Evaluation of the effect of anolyte recirculation and anolyte pH on the performance of a microbial fuel cell employing ceramic separator

Electrochemical process for petroleum refinery wastewater treatment to produce power and hydrogen using microbial electrolysis cell

This research aims to assess the microbial electrolysis cell (MEC) fed with petroleum refinery wastewater (PRW) to produce power density and bio-electrochemical hydrogen. The MEC produces a maximum bio-electricity of 21.4 mA and a power density of 1200123.90 W/m2 with a loading of chemical oxygen demand (COD) of 17000 mg/L. Due to catalyzed oxidation of complex compounds in PRW with a maintained microbial biofilm growth was observed after 90 d of operation of MEC. Results showed that the oxidation of organic substances in PRW enhanced the size in the growth of microbial film which further increased the generation of electrons leading to current density of 5890 mA/m2. The COD removal efficiency of MEC was found to be 89.9%. The bio-electricity and hydrogen production of the MEC was estimated to be 24.5 mA and 19.2 L respectively when loaded with PRW having a COD of 17500 mg/L after 130 d. Present experiments demonstrate the efficiency of MEC technology efficiency in treating petroleum wastewater with the help of microbial biofilm.

Biodegradation of petroleum wastewater for the production of bioelectricity using activated sludge biomass

Objective

This research is based on the treatment of petroleum wastewater (PWW) with pretreated activated sludge for the production of electricity and removal of chemical oxygen demand (COD) using microbial fuel cell (MFC).

Methods

The application of the MFC system which uses activated sludge biomass (ASB) as a substrate resulted in the reduction of COD by 89.5% of the original value. It generated electricity equivalent to 8.18 mA/m2 which can be reused again. This would solve the majority of environmental crises which we are facing today.

Results

This study discusses the application of ASB to enhance the degradation of PWW for the production of a power density of 1012.95 mW/m2 when a voltage of 0.75 V (voltage) is applied at 30:70% of ASB when MFC is operated in a continuous mode. Microbial biomass growth was catalyzed using activated sludge biomass. The growth of microbes was observed by scanning through an electron microscope. Through oxidation in the MFC system, bioelectricity is generated which is used in the cathode chamber. Furthermore, the MFC operated using ASB in a ratio of 35 with the current density, which decreased to 494.76 mW/m2 at 10% ASB.

Application

Our experiments demonstrate that the efficiency of the MFC system can generate bioelectricity and treat petroleum wastewater by using activated sludge biomass.

Microbial electro deionization for waste water treatment - A critical review on methods, applications and mechanism

Electro deionization using microbial communities has been proven as a competent method for desalination and abatement of water pollution by removing ionic chemicals from the target waters. Microbial Desalination Cell (MDC) facilitates microbial deionization which can either support or be a substitute for the conventional desalination methods. Generation of electricity is accomplished by the bio electrochemical oxidation of organic compounds present as contaminants in wastewater which in turn attribute to the migration of ions in MDC system. The present review aims to elucidate the theory, principles and the application of microbial desalination cell and microbial fuel cell (MFC) in treatment of saline and wastewaters. Air cathode MDC and stacked MDC for purification of saline water are found to give promising results. Air pump assisted microbial desalination cell reported 150.39 ppm h^-1 of salt removal with an operational time period of 80 h and showed consistent results. Hence the air cathode assisted MDC showed dominant capacity of salt removal compared to stacked MDC. Also, three major types of microbial fuel cell, namely photosynthetic biofilm MFC, constructive wetland MFC and ceramic membrane supported MFC are reviewed for their potentials in wastewater treatment by deionization method and electricity generation. Complete (100%) removal of chemical oxygen demand was reported by photosynthetic microbial fuel cell operated for 16 days having 435.8 Ω of external resistance. When constructive wetland microbial fuel cell was operated for 10 days with 1000 ohms of external resistance, it exhibited complete (100%) removal of chemical oxygen demand from the wastewater. About 92% of chemical oxygen demand removal was demonstrated by ceramic membrane supported microbial fuel. Compared to ceramic membrane microbial fuel cell, photosynthetic and constructive wetland microbial fuel cell displayed better performance in terms of pollutant removal capacity and economical factor. Ability of the electrogenic species, namely Geobacter, Shewanella, Clostridium and Bacillus and the photosynthetic species, namely Chorella Vulgaris Rhodopsuedomonas, and Scenedesmus abundans in microbial deionization methods and their performance levels reported by several researchers are presented.

