Statistical optimization of parameters affecting lipid productivity of microalga Chlorella protothecoides cultivated in photobioreactor under nitrogen starvation

Norfloxacin removal by ultraviolet-activated sodium percarbonate and sodium hypochlorite: process optimization and anion effect

The efficiency of UV-activated sodium percarbonate (SPC) and sodium hypochlorite (SHC) in Norfloxacin (Norf) removal from an aqueous solution was assessed. Control experiments were conducted and the synergistic effect of the UV-SHC and UV-SPC processes were 0.61 and 2.89, respectively. According to the first-order reaction rate constants, the process rates were ranked as UV-SPC > SPC > UV and UV-SHC > SHC > UV. Central composite design was applied to determine the optimum operating conditions for maximum Norf removal. Under optimum conditions (UV-SPC: 1 mg/L initial Norf, 4 mM SPC, pH 3, 50 min; UV-SHC: 1 mg/L initial Norf, 1 mM SHC, pH 7, 8 min), the removal yields for the UV-SPC and UV-SHC were 71.8 and 72.1%, respectively. HCO₃^-, Cl^-, NO₃^-, and SO₄^2- negatively affected both processes. UV-SPC and UV-SHC processes were effective for Norf removal from aqueous solution. Similar removal efficiencies were obtained with both processes; however, this removal efficiency was achieved in a much shorter time and more economically with the UV-SHC process.

Biomass and lipid production by the native green microalgae Chlorella sorokiniana in response to nutrients, light intensity, and carbon dioxide: experimental and modeling approach

Introduction: Microalgae are photosynthetic cells that can produce third-generation biofuels and other commercial compounds. Microalgal growth is influenced by two main parameters: light intensity and carbon dioxide concentration, which represent the energy and carbon source, respectively. For photosynthesis, the optimum values of abiotic factors vary among species. Methods: In this study, the microalga Chlorella sorokiniana was isolated from a freshwater lake. It was identified using molecular analysis of the ribosomal internal transcribed spacer. A single-factor design of experiments in 250-mL Erlenmeyer flasks was used to evaluate which concentrations of nitrogen and phosphorus increase the production of biomass and lipids. The response surface methodology was used with a 3²-factorial design (light intensity and CO₂ were used to evaluate its effect on biomass, lipid production, and specific growth rates, in 200-mL tubular photobioreactors (PBRs)). Results and Discussion: Low levels of light lead to lipid accumulation, while higher levels of light lead to the synthesis of cell biomass. The highest biomass and lipid production were 0.705 ± 0.04 g/L and 55.1% ± 4.1%, respectively. A mathematical model was proposed in order to describe the main phenomena occurring in the culture, such as oxygen and CO₂ mass transfer and the effect of light and nutrients on the growth of microalgae. The main novelties of this work were molecular identification of the strain, optimization of culture conditions for the indigenous microalgae species that were isolated, and formulation of a model that describes the behavior of the culture.

Electrochemical Degradation of Methylene Blue by a Flexible Graphite Electrode: Techno-Economic Evaluation

In this study, electrochemical removal of methylene blue (MB) from water using commercially available and low-cost flexible graphite was investigated. The operating conditions such as initial dye concentration, initial solution pH, electrolyte dose, electrical potential, and operating time were investigated. The Box-Behnken experimental design (BBD) was used to optimize the system's performance with the minimum number of tests possible, as well as to examine the independent variables' impact on the removal efficiency, energy consumption, operating cost, and effluent MB concentration. The electrical potential and electrolyte dosage both improved the MB removal efficiency, since increased electrical potential facilitated production of oxidizing agents and increase in electrolyte dosage translated into an increase in electrical current transfer. As expected, MB removal efficiency increased with longer operational periods. The combined effects of operating time-electrical potential and electrical potential-electrolyte concentration improved the MB removal efficiency. The maximum removal efficiency (99.9%) and lowest operating cost (0.012 $/m³) were obtained for initial pH 4, initial MB concentration 26.5 mg/L, electrolyte concentration 0.6 g/L, electrical potential 3 V, and operating time 30 min. The reaction kinetics was maximum for pH 5, and as the pH increased the reaction rates decreased. Consequent techno-economic assessment showed that electrochemical removal of MB using low-cost and versatile flexible graphite had a competitive advantage.

