Nitrogen doped carbon quantum dots (N-CQDs) with high luminescence for sensitive and selective detection of hypochlorite ions by fluorescence quenching

Highly-fluorescent extracts from Pterocarpus wood for Fe3+ ion detection

At present, excessive Fe3+ in daily water has become a threat to human health. Among the conventional detection methods for Fe3+, fluorescent probes have been applied on a large scale due to their simplicity and efficiency. However, the currently available fluorescent probes are difficult to synthesize, costly and environmentally unfriendly, limiting their applications. In this work, a fluorescent extract of Pterocarpus wood was successfully obtained, and the structure of some coumarin-based molecules in this extract was determined by 2D-NMR. Subsequently, the intensity of this fluorescence was optimized using response surface methodology (RSM), resulting in a high-intensity fluorescent probe. The probe was sensitive to the concentrations of Fe3+ and MnO4-, and could efficiently detects Fe3+ in the range of 2.7 μM-8.0 μM, with LOD and LOQ reaching 1.06 μM and 3.20 μM, respectively. Moreover, based on the strong complexation property of EDTA on Fe3+, this work designed the "switch-on" fluorescent probes. The experiment shows that both static and dynamic quenching exist in this system. The mechanism of complexation and oxidation of fluorescent molecules by the quencher is interpreted in the quenching reaction. In addition, the fluorescent probe has a high yield and low cost, it also performs well in actual water sample tests. This method is expected to be developed as a new way on Fe3+ detection.

Yellow-emitting carbon dots as fluorescent sensors for the rapid determination of curcumin

The non-standard use of curcumin could cause some adverse drug reactions, such as diarrhea, nausea and skin allergies. Thus, the curcumin determination was fundamental to disease treatment and prevention. Herein, a facile and efficient fluorescent probe was developed based on carbon dots, which was prepared through hydrothermal method (o-phenylenediamine and N-isopropylacrylamide as the reaction raw materials). Characteristics of the as-fabricated carbon dots (NCDs) were studied through some analysis techniques, such as UV-vis absorption spectroscopy, transmission electron microscopy, Fourier transform infrared instrument, X-ray photoelectron spectroscopy and fluorescence spectrophotometer. Fluorescence quenching phenomenon could be observed after addition of curcumin. This as-prepared fluorescent probe displayed a significant response for the determination of curcumin with a satisfactorily lower detection limit of 0.017 μM and a considerable linear range of 0.5-50 μM compared to reported literatures. Because of the preeminent repeatability and anti-jamming capability, the as-developed CDs suggested mighty potentiality for actual applications of curcumin detection in real samples and temperature sensing.

Carbon Quantum Dots with High Photothermal Conversion Efficiency and Their Application in Photothermal Modulated Reversible Deformation of Poly(N-isopropylacrylamide) Hydrogel

The fluorescence of carbon quantum dots (CQDs) has been paid a lot of attention, but its photothermal performance attracts less attention since preparing CQDs with high photothermal conversion efficiency (PCE) is a big challenge. In this work, CQDs with an average size of 2.3 nm and a PCE of up to 59.4% under 650 nm laser irradiation were synthesized by a simple one-pot microwave-assisted solvothermal method using citric acid (CA) and urea (UR) as the precursors and N,N-dimethylformamide as the solvent under an optimized condition (CA/UR = 1/7, 150 °C, and 1 h). The as-prepared CQDs were demonstrated to have unique surface chemical states; i.e., abundant pyrrole, amide, carboxyl, and hydroxyl groups were found on the surfaces of CQDs, which ensure a high PCE. These CQDs were introduced into a thermoresponsive poly(N-isopropylacrylamide) (PNIPAM) to form a CQDs@PNIPAM nanocomposite, and then, a bilayer hydrogel composed of CQDs@PNIPAM and polyacrylamide (PAM) was fabricated. The bilayer hydrogel can be reversibly deformed just by a light switching on/off operation. Based on the excellent photothermal performance, the developed CQDs are expected to be used in photothermal therapy, photoacoustic imaging, and other biomedical fields, and the CQDs@PNIPAM hydrogel nanocomposite is promising to be applied in intelligent device systems as a light-driven smart flexible material.

Solvothermal synthesis of bifunctional carbon dots for tartrazine and Fe(III) detection from chamomile residue by ternary DES pretreatment

A ternary deep eutectic solvent (DES) consisting of choline chloride, lactic acid, and urea in a molar ratio of 1:2:2 was used to pretreat chamomile residue, followed by carbon dots (CDs) preparation using a one-pot solvothermal method. The CDs prepared under the suitable conditions had a high quantum yield of 47.34% and could be used as a bifunctional fluorescent probe for the detection of tartrazine and Fe(III). The concentration of tartrazine or Fe(III) had a good linear relationship with the fluorescence intensity of CDs that the determination coefficient (R²) was 0.9957 and 0.9943, and the limit of detection (LOD) was 40 nM and 119 nM, respectively. After verifying the different fluorescence quenching mechanisms of CDs by these two substances, a quantitative analysis was performed on real samples with recoveries of 90.70%∼104.29%. Overall, this study provided a promising technology for chemical conversion from low-cost chamomile residue to attractive bifunctional fluorescent probe.