Use of Pineapple Waste as Fuel in Microbial Fuel Cell for the Generation of Bioelectricity

The excessive use of fossil sources for the generation of electrical energy and the increase in different organic wastes have caused great damage to the environment; these problems have promoted new ways of generating electricity in an eco-friendly manner using organic waste. In this sense, this research uses single-chamber microbial fuel cells with zinc and copper as electrodes and pineapple waste as fuel (substrate). Current and voltage peaks of 4.95667 ± 0.54775 mA and 0.99 ± 0.03 V were generated on days 16 and 20, respectively, with the substrate operating at an acid pH of 5.21 ± 0.18 and an electrical conductivity of 145.16 ± 9.86 mS/cm at two degrees Brix. Thus, it was also found that the internal resistance of the cells was 865.845 ± 4.726 Ω, and a maximum power density of 513.99 ± 6.54 mW/m2 was generated at a current density of 6.123 A/m2, and the final FTIR spectrum showed a clear decrease in the initial transmittance peaks. Finally, from the biofilm formed on the anodic electrode, it was possible to molecularly identify the yeast Wickerhamomyces anomalus with 99.82% accuracy. In this way, this research provides a method that companies exporting and importing this fruit may use to generate electrical energy from its waste.

Ceramic-microbial fuel cell (C-MFC) for waste water treatment: A mini review

Microbial fuel cell (MFC) is a bio-electrochemical system that utilizes the activity of electrogenic bacteria to generate electricity. When wastewater is used as feed in MFC, its organic constituents are hydrolyzed and oxidized by the bacteria. Hence, this technology is a source of clean electricity while simultaneously treating wastewater. Over the years much research has been done to improve its efficiency as well as to reduce the cost of implementation and functioning. However, scalability and commercialization of this technology still faces several challenges. This mini review discusses the use of ceramics in MFCs using wastewater feed as a method of overcoming the current technological challenges. Ceramics can be used as separators, chassis or electrode, conferring facile chemical and structural stability. The material is low-cost, environment-friendly and easily available. Studies reporting stacked configurations have been mentioned, and those that have reported field studies and technology oriented practical applications. Critical analysis of the scalability of the use of ceramics for the dual purpose of electricity generation as well as wastewater treatment has been done in this review. Future research directives towards potential sustainable commercialization have also been mentioned. C-MFC is a promising technology and the primary aim of this review is to help enhance the knowledge base for the optimization of use of ceramics in MFC to achieve large-scale clean electricity generation and sewage treatment.

Bio-electrochemical frameworks governing microbial fuel cell performance: technical bottlenecks and proposed solutions

Microbial fuel cells (MFCs) are recognized as a future technology with a unique ability to exploit metabolic activities of living microorganisms for simultaneous conversion of chemical energy into electrical energy. This technology holds the promise to offer sustained innovations and continuous development towards many different applications and value-added production that extends beyond electricity generation, such as water desalination, wastewater treatment, heavy metal removal, bio-hydrogen production, volatile fatty acid production and biosensors. Despite these advantages, MFCs still face technical challenges in terms of low power and current density, limiting their use to powering only small-scale devices. Description of some of these challenges and their proposed solutions is demanded if MFCs are applied on a large or commercial scale. On the other hand, the slow oxygen reduction process (ORR) in the cathodic compartment is a major roadblock in the commercialization of fuel cells for energy conversion. Thus, the scope of this review article addresses the main technical challenges of MFC operation and provides different practical approaches based on different attempts reported over the years.

Sustainable operation requires addressing key MFC-bottleneck issues. Enhancing extracellular electron transfer is the key to elevated MFC performance.