Enhanced Lipid Production of Chlorella sp. HS2 Using Serial Optimization and Heat Shock

Chlorella sp. HS2, which previously showed excellent performance in phototrophic cultivation and has tolerance for wide ranges of salinity, pH, and temperature, was cultivated heterotrophically. However, this conventional medium has been newly optimized based on a composition analysis using elemental analysis and ICP-OES. In addition, in order to maintain a favorable dissolved oxygen level, stepwise elevation of revolutions per minute was adopted. These optimizations led to 40 and 13% increases in the biomass and lipid productivity, respectively (7.0 and 2.25 g l^-1d^-1 each). To increase the lipid content even further, 12 h heat shock at 50°C was applied and this enhanced the biomass and lipid productivity up to 4 and 17% respectively (7.3 and 2.64 g l^-1d^-1, each) relative to the optimized conditions above, and the values were 17 and 14% higher than ordinary lipid-accumulating N-limitation (6.2 and 2.31 g l^-1d^-1). On this basis, heat shock was successfully adopted in novel Chlorella sp. HS2 cultivation as a lipid inducer for the first time. Considering its fast and cost-effective characteristics, heat shock will enhance the overall microalgal biofuel production process.

Optimization of bio-cement production from cement kiln dust using microalgae

•

CKD with microalgae sp. Chlorella kessleri is investigated for maximum bio-cement yields.

•

A predictive quadratic model was developed for CaCO₃ yield with R² value of c.a. 92%.

•

Low temperature and high pH were found to be important parameters in RSM study.

•

Under optimal set, a maximum of 96% Ca was extracted experimentally from CKD.

•

FTIR, XRD and EDS analysis confirmed the produced bio-cement compound.

The main aim of this study was to maximize bio-cement (CaCO₃) production through a waste feedstock of cement kiln dust (CKD) as a source of calcium by deployment of microalgae sp. Chlorella kessleri. The effect of process parameters such as temperature, pH and time-intervals of microalgae cultivation, were set as criteria that ultimately subscribe to a process of optimization. In this regard, a single factor experiments integrated with response surface methodology (RSM) via central composite design (CCD) was considered. A quadratic model was developed to predict the maximum CaCO₃ yield. A ceiling of 25.18 g CaCO₃ yield was obtained at an optimal set of 23 °C, pH of 10.63 and day-9 of microalgae culture. Under these optimized conditions, maximum 96% calcium was extracted from CKD. FTIR, XRD and EDS analyses were conducted to characterize the CaCO₃ precipitates. Compressive modes of mechanical testing seemed to hold conventional cement complimented by CaCO₃ co-presence markedly superior to mere cement performance as far as compressive strength is concerned. The latter criterion exhibited further increase in correspondence with rise in cement to bio-cement ratio. This investigative endeavour at hand offers a simple pivotal platform on the basis of which a scale-up of microalgae-infested bio-cement production might be facilitated in conjunction with the added benefit of alleviation in environmental pollution through cement waste utilization.

Past, current, and future research on microalga-derived biodiesel: a critical review and bibliometric analysis

Microalga-derived biodiesel plays a crucial role in the sustainable development of biodiesel in recent years. Literature related to microalga-derived biodiesel had an increasing trend with the expanding research outputs. Based on the Science Citation Index Expanded (SCI-Expanded) of the Web of Science, a bibliometric analysis was conducted to characterize the body of knowledge on microalga-derived biodiesel between 1993 and 2016. From the 30 most frequently used author keywords, the following research hotspots are extracted: lipid preparation from different microalga species, microalga-derived lipid and environmental applications, lipid-producing microalgae cultivation, microalgae growth reactor, and microalga harvest and lipid extraction. Other keywords, i.e., microalga mixotrophic cultivation, symbiotic system between microalga and other oleaginous yeast, microalga genetic engineering, and other applications of lipid-producing microalga are future focal points of research. Graphical abstract.