Detection of Legionella-contaminated aerosols in the vicinity of a bio-trickling filter of a breeding sow facility - A pilot study

Size-selective sampler combined with an immunochromatographic assay for the rapid detection of airborne Legionella pneumophila

Airborne biological aerosols (also called bioaerosols) are found in various environmental and occupational settings. Among these, pathogenic bioaerosols can cause diseases such as legionellosis, influenza, measles, and tuberculosis. To prevent or minimize people's exposure to these pathogenic bioaerosols in the field, a rapid detection method is required. In this study, a size-selective bioaerosol (SSB) sampler was combined with the immunochromatographic assay (ICA). The SSB sampler can collect bioaerosols on the sampling swab and the lateral flow test kit used in ICA can rapidly detect the pathogens in bioaerosols collected on the swab. Before testing the combined method, the lower limit of detection (LOD) of the lateral flow test kit was determined. Legionella pneumophila (L. pneumophila) was used as a target pathogen. The results show that at least 1.3 × 103L. pneumophila cells are required to be detected by the lateral flow test kit. To test the developed method, L. pneumophila suspension was aerosolized in the sampling chamber and collected using two SSB samplers with different sampling times (10 and 20 min). The developed method could detect aerosolized L. pneumophila and also estimate the concentrations from the lower LOD, sampling time, and formation of a positive line on a test strip. When positive results were obtained from sampling for 10 min and 20 min, concentrations of respirable L. pneumophila were estimated ≥5.2 × 104 CFUresp/m3 and ≥2.6 × 104 CFUresp/m3, respectively. The conventional sampler Andersen impactor with colony counting was also used for comparison. In all cases, the estimated concentrations obtained by the developed method were higher than those obtained by the conventional method. These findings confirm that the developed method can overcome the limitations of conventional methods and eventually benefit environmental and occupational health by providing a better method for risk assessment.

Immunomagnetic separation coupled with flow cytometry for the analysis of Legionella pneumophila in aerosols

Legionella pneumophila are pathogenic bacteria that can be found in high concentrations in artificial water systems like evaporative cooling towers, which have been the source of frequent outbreaks in recent years. Since inhaled L. pneumophila can lead to Legionnaires' disease, the development of suitable sampling and rapid analysis strategies for these bacteria in aerosols is therefore of great relevance. In this work, different concentrations of viable L. pneumophila Sg 1 were nebulized and sampled by the cyclone sampler Coriolis® µ under defined conditions in a bioaerosol chamber. To quantify intact Legionella cells, the collected bioaerosols were subsequently analyzed by immunomagnetic separation coupled with flow cytometry (IMS-FCM) on the platform rqmicro.COUNT. For analytical comparison, measurements with qPCR and cultivation were performed. Limits of detection (LOD) of 2.9 × 10³ intact cells m^-3 for IMS-FCM and 7.8 × 10² intact cells m^-3 for qPCR indicating a comparable sensitivity as in culture (LOD = 1.5 × 10³ culturable cells m^-3). Over a working range of 10³ - 10⁶ cells mL^-1, the analysis of nebulized and collected aerosol samples with IMS-FCM and qPCR provides higher recovery rates and more consistent results than by cultivation. Overall, IMS-FCM is a suitable culture-independent method for quantification of L. pneumophila in bioaerosols and is promising for field application due to its simplicity in sample preparation.

Zeolite powder based polyurethane sponges as biocarriers in moving bed biofilm reactor for improving nitrogen removal of municipal wastewater

This study aims to enhance nitrogen removal efficiency of a moving bed biofilm reactor (MBBR) by developing a new MBBR with zeolite powder-based polyurethane sponges as biocarriers (Z-MBBR). Results indicated the total nitrogen (TN) removal efficiency and simultaneous nitrification and denitrification (SND) performance in Z-MBBR were nearly 10% higher than those in the conventional MBBR with sponges as biocarriers (S-MBBR). About 84.2 ± 4.8% of TN was removed in Z-MBBR compared to 75.1 ± 6.8% in S-MBBR. Correspondingly, the SND performance in Z-MBBR and S-MBBR was 90.7 ± 4.1% and 81.7 ± 6.5%, respectively. The amount of biofilm attached to new biocarriers (0.470 ± 0.131 g/g carrier) was 1.3 times more than that of sponge carriers (0.355 ± 0.099 g/g carrier). Based on the microelectrode measurements and microbial community analysis, more denitrifying bacteria existed in the Z-MBBR system, and this can improve the SND performance. Consequently, this new Z-MBBR can be a promising option for a hybrid treatment system to better nitrogen removal from wastewater.

