Under-oil superhydrophilic TiO2/poly(sodium vinylphosphonate) nanocomposite for the separation of water from oil

Facile fabrication of Mxene coated metal mesh-based material for oil /water emulsion separation

The present study was set out to synthesize Mxene (Ti₃C₂Tx) and functionalized Mxene nanoparticles and fabricating Mxene coated stainless steel meshes using the dip-coating methodology to investigate the capability of Mxene nanoparticles in oil-water emulsion separation. O/W mixtures separation with extraordinary 100% of effectiveness and purity using designed grid was observed. Most specifically, Mxene fabricated mesh showed good resistance to corrosive solutions of HCl and NaOH and was used to separate O/W at harsh medium condition with a separation efficiency of more than after 96.0% replicated experiment, and its super-hydrophilicity persisted in spite of the air exposure condition, extreme fluids immersion, or abrasion. The XRD, FTIR, SEM, FESEM, AFM and DLS tests have been performed to characterize the Mxene coating and its effectiveness on the O/W separation. These analyzes confirm the fabricated tough super-hydrophilic stainless-steel mesh explored in this research can basically be utilized as a highly effective useful mesh for O/W fluid separation under different sever circumstances. The XRD pattern of the resulting powder shows a single phase formation of Mxene, the SEM and FESEM images confirms creation of coated mesh with approximately 30 µ pore size, AFM tests verify that structures (both in nm and µm sizes) formation with high RMS (Root Mean Square) roughness values of 0.18 µm and 0.22 µm for Mxene and carboxylic-Mxene coated mesh. The DLS tests prove the droplets size distribution of emulsion has been augmented after several O/W separation, which confirmed the coagulating mechanism of oil droplets once contacting with the Mxene and carboxylic Mxene coatings of the mesh.

Substituted Poly(Vinylphosphonate) Coatings of Magnetite Nanoparticles and Clusters

Magnetite nanoparticles and clusters of nanoparticles have been of Increasing scientific interest in the past decades. In order to prepare nanoparticles and clusters that are stable in suspension, different coatings have been used. Phosphates and phosphonates are a preferred anchoring group for the coating of magnetite nanomaterials. However, poly(vinylphosphonates) have rarely been used as a coating agent for any nanoparticles. Here, poly(methylvinylphosphonate) and other substituted polyvinylphosphonates are described as new coatings for magnetite nanoparticles and clusters. They show great stability in aqueous suspension. This is also the first time phosphonate-coated magnetite clusters have been synthesized in a one-pot polyol reaction. The coated magnetite nanoparticles and clusters have been characterized by TEM, EDX, FTIR, magnetization measurement, XRD as well as XPS. It has been shown that substituted vinylphosphonates can be easily synthesized in one-step procedures and as a polymeric coating can imbue important properties such as stability in suspension, tight binding to the particle surface, the ability to be further functionalized or to tightly adsorb metal ions. For the synthesis of magnetite clusters the cluster formation, polymerization and coating are done in a one-pot reaction and the resulting magnetite clusters show a higher amount of phosphonate coating than with a three-step procedure including a ligand exchange.