Microwave synthesized strontium hexaferrite 2D sheets as versatile and efficient microwave catalysts for degradation of organic dyes and antibiotics

N-doped lignin-based activated carbon aerogel derived from bamboo black pulp liquor for efficient removal of malachite green in wastewater

In this study, a lignin-based aerogel (LA) was prepared through acid precipitation of BPBL, followed by sol-gel method and freeze-drying. Additionally, a one-step activation-carbonization method was used to acquire nitrogen-doped lignin-based activated carbon aerogel (NLACA). The adsorption and catalytic degradation performance for malachite green (MG) were examined. The specific surface area of NLACA after N-doping was 2644.5 m2/g. The adsorption capacity for MG was increased to 3433 mg/g with the presence of nitrogenous functional groups on surface of NLACA compared without N-doping. Meanwhile, non-radical singlet oxygen is the primary active substance and degradation efficiency arrives at 91.8% after the catalytic degradation within 20 min and it has good stability and reuse. Three possible degradation pathways during degradation were analyzed by LC-MS technique. The adsorption isotherm and kinetic data demonstrated conformity with both the Langmuir model and the pseudo-second-order kinetic model. The primary mechanisms of the adsorption for MG dyes on NLACA include hydrogen bonding, π-π interactions, attraction of electrostatic and pore filling. Hence, NLACA derived from BPBL acts as a cost-effective and high-performance adsorbent and catalyst for removal of MG in dye wastewater. This concept introduces an innovative approach of "treatment of waste with waste" for developing a low-consumption, high-efficiency dye wastewater treatment and provides significant reference to treatment dye wastewater.

Investigation of structural, morphological and magnetic properties of nanostructured strontium hexaferrite through co-precipitation technique: Impacts of annealing temperature and Fe/Sr ratio

M-type strontium hexaferrite (SrM) were successfully synthesized from Sr²⁺ and Fe³⁺ precursor salt through co-precipitation technique. Different higher sintering temperatures (800-1000 °C) were used to get the desired SrM with variation of Fe³⁺/Sr²⁺ mole ratio as well. The characterization of SrM and its properties were investigated using modern instrumental techniques viz. X-ray diffraction (XRD), Fourier Transform Infrared Spectrometer, Scanning Electron Microscopy, Vibrating Sample Magnetometer, UV-Visible NIR Spectrometer, Impedance Analyzer and Thermal Conductivity Meter. The phase of the synthesized SrM were confirmed by comparing the XRD patterns with the standard ICDD data and Reitvelt Refinement for the SrM having Fe³⁺/Sr²⁺ ratio 10 and SrM with distinct annealing temperature were performed. The structural parameters, particle size (75 nm-318 nm) and shape of the as prepared samples were changed with calcination temperature as well as mole ratio. The saturation magnetization (73.77-24.27 emu/g), coercivity (3732.28-642.10 Oe) and remanant magnetization (39.15-8.86 emu/g) were varied with calcination temperature and composition. The dielectric properties, optical properties and thermophysical properties were measured for the SrM keeping Fe³⁺/Sr²⁺ ratio 10 calcined at 1000 °C. The synthesized SrM can be applied in magnetic recording media and as photocatalyst due to its low coercivity (2764.48 Oe), high saturation magnetization (73.77 emu/g) and low band gap energy (Eg-2.04 eV) respectively.

