Pediatric ventricular assist devices: Trends in device utilization

The evolution of long-term pediatric ventricular assistance devices: a critical review

Introduction: The gap between the number of heart failure patients and the number of potential heart donors has never been larger than today, especially among the pediatric population. The use of mechanical circulatory support is seen as a potential alternative for clinicians to treat more patients. This treatment has proven its efficiency on short-term use. However, in order to replace heart transplant, the techniques should be used over longer periods of time.Areas covered: This review aims at furnishing an engineering vision of the evolution of ventricular assistance devices used in pediatrics. A critical analysis of the clinical complications related to devices generation is made to give an overview of the design improvements made since their inception.Expert opinion: The long-term use of a foreign device in the body is not without consequences, especially among fragile pediatric patients. Moreover, the size of their body parts increases the technical difficulties of such procedure. The balance between the living cells of the body is disturbed by the devices, mostly by the shear stress generated. To provide a safe mechanical circulatory support for long-term use, the devices should be more hemocompatible, preserving blood cells, adapted to the patient's systemic grid and miniaturized for pediatric use.

Methods for determination of stagnation in pneumatic ventricular assist devices

Background:

A pneumatic paediatric ventricular assist device developed at the Foundation of Cardiac Surgery Development, Zabrze, equipped with valves based on J. Moll’s design, with later modifications introduced at the Institute of Turbomachinery, Lodz University of Technology, was tested numerically and experimentally. The main aim of those investigations was to detect stagnation zones within the ventricular assist device and indicate advantages and limitations of both approaches.

Methods:

In the numerical transient test, a motion of the diaphragm and discs was simulated. Two different methods were used to illustrate stagnation zones in the ventricular assist device. The flow pattern inside the chamber was represented by velocity contours and vectors to validate the results using images obtained in the laser particle image velocimetry experiment.

Results:

The experimental light-based method implied problems with proper illumination of regions in the wall vicinity. High-resolution flow data and other important parameters as stagnation regions or flow patterns in regions not accessible for light in the particle image velocimetry method are derived in the numerical solution. However, computations of a single case are much more time-consuming if compared to a single experiment conducted on a well-calibrated stand.

Conclusion:

The resulting main vortexes in the central part of the pump chamber and the velocity magnitudes are correlated in both methods, which are complementary and when used together offer better insight into the flow structure inside the ventricular assist device and enable a deeper analysis of the results.