Carbon dots electrochemically prepared from dopamine and epigallocatechin gallate for hypochlorite detection with high selectivity via a dynamic quenching mechanism

Monitoring hypochlorite levels in water is of great importance because of its high toxicity and wide applications as water disinfectants. In this manuscript, carbon dot (CD) was electrochemically prepared by using dopamine and epigallocatechin gallate (molar ratio 1:1) as the carbon source for efficient hypochlorite determination. By electrolyzing the solution at 10 V for 12 min with PBS as an electrolyte, dopamine would react with epigallocatechin at the anode, and through polymerization, dehydration, and carbonization, strong blue-fluorescent CDs were obtained. CDs were characterized by UV-Vis spectroscopy, fluorescence spectroscopy, high-resolution transmission electron microscopy, FT-IR, etc. These CDs have an excitation wavelength at 372 nm and an emission wavelength at 462 nm, owing an average particle size of 5.5 nm. The presence of hypochlorites can quench the fluorescence of CDs, and its reduction in intensity is linear with hypochlorite concentration over the range of 0.5-50 μM, ΔF/F₀ = 0.0056 + 0.0194C_ClO^-, R²=0.997. The detection limit achieved 0.23 μM (S/N = 3). The mechanism for fluorescence quenching is via a dynamic process. Different from many other fluorescence methods based on the strong oxidizing ability of hypochlorites, our method shows strong selectivity toward hypochlorites over other oxidizing agents such as H₂O₂. The assay was validated by the detection of hypochlorites in water samples, with recoveries between 98.2% and 104.3%.

Solvothermal preparation of nitrogen-doped carbon dots with PET waste as precursor and their application in LEDs and water detection

Developing novel, alternative ways to recycle PET waste, which has an important influence on reduction of landfilling and CO₂ emissions, has always been a research hot spot for industry and academy. In this work, PET waste was adopted as precursor for the preparation of nitrogen-doped Carbon Dots (NCDs). Firstly, PET oligomers were obtained by alcoholysis of PET waste with ethylene glycol. Then, the mixture without isolation and purification as well as pyromellitic acid dianhydride and urea were adopted as precursors for the preparation of NCDs by solvothermal method with tetrahydrofuran (THF) as solvent. The as-prepared NCDs has a spherical structure with an average particle size of 2.3 nm. What is more, NCDs exhibit excitation-independent emission properties, the largest excitation peak and emission peak of NCDs located in 360 nm and 470 nm, and the fluorescence quantum yield is 48.16 %. In term of application, NCDs are dispersed in PMMA and loaded on 365 nm and 430 nm LED chips to obtain LED devices emitting yellow light ((0.55, 0.44), 2018 K) and warm white light ((0.37, 0.31), 3783 K), respectively. In addition, NCDs could be adopted as fluorescent probe for the construction of sensor for water in organic solvents based on dynamic quenching of NCDs, and the limit of detection (LOD) is 0.00001 %.

Novel highly selective fluorescence sensing strategy for Mercury(Ⅱ) in water based on nitrogen-doped carbon quantum dots

In this work, a fluorescent signal-closing probe of nitrogen-doped carbon quantum dots (NCQDs) was developed for quantitative detection of mercury ions (Hg²⁺). In this detection system, the NCQDs with high quantum yield (QY, 63.80 %) were synthesized via simple hydrothermal method with Methyl Glycine Diacetic acid Trisodium Salt (MGDA) and m-phenylenediamine (MPD) as carbon and nitrogen sources. The NCQDs have a typical surface structure and exceptional fluorescence stability, and their fluorescence zones are centered on excitation wavelengths of 440 nm and emission wavelengths of 510 nm. Under optimal conditions, the NCQDs have outstanding anti-interference ability to various ions and high selectivity to mercury ions. The fluorescence intensity of the detection system is weakened due to the generation of non-fluorescent groups caused by the static quenching effect. The fluorescence quenching efficiency shows a fascinating linear relationship with Hg²⁺ ions at 0-100 μM (y = 0.0051x-0.015, R² = 0.9943), and the detection limit is 0.9 μM. Acute toxicity test shows that NCQDs have low toxicity and little harm to environment. The detection system can be used for the quantification of mercury ions in environmental water samples, and the recovery rate is between 99.64 % and 103.43 %, indicating that it is a simple and economical fluorescence detection method.

Dual-emission fluorescence detection of histidine using carbon dots and calcein/Ni2+ complexes

Histidine (His) is a natural amino acid that plays very important roles in biota. However, the low concentrations of His in biological fluids and the similar structures and properties of other amino acids mean it is difficult to selectively determine His concentrations in biological fluids with a high degree of sensitivity. A novel ratiometric fluorescence probe for detecting His in aqueous solutions is described here. The method involves carbon dots (CDs) and calcein/Ni²⁺ complexes. At an excitation wavelength of 480 nm, the CD/calcein system emits green fluorescence (maximum emission from calcein at 512 nm) and red fluorescence (maximum emission from CDs at 617 nm). The presence of Ni²⁺ decreases the calcein fluorescence intensity because of static quenching caused by the formation of calcein/Ni²⁺ complexes but the CD fluorescence intensity remains almost unchanged. Fluorescence of calcein/Ni²⁺ complexes provides the response, and the presence of His binds to Ni²⁺ via cooperative chelation and produces free calcein causing fluorescence to be recovered. CDs provide a self-calibration fluorescence signal, the intensity of which remains almost unchanged in the presence of His. The ratio of the fluorescence intensities at 512 and 617 nm (I₅₁₂/I₆₁₇) was strongly related to the His concentration in the range 0.5-22 μM, and the detection limit was 0.16 μM. The specificity of Ni²⁺/His interactions allows His to be determined without interference from other species. The method was successfully used to determine His in diluted human urine. The recovery was acceptable, suggesting that the biosensor can be used to determine His in real samples.

N-doped carbon dots as robust fluorescent probes for the rapid detection of hypochlorite

N-doped carbon dots (NCDs) with high quantum yield (67%), which could act as robust fluorescent probes for the detection of free chlorine in local tap water with rapid response and accurate measurement, were efficiently prepared.