2+δ-Dimensional Materials via Atomistic Z-Welding

Pivotal to functional van der Waals stacked flexible electronic/excitonic/spintronic/thermoelectric chips is the synergy amongst constituent layers. However; the current techniques viz. sequential chemical vapor deposition, micromechanical/wet-chemical transfer are mostly limited due to diffused interfaces, and metallic remnants/bubbles at the interface. Inter-layer-coupled 2+δ-dimensional materials, as a new class of materials can be significantly suitable for out-of-plane carrier transport and hence prompt response in prospective devices. Here, the discovery of the use of exotic electric field ≈10⁶  V cm^{- 1} (at microwave hot-spot) and 2 thermomechanical conditions i.e. pressure ≈1 MPa, T ≈ 200 °C (during solvothermal reaction) to realize 2+δ-dimensional materials is reported. It is found that P_z P_z chemical bonds form between the component layers, e.g., CB and CN in G-BN, MoN and MoB in MoS₂ -BN hybrid systems as revealed by X-ray photoelectron spectroscopy. New vibrational peaks in Raman spectra (BC ≈1320 cm^-1 for the G-BN system and MoB ≈365 cm^-1 for the MoS₂ -BN system) are recorded. Tunable mid-gap formation, along with diodic behavior (knee voltage ≈0.7 V, breakdown voltage ≈1.8 V) in the reduced graphene oxide-reduced BN oxide (RGO-RBNO) hybrid system is also observed. Band-gap tuning in MoS₂ -BN system is observed. Simulations reveal stacking-dependent interfacial charge/potential drops, hinting at the feasibility of next-generation functional devices/sensors.

Enhanced carriers separation in novel in-plane amorphous carbon/g-C3N4 nanosheets for photocatalytic environment remediation

Although carbon-based materials/g-C₃N₄ heterostructure with an up-down structure in space can inhibit the recombination of charge carriers, the electron transfer is still suppressed by the interlayer van der Waals force. Herein, amorphous carbon is successfully introduced into the g-C₃N₄ nanosheet (CNS) by a self-conversion process to form an in-plane heterostructure of amorphous carbon/g-C₃N₄ (CNSC₁). Kelvin probe atomic force microscopy (KPFM) and density functional theory (DFT) confirm that g-C₃N₄ and amorphous carbon are in the same plane, which can generate the surface electric field of CNSC₁, providing a driving force for the transfer of electrons from g-C₃N₄ to amorphous carbon. Meanwhile, the sp²-hybridized π conjugation bond of amorphous carbon can rapidly capture and store photogenerated electrons, inhibiting charge carrier recombination and thus generating more electrons to facilitate the yield of hydroxyl radicals. The photocatalytic activity of CNSC₁ for the degradation of tetracycline and rhodamine B is 2.7 times and 4.8 times higher than that of CNS, respectively, due to the efficient interface charge separation. This work is expected to provide a new idea for the combination of carbon materials and g-C₃N₄.

Atomic sheets of silver ferrite with universal microwave catalytic behavior

Prompt degradation of organic pollutants renders microwave (MW) catalysis technology extremely lucrative; ideal microwave catalysts are therefore being hunted with an unprecedented urgency. Ideal functional microwave catalyst should be highly crystalline, room temperature ferromagnetic (for magnetic retrieval), highly dielectric (for sufficient microwave absorption) apart from being structurally stable at high temperature. The potential of silver ferrite 2D sheets (2D AFO) synthesized using a novel microwave technique as a microwave catalyst for the degradation of a variety of organic dyes and antibiotics was investigated in this article. While organic dyes like malachite green (MG), brilliant green (BG) and nile blue A (NB) achieved 99.2%, 98.8% and 95.2%, respectively; antibiotic tetracycline hydrochloride (TCH) molecule resulted in 75.8% degradation efficiency. Total organic carbon (TOC) measurements yielded 76%, 59.1%, 49.1% and 47.6% of carbon content for MG, BG, NB and TCH, respectively. The reaction pathway via intermediates and subsequent degradation to CO₂ and H₂O is revealed by liquid chromatography-mass spectrometry (LCMS). Both superoxide and hydroxyl radicals are participating in the process, according to scavenger tests. The evolution of silver ferrite as a new 2D material and its demonstration as an ideal microwave catalyst will lead to a new beginning in catalysis science and technology.

Zinc ferrite-graphitic carbon nitride nanohybrid for photo-catalysis of the antibiotic ciprofloxacin

2D hybrid sheets of zinc ferrite and graphitic carbon nitride were explored for their application as a UV catalyst for the degradation of ciprofloxacin.