Predicting Tablet Strength from the Wet Granulation Conditions via the Unified Compaction Curve

Evaluation of binders in twin-screw wet granulation - Optimization of tabletability

The influence of hydroxypropyl cellulose type (HPC-SSL SFP, HPC-SSL), concentration (2 %, 3.5 %, 5 %) and filler (lactose, calcium hydrogen phosphate (DCP)/microcrystalline cellulose (MCC)) on twin-screw wet granulation and subsequent tableting was studied. The aim was to identify the formulation of the highest tabletability which still fulfills the requirements of the disintegration. Lactose combined with 5 % binder enabled a higher tabletability and a faster disintegration than DCP/MCC. It was found that tabletability of lactose formulations can be increased by higher binder concentration and higher compression pressure while tabletability of DCP/MCC formulations can be only increased by higher compression pressure. It was observed that batches containing DCP/MCC failed the disintegration test, if the highest binder concentration and the highest compression pressure were used. To ensure a fast disintegration, the compression pressure or at least the binder concentration had to be low. Changing the disintegrant and its localization improved the DCP/MCC formulation, resulting in faster disintegration than lactose tablets. However, it also resulted in a lower tabletability. In this study best tablets were achieved with 3.5 % or 5 % binder and lactose as filler. These tablets presented the highest tabletability but still disintegrated in less than 500 s.

Functionality evaluation of co-processed excipients as diluents in tablets manufactured by wet granulation

Diluents are essential components of a tablet formulation. The type of diluent used in a formulation influences the quality of tablets produced from that formulation. The aim of this study was to evaluate the tableting properties of co-processed excipients (C-PEs) incorporated as diluents in tablet formulation by wet granulation. Metronidazole tablets were prepared by wet granulation incorporating different diluents that were either single component excipients (SCEs) (lactose and microcrystalline cellulose) or C-PEs (Ludipress®, StarLac®, Prosolv® and AVICEL®HFE). The granules obtained for each formulation were evaluated for particle size analysis, flow properties and compression properties. Tablets weighing 500 mg were compressed from the metronidazole granules on a Single Station Tablet Press using a 12 mm punch and die tooling system. The tablets were kept for 24 h post-production, and the properties of weight uniformity, thickness, tensile strength, friability, disintegration time and dissolution profile evaluated subsequently. Results of granule properties showed that variations in parameters evaluated was as a result of differences in the type and composition of diluent used in formulation. Compactibility and tabletability profile of metronidazole granules revealed a better performance with granules processed with C-PE based diluents compared to SCE-based diluents. Tablets formulated with C-PEs as diluents were uniform in tablet weight, disintegrated faster and yielded a faster drug release compared to tablet formulations containing SCEs as diluent. This study reveals the performance advantage of C-PEs as diluents in tablets manufactured by wet granulation and highlights the importance of rational selection of excipients during tablet formulation.