Ubiquity of microbial capacity to degrade metaldehyde in dissimilar agricultural, allotment and garden soils

Probe-based qPCR assay enables the rapid and specific detection of bacterial degrading genes for the pesticide metaldehyde in soil

Metaldehyde, a molluscicide pesticide, has been identified as a pollutant of concern due to its repeated detection in drinking water, thereby generating numerous compliance failures for water utilities. Biological degradation potential for metaldehyde is widespread in soils, occurring at different rates, but to date, no molecular methods for its assessment have been reported. Here, three genes belonging to a shared metaldehyde-degrading gene cluster present in bacteria were used as candidates for development of a quantitative PCR (qPCR) assay for assessing the metaldehyde-degrading potential in soil. Screening of gene targets, primer pairs and optimization of reaction conditions led to the development of a sensitive and specific probe-based qPCR method for quantifying the mahY metaldehyde-degrading gene from soil. The technique was tested across 8 soils with different compositions and origins. The degrading pathway was detected in 4/8 soils, in which a higher number of gene copies correlated with periods of greater metaldehyde removal. Additionally, swift elimination of the pesticide was observed in soils with an elevated initial number of mahY gene copies. The gene cluster was not detected in other soils, even though metaldehyde removal occurred, indicating that other biological degrading pathways are also important in nature. The method described here is the first one available to estimate the microbial metaldehyde degradation potential and activity in soils, and can also be used to detect degrading microorganisms in systems such as sand filters for water purification or to monitor degrading strains in engineered processes.

Trends in metaldehyde concentrations and fluxes in a lowland, semi-agricultural catchment in the UK (2008-2018)

Metaldehyde, a widely used molluscicide, is one of the most commonly detected pesticides in aquatic environments in the UK. In this study, metaldehyde concentrations and fluxes in stream water over a ten-year period (2008-2018) are reported for the River Colne catchment (Essex, southeast England), and the influence of hydrological conditions and application regimes are assessed. In general, peaks in metaldehyde concentration in river water occasionally exceeded 0.25 μg L^-1, and concentrations did not typically exceed the European Union Drinking Water Directive (EU DWD) regulatory limit of 0.1 μg L^-1. Metaldehyde concentration peaks displayed a seasonal pattern. Metaldehyde concentrations during periods when the molluscicide was not applied to agricultural land (January, July) and during the spring-summer application period (February to June) were generally low (0.01-0.03 μg L^-1). Peaks in metaldehyde concentration mainly occurred during the autumn-winter application season (August to December), and were typically associated with high intensity hydrological regimes (daily rainfall ≥10 mm; stream flow up to 18 m³ s^-1). Where metaldehyde concentrations exceeded the EU DWD regulatory limit, this was short-lived. The annual flux at the top of the Colne catchment (0.2-0.6 kg a^-1) tended to be lower than in the middle of the catchment (0.3-1.4 kg a^-1), with maximum flux values observed at the bottom of the catchment (0.5-25.8 kg a^-1). Metaldehyde losses from point of application to surface water varied between 0.01 and 0.25%, with a maximum of 1.18% (2012). Annual flux was primarily controlled by the annual precipitation and stream flow (R² = 0.9) rather than annual metaldehyde use (kg active applied). Precipitation explained 37% and 81% of variability in metaldehyde concentration and flux, respectively. Annual ranges in metaldehyde concentration were greater in the years 2012 and 2014 with an overall reduction in the range of metaldehyde concentrations evident over the period 2015-2018. It is the expectation that metaldehyde concentrations in stream water will continue to decrease following the withdrawal of metaldehyde for outdoor use in the UK from March 2022.

ATR-FTIR and LC-Q-ToF-MS analysis of indoor dust from different micro-environments located in a tropical metropolitan area

Indoor dust is an important matrix that exposes humans to a broad spectrum of chemicals. The information on the occurrence of contaminants of emerging concern (CECs), their metabolites, and re-emerging contaminants in indoor dust is rather limited. As the indoor environment is exposed to various chemicals from personal care products, furniture, building materials, machineries and cooking/cleaning products, there is a high chance of the presence of hazardous contaminants in indoor dust. In the present study, dust samples were collected from four different micro indoor environments (photocopying centres, residential houses, classrooms, and ATM cabins) located in an urban environment located in India's southwestern part. The collected samples were subjected to ATR - FTIR and LC-Q-ToF-MS analyses. The ATR - FTIR analysis indicated the presence of aldehydes, anhydrides, carboxylic acids, esters, sulphonic acids, and asbestos - a re-emerging contaminant. A total of 19 compounds were identified from the LC-Q-ToF-MS analysis. These compounds belonged to various classes such as plasticisers, plasticiser metabolites, photoinitiators, personal care products, pharmaceutical intermediates, surfactants, and pesticides. To the best of our knowledge, this is the first report regarding the presence of CECs in indoor environments in Kerala and also the suspected occurrence of pesticides (metaldehyde and ethofumesate) in classroom dust in India. Another important highlight of this work is the demonstration of ATR-FTIR as a complementary technique for LC-Q-ToF-MS in the analysis of indoor pollution while dealing with totally unknown pollutants. These results further highlight the occurrence of probable chemically modified metabolites in the tropical climatic conditions in a microenvironment.