Efficient removal of antimony from aqueous solution by sustainable polymer assisted ultrafiltration process

Reduction of Ultrafiltration Membrane Fouling by the Pretreatment Removal of Emerging Pollutants: A Review

Ultrafiltration (UF) processes exhibit high removal efficiencies for suspended solids and organic macromolecules, while UF membrane fouling is the biggest obstacle affecting the wide application of UF technology. To solve this problem, various pretreatment measures, including coagulation, adsorption, and advanced oxidation, for application prior to UF processes have been proposed and applied in actual water treatment processes. Previously, researchers mainly focused on the contribution of natural macromolecular pollutants to UF membrane fouling, while the mechanisms of the influence of emerging pollutants (EPs) in UF processes (such as antibiotics, microplastics, antibiotic resistance genes, etc.) on membrane fouling still need to be determined. This review introduces the removal efficiency and separation mechanism for EPs for pretreatments combined with UF membrane separation technology and evaluates the degree of membrane fouling based on the UF membrane's materials/pores and the structural characteristics of the cake layer. This paper shows that the current membrane separation process should be actively developed with the aim of overcoming specific problems in order to meet the technical requirements for the efficient separation of EPs.

Speciation, in vitro bioaccessibility and health risk of antimony in soils near an old industrial area

Antimony (Sb) contamination in soil has become a major environmental issue due to its adverse effects on ecosystems and human health. In this paper, 1255 soil samples were analyzed to investigate the distribution, speciation, in vitro oral bioaccessibility (8 soil samples) and human health risk of Sb in contaminated soils and its impacts on groundwater. The results showed that 4.38 % of the soil samples within the depth of 0-31 m exceeded the Risk Screening Values (RSV). Sb mainly existed in the residual fraction (38.05 % ∼ 94.22 %), Fe/Mn oxides (0.01 % ∼ 31.80 %) and the organic fraction (0.32 % ∼ 21.55 %) with poor mobility. The bioaccessibility of Sb was approximately <31 %. The total concentration of Sb (TSb) in soil was the dominant factor influencing the bioaccessible concentration of Sb (SbBio). Soil physiochemical properties such as Fe, Mn, and organic matter content (OM) also affected the magnitude of SbBio. Health risk assessment based on in vitro bioaccessibility suggested that the hazard quotient (HQ) of adults was within the acceptable level (HQ < 1) for industrial scenario, while the HQ of children and adults was greater than the acceptable level (HQ ≥ 1) for residential scenario, with a higher risk to children than adults. The results of the leaching experiment involving Dilution-Attenuation Factor (DAF) model suggested that the predicted maximum concentration of Sb in groundwater was 2.40 μg/L that is lower than the acceptable standard value (5 μg/L), implying that groundwater was not contaminated by Sb in soil. The findings of this study provide some insights into the speciation, in vitro bioaccessibility and health risk of toxic trace metals in contaminated soils and the potential environmental impacts.

Removal of Antimony(III) and Antimony(V) from water samples through water-soluble polymer-enhanced ultrafiltration

Addressing antimony (Sb) contamination, which is caused by the use of Sb compounds in various industries, is crucial. This study aims to compare two different Sb removal mechanisms: ion exchange and chelation. Therefore, two different water-soluble polymers-glycidyl methacrylate-N-methyl-D-glucamine and poly 2-(acryloyloxy)ethyl trimethylammonium chloride-were synthesized and used to remove Sb(III) and Sb(V) using the polymer-enhanced ultrafiltration (PEUF) method. The removal of Sb(III) was pH-dependent and extremely difficult at a pH of 1.2. However, when the pH of the solution was increased to 11, the Sb(III) removal rate increased to 77%. The Sb(III) removal rate was 28% at an Sb(III):polymer mole ratio of 1:5, which increased to 77% at a mole ratio of 1:20. Sb(III) removal was discovered to be unaffected by the low concentrations of Na⁺, K⁺, Ca²⁺, and Mg²⁺ ions in the solution, maintaining a Sb(III) removal rate of 77%. The test parameters showed different characteristics for Sb(V) removal. Increasing the pH of the solution from 1 to 9 correspondingly increased the removal rate from 0% to 45%, but increasing it further to 11 decreased the removal rate to 14%. The removal rate of Sb(V) was 67% at a Sb(V):polymer mole ratio of 1:60. Sb(V) removal was discovered to be unaffected by low concentrations of SO₄^2-, NO₃^-, and PO₄^3- anions in the solution. However, notably, the Sb(V) removal rate decreased from 67% to 58% in the presence of Cl^- ions. The results demonstrate that Sb removal via chelation was more effective than by ion exchange, and it remained unaffected by the presence of interfering ions.

Traditional Chinese Medicine Extract Properties Incorporated Energy Analysis for Membrane Concentration Processes

This work focuses on the energy analysis of the membrane concentration systems that process traditional Chinese medicine extracts with dynamic properties incorporated, particularly for reverse osmosis (RO) and membrane distillation (MD) processes. The evaluation of process energy consumption was achieved by integrating the empirical properties correlations of Brix and other characteristics properties of the feed (e.g., density and heat capacity). The dynamic SEC analysis for RO process was largely dependent on the feed pressure, reported at 50 kWh/m³ at feed pressure of 0.9 MPa with less than 50% water removal. The occurrence of foaming at above 50% water removal caused discrepancies between the simulated flux results and the experimentally acquired results in RO, whereas the estimated dynamic SEC for MD process did not show a strong correlation with the temperatures selected in this study, ranging from 900 to 1000 kWh/m³. This approach can be adapted into the design and zoptimization for the concentration process of other herbal extracts by membrane technologies, allowing comprehensive understanding into the energy analysis in future study.