the coal seam gas content (CSGS), the temperature of the coal core sample (CCS) will increase. The heat generated by the core bit cutting and rubbing the coal during coring is transferred to the CCS through the core tube, resulting in the temperature rising of the CCS. Because the CCS entering the core tube during coring is a dynamic process, the temperature of CCS is difficult to measure. To solve this problem, the temperatures of the core tube wall during coring in the Jiulishan coal mine (JLS), Guhanshan coal mine (GHS) and Zhaogu coal mine (ZG) at the core depth of 20 m were measured by the self-designed temperature measuring device. The thermodynamic models of the core bit and the core tube during coring were established. The reliability of the model was verified by comparing the numerical simulation results with the field measurement results. The verified model was used to predict the temperature changes of the core tube wall during coring in different strength coal seams and different core depths. The results show that the temperature change of the core tube wall was divided into a slowly temperature rising stage Ⅰ, a fast temperature rising stage Ⅱ and a slowly temperature rising and slowly temperature falling stage Ⅲ, which correspond to the process of pushing the core tube, drilling the CCS and early stage and later stage of withdrawing the core tube, respectively. The maximum temperature of the core tube wall appears in the first 3 min of withdrawing the core tube, and increases with the core depth increasing. The temperature of the measuring point at the end of drilling the CCS and the maximum temperature during coring linearly increase with the core depth. The temperature heating rate of the core tube is negatively linear, with the coal seam strength during pushing the core tube wall process. However, the temperature heating rate of the core tube wall is positively linear with the coal seam strength during drilling the CCS process. This study can provide a basis for further research on the dynamic distribution characteristics of temperature in the CCS during coring, which is of profound significance to calculate the gas loss amount and CSGC.