Performance Comparison of Three Common Proton Exchange Membranes for Sustainable Bioenergy Production in Microbial Fuel Cell

Enhancing Biodegradation of Pyridine with Trehalose Lipid in Rhodococcus pyridinivorans sp. Strain HR-1-Inoculated Microbial Fuel Cell

A Gram-positive exoelectrogen Rhodococcus pyridinivorans sp. strain HR-1 was cultivated from leachate-fed microbial fuel cell (MFC) to study the biodegradation effect of pyridine. In the comparison with mixed cultured MFC, HR-1 presented a remarkable electrical capacity with a maximum output of 4.33 W/m3 under 30 °C in neutral anolyte with 1 g/L acetate as a substrate. Further, HR-1 demonstrated the environmental resistance as a Gram-positive strain. Microbial metabolism was evident at pH between 5–9 and temperature in the range of 20–40 °C, whereas optimal condition for pyridine degradation was observed at 30 °C. This is the first study reporting the degradation of pyridine in the bio-electrochemical system that achieved a 42% ± 5% degradation rate in a full operation cycle at 2 g/L of the concentration. Considering the nonnegligible internal resistance of HR-1-inoculated MFC, trehalose lipid was also introduced as a bio-surfactant to reduce the charge transfer obstacle between the microbes and the electrodes. The surface morphology illustrated that the strain had a plump shape with a high specific area. Accordingly, bio-surfactant addition promoted the anode biomass (1.2 ± 0.1 mg/cm2 to 1.7 ± 0.2 mg/cm2) and achieved a higher degradation rate (68% ± 4%). The feasibility of electrochemical disposal on pyridine and eminent adaptability of strain sp. HR-1 as a Gram-positive exoelectrogen makes MFC a practical approach for real application.

Sodium nitrate as a methanogenesis suppressor in earthen separator microbial fuel cell treating rice mill wastewater

The microbial fuel cell (MFC) is one of the sustainable technologies, which alongside treating wastewater, can generate electricity. However, its performance is limited by factors like methanogenesis where methanogens compete with the anode respiring bacteria for substrate, reducing the power output. Thus, sodium nitrate, which has been previously reported to target the hydrogenotrophic methanogens, was used as a methanogenic suppressor in this study. The performance of MFC with and without sodium nitrate was studied during the treatment of rice mill wastewater. A significantly higher power density and coulombic efficiency (CE) were noted in the MFC with sodium nitrate (MFC_T) (271.26 mW/m³) as compared to the control MFC (MFC_C) (107.95 mW/m³). Polarization studies showed lower internal resistance for the MFC_T (330 Ω) as compared to MFC_C (390 Ω). Linear sweep voltammetry and cyclic voltammetry indicated a higher electron discharge on the anode surface due to enhancement of electrogenic activity. Considerable reduction (76.8%) in specific methanogenic activity was also observed in anaerobic sewage sludge mixed with sodium nitrate compared to the activity of anaerobic sewage sludge without any treatment. Due to the inhibition of methanogens, a lower chemical oxygen demand (COD) and phenol removal efficiency were observed in MFC_T as compared to MFC_C. The COD balance study showed an increase in substrate conversion to electricity despite the increase in nitrate concentration. Therefore, selective inhibition of methanogenesis had been achieved with the addition of sodium nitrate, thus enhancing the power generation by MFCs.

Effect of Anolyte pH on the Performance of a Dual-Chambered Microbial Fuel Cell Operated with Different Biomass Feed

Finding sustainable alternative energy resources and treating wastewater are the two most important issues that need to be solved. Microbial fuel cell (MFC) technology has demonstrated a tremendous potential in bioelectricity generation with wastewater treatment. Since wastewater can be used as a source of electrolyte for the MFC, the salient point of this study was to investigate the effect of pH on bioelectricity production using various biomass feed (wastewater and river water) as the anolyte in a dual-chambered MFC. Maximum extents of power density (1459.02 mW·m−2), current density (1288.9 mA·m−2), and voltage (1132 mV) were obtained at pH 8 by using Bhairab river water as a feedstock in the MFC. A substantial extent of chemical oxygen demand (COD) removal (94%) as well as coulombic efficiency (41.7%) was also achieved in the same chamber at pH 8. The overall performance of the MFC, in terms of bioelectricity generation, COD removal, and coulombic efficiency, indicates a plausible utilization of the MFC for wastewater treatment as well as bioelectricity production.

Carbon Nanotube/Pt Cathode Nanocomposite Electrode in Microbial Fuel Cells for Wastewater Treatment and Bioenergy Production

In this paper, we reported the fabrication, characterization, and application of carbon nanotube (CNT)-platinum nanocomposite as a novel generation of cathode catalyst in microbial fuel cells (MFCs) for sustainable energy production and wastewater treatment. The efficiency of the carbon nanocomposites was compared by platinum (Pt), which is the most effective and common cathode catalyst. This nanocomposite is utilized to benefit from the catalytic properties of CNTs and reduce the amount of required Pt, as it is an expensive catalyst. The CNT/Pt nanocomposites were synthesized via a chemical reduction technique and the electrodes were characterized by field emission scanning electron microscopy, electronic dispersive X-Ray analysis, and transmission electron microscopy. The nanocomposites were applied as cathode catalysts in the MFC to obtain polarization curve and coulombic efficiency (CE) results. The catalytic properties of electrodes were tested by linear sweep voltammetry. The CNT/Pt at the concentration of 0.3 mg/cm2 had the highest performance in terms of CE (47.16%), internal resistance (551 Ω), COD removal (88.9%), and power generation (143 mW/m2). In contrast, for the electrode with 0.5 mg/L of Pt catalyst, CE, internal resistance, COD removal, and power generation were 19%, 810 Ω, 96%, and 84.1 mW/m2, respectively. So, it has been found that carbon nanocomposite cathode electrodes had better performance for sustainable clean energy production and COD removal by MFC.