Feasibility of using basalt fiber as biofilm Carrier to construct bio-nest for wastewater treatment

Generally, biofilms developed for wastewater treatment readily detach from carrier medium once available thickness exceeds about 2 mm. Carrier media made of basalt fibers (BFs) could form ball-like aggregates (more than 10 cm in size, and called bio-nest). To demonstrate its feasibility for wastewater treatment, both reactors with and without BF carriers (RBF and RCO) were evaluated in terms of nutrient removal, oxygen mass transport and biological viabilities as well as biofilm adsorption characteristics. Therefore, oxygen microprofiles and confocal images for bio-nest as well as functional groups for biofilm-attached BF were performed on microsensor systems, confocal laser scanning microscopy (CLSM) and Fourier transform infrared (FTIR). Despite COD:N ratio, both reactors removed about 90% of COD, while only RBF reactor achieved high denitrification capabilities, with nitrogen removal efficiencies varying between 60.10 ± 0.45% and 82.07 ± 0.64%. Microprofile and confocal images showed that dissolved oxygen could reach the core with depth up to 50 mm, at which viable bacteria were detected. Characteristic peaks on FT-IR spectrum demonstrated that various functional groups of polysaccharide and proteins in EPS played a key role in aggregating biofilm-attached BFs into a bio-nest. Thus, BF provides a promising alternative to conventional carrier medium for wastewater treatment.

Health risks from exposure to Legionella in reclaimed water aerosols: Toilet flushing, spray irrigation, and cooling towers

The use of reclaimed water brings new challenges for the water industry in terms of maintaining water quality while increasing sustainability. Increased attention has been devoted to opportunistic pathogens, especially Legionella pneumophila, due to its growing importance as a portion of the waterborne disease burden in the United States. Infection occurs when a person inhales a mist containing Legionella bacteria. The top three uses for reclaimed water (cooling towers, spray irrigation, and toilet flushing) that generate aerosols were evaluated for Legionella health risks in reclaimed water using quantitative microbial risk assessment (QMRA). Risks are compared using data from nineteen United States reclaimed water utilities measured with culture-based methods, quantitative PCR (qPCR), and ethidium-monoazide-qPCR. Median toilet flushing annual infection risks exceeded 10^-4 considering multiple toilet types, while median clinical severity infection risks did not exceed this value. Sprinkler and cooling tower risks varied depending on meteorological conditions and operational characteristics such as drift eliminator performance. However, the greatest differences between risk scenarios were due to 1) the dose response model used (infection or clinical severity infection) 2) population at risk considered (residential or occupational) and 3) differences in laboratory analytical method. Theoretical setback distances necessary to achieve a median annual infection risk level of 10^-4 are proposed for spray irrigation and cooling towers. In both cooling tower and sprinkler cases, Legionella infection risks were non-trivial at potentially large setback distances, and indicate other simultaneous management practices could be needed to manage risks. The sensitivity analysis indicated that the most influential factors for variability in risks were the concentration of Legionella and aerosol partitioning and/or efficiency across all models, highlighting the importance of strategies to manage Legionella occurrence in reclaimed water.

The Use of Bioaerosol Sampling for Airborne Virus Surveillance in Swine Production Facilities: A Mini Review

Modern swine production facilities typically house dense populations of pigs and may harbor a variety of potentially zoonotic viruses that can pass from one pig generation to another and periodically infect human caretakers. Bioaerosol sampling is a common technique that has been used to conduct microbial risk assessments in swine production, and other similar settings, for a number of years. However, much of this work seems to have been focused on the detection of non-viral microbial agents (i.e., bacteria, fungi, endotoxins, etc.), and efforts to detect viral aerosols in pig farms seem sparse. Data generated by such studies would be particularly useful for assessments of virus transmission and ecology. Here, we summarize the results of a literature review conducted to identify published articles related to bioaerosol generation and detection within swine production facilities, with a focus on airborne viruses. We identified 73 scientific reports, published between 1991 and 2017, which were included in this review. Of these, 19 (26.7%) used sampling methodology for the detection of viruses. Our findings show that bioaerosol sampling methodologies in swine production settings have predominately focused on the detection of bacteria and fungi, with no apparent standardization between different approaches. Information, specifically regarding virus aerosol burden in swine production settings, appears to be limited. However, the number of viral aerosol studies has markedly increased in the past 5 years. With the advent of new sampling technologies and improved diagnostics, viral bioaerosol sampling could be a promising way to conduct non-invasive viral surveillance among swine farms.