Tunneling recombinations in scintillators, phosphors, and dosimeters

Persistent Charging of CsPbBr3 Perovskite Nanocrystals Confined in Glass Matrix

Manipulation of persistent charges in semiconductor nanostructure is the key point to obtain quantum bits towards the application of quantum memory and information devices. However, realizing persistent charge storage in semiconductor nano-systems is still very challenge due to the disturbance from crystal defects and environment conditions. Herein, the two-photon persistent charging induced long-lasting afterglow and charged exciton formation are observed in CsPbBr3 perovskite nanocrystals (NCs) confined in glass host with effective lifetime surpassing one second, where the glass inclosure provides effective protection. A method combining the femtosecond and second time-resolved transient absorption spectroscopy is explored to determine the persistent charging possibility of perovskite NCs unambiguously. Meanwhile, with temperature-dependent spectroscopy, the underlying mechanism of this persistent charging is elucidated. A two-channel carrier transfer model is proposed involving athermal quantum tunneling and slower thermal-assisted channel. On this basis, two different information storage devices are demonstrated with the memory time exceeding two hours under low-temperature condition. These results provide a new strategy to realize persistent charging in perovskite NCs and deepen the understanding of the underlying carrier kinetics, which may pave an alternative way towards novel information memory and optical data storage applications.

Scintillation Properties of CsPbBr3 Nanocrystals Prepared by Ligand-Assisted Reprecipitation and Dual Effect of Polyacrylate Encapsulation toward Scalable Ultrafast Radiation Detectors

Lead halide perovskite nanocrystals (LHP-NCs) embedded in polymeric hosts are gaining attention as scalable and low-cost scintillation detectors for technologically relevant applications. Despite rapid progress, little is currently known about the scintillation properties and stability of LHP-NCs prepared by the ligand assisted reprecipitation (LARP) method, which allows mass scalability at room temperature unmatched by any other type of nanostructure, and the implications of incorporating LHP-NCs into polyacrylate hosts are still largely debated. Here, we show that LARP-synthesized CsPbBr3 NCs are comparable to particles from hot-injection routes and unravel the dual effect of polyacrylate incorporation, where the partial degradation of LHP-NCs luminescence is counterbalanced by the passivation of electron-poor defects by the host acrylic groups. Experiments on NCs with tailored surface defects show that the balance between such antithetical effects of polymer embedding is determined by the surface defect density of the NCs and provide guidelines for further material optimization.

Optical and Scintillation Properties of Record-Efficiency CdTe Nanoplatelets toward Radiation Detection Applications

Colloidal CdTe nanoplatelets featuring a large absorption coefficient and ultrafast tunable luminescence coupled with heavy-metal-based composition present themselves as highly desirable candidates for radiation detection technologies. Historically, however, these nanoplatelets have suffered from poor emission efficiency, hindering progress in exploring their technological potential. Here, we report the synthesis of CdTe nanoplatelets possessing a record emission efficiency of 9%. This enables us to investigate their fundamental photophysics using ultrafast transient absorption, temperature-controlled photoluminescence, and radioluminescence measurements, elucidating the origins of exciton- and defect-related phenomena under both optical and ionizing excitation. For the first time in CdTe nanoplatelets, we report the cumulative effects of a giant oscillator strength transition and exciton fine structure. Simultaneously, thermally stimulated luminescence measurements reveal the presence of both shallow and deep trap states and allow us to disclose the trapping and detrapping dynamics and their influence on the scintillation properties.

On a local (de-)trapping model for highly doped Pr3+ radioluminescent and persistent luminescent nanoparticles

Trivalent praseodymium exhibits a wide range of luminescent phenomena when doped into a variety of different materials. Herein, radioluminescent NaLuF4:20%Pr3+ nanoparticles are studied. Four different samples of this composition were prepared ranging from 400-70 nm in size. Kinetic studies of radioluminescence as a function of X-ray irradiation time revealed a decrease in the emissions originating from the 1S0 level, due to the formation or optical activation of defects during excitation, and a simultaneous increase in the visible emissions resulting from the lower optical levels. Thermoluminescence measurements elucidated that a local de-trapping mechanism was responsible for the increase in steady state emission and persistent luminescence originating from the lower optical levels. The results and mechanism described through this study serve to provide a novel nanoparticle composition with versatile luminescent properties and provides experimental evidence in favor of a local trapping model.

Morphology Related Defectiveness in ZnO Luminescence: From Bulk to Nano-Size

This study addresses the relationship between material morphology (size, growth parameters and interfaces) and optical emissions in ZnO through an experimental approach, including the effect of different material dimensions from bulk to nano-size, and different excitations, from optical sources to ionizing radiation. Silica supported ZnO nanoparticles and ligand capped ZnO nanoparticles are synthesized through a sol–gel process and hot injection method, respectively. Their optical properties are investigated by radioluminescence, steady-state and time-resolved photoluminescence, and compared to those of commercial micrometric powders and of a bulk single crystal. The Gaussian spectral reconstruction of all emission spectra highlights the occurrence of the same emission bands for all samples, comprising one ultraviolet excitonic peak and four visible defect-related components, whose relative intensities and time dynamics vary with the material parameters and the measurement conditions. The results demonstrate that a wide range of color outputs can be obtained by tuning synthesis conditions and size of pure ZnO nanoparticles, with favorable consequences for the engineering of optical devices based on this material.