Harvesting of different microalgae through 100-μm-pore-sized screen filtration assisted by cationic polyacrylamide and specific extracellular organic matter

Insight into coagulation/flocculation mechanisms on microalgae harvesting by ferric chloride and polyacrylamide in different growth phases

FeCl3 and polyacrylamide (PAM) had been used to investigate the effect of coagulation, flocculation, and their combination on algae cells and extracellular organic matter (EOM) at different phases. PAM tended to aggregate particle-like substances, while FeCl3 could interact with EOM. The content of EOM kept rising during the algae growth cycle, while OD680 peaked at about 3.0. At stationary phase Ⅰ, the removal efficiencies of UV254, turbidity and OD680 of the suspension conditioned with FeCl3 + PAM reached (88.08 ± 0.89)%, (89.72 ± 0.36)% and (93.99 ± 0.05)%, respectively. Nevertheless, PAM + FeCl3 exhibited the worst efficiency because of the release of EOM caused by the turbulence. The results suggested that algal cells served as a coagulation aid to facilitate floc formation, while excessive EOM deteriorated harvesting performance. The process of FeCl3 + PAM at stationary phase Ⅰ appears to be a promising technology for microalgae harvesting.

Instantaneous and reversible flocculation of Scenedesmus via Chitosan and Xanthan Gum complexation

An instantaneous and reversible flocculation method for Scenedesmus harvesting was developed, based on the complexation of Chitosan (CTS) and Xanthan Gum (XG). Under rapid stirring, Scenedesmus cells formed centimeter-sized flocs within 20 s using binary flocculants of 4 mg/L CTS and 16 mg/L XG. These flocs exhibited a remarkable harvest efficiency exceeding 95 % when filtered through 500-μm-pore-sized sieves. Furthermore, the flocs could be completely disintegrated by using alkaline or NaCl solutions (pH > 11 or NaCl concentration > 1.5 mol/L). Adjusting pH allowed recovery of 50 % CTS and 75 % XG, resulting in microalgae biomass with lower flocculant content and reducing reagent costs. Electrostatic interaction of -COO- of XG and -NH3+ of CTS deduced the formation of polyelectrolyte complexes (PECs), which shrink and wrap the coexisting algal cells to form the flocs under stirring. CTS and XG complexation was instantaneous and reversible, explaining quick flocculation and disintegration.

A novel biomineralization-inspired flocculation approach for harvesting high quality microalgal biomass: Dual action of cationic polyelectrolytes and nanosilica

This study posed a novel biomimetic flocculation approach, aiming to efficiently harvest high-quality biomass of Scenedesmus quadricauda cultured with anaerobic digestate. Here, that poly(diallyldimethylammonium chloride) (PDADMAC) could serve as mimetic silicified proteins to spontaneously incorporate nanosilica onto microalgal cells, imparting diatom-like characteristics to S. quadricauda. Compared to the exponential growth phase (day 3), the highest harvesting efficiency (93.49%) was obtained at a lower dosage of PDADMAC (5 mg/g) in the stationary phase (day 6), which was attributed to changes in properties and composition of microalgal LB-EPS. On day 6, the hydrophobic functional groups in LB-EPS provided more binding sites during the flocculation process and formed a network structure of microalgal cells-flocculants-nanosilica. The resulting larger and more stable biomimetic silica shell promoted microalgal flocculation and sedimentation. Compared to conventional harvesting methods (centrifugation, polyacrylamide, alkaline flocculation), this method had the minimal negative impact on harvested biomass, with 9.95% of cell membranes damaged.

Calcium sulfite oxidation activated by ferrous iron integrated with membrane filtration for removal of typical algal contaminants

Oxidation treatment of algae-laden water may cause cells rupture and emission of intracellular organics, thus restricting its further popularization. As a moderate oxidant, calcium sulfite could be slowly released in the liquid phase, thus exhibiting a potential to maintain the cells integrity. To this end, calcium sulfite oxidation activated by ferrous iron was proposed integrated with ultrafiltration (UF) for removal of Microcystis aeruginosa, Chlorella vulgaris and Scenedesmus quadricauda. The organic pollutants were significantly eliminated, and the repulsion between algal cells was obviously weakened. Through fluorescent components extraction and molecular weights distribution analyses, the degradation of fluorescent substances and the generation of micromolecular organics were verified. Moreover, the algal cells were dramatically agglomerated and formed larger flocs under the premise of maintaining high cell integrity. The terminal normalized flux was ascended from 0.048 to 0.072 to 0.711-0.956, and the fouling resistances were extraordinarily decreased. Due to the distinctive spiny structure and minimal electrostatic repulsion, Scenedesmus quadricauda was easier to form flocs, and its fouling was more readily mitigated. The fouling mechanism was remarkably altered through postponing the formation of cake filtration. The membrane interface characteristics including microstructures and functional groups firmly proved the fouling control efficiency. The reactive oxygen species (i.e., SO₄^•- and ¹O₂) generated through the principal reactions and Fe-Ca composite flocs played dominant roles in alleviating membrane fouling. Overall, the proposed pretreatment exhibits a brilliant application potential for enhancing UF in algal removal.

Comprehensive analysis of the combined flocculation and filtration process for microalgae harvesting at various operating parameters

The combined process of flocculation and filtration can improve algae harvesting performance by combining the benefits of both and overcoming the drawbacks. The entire process was thoroughly examined in this study, considering technical and economic feasibility under a variety of operating situations. Dead-end filtration was performed to evaluate the harvesting performance, the removal of extracellular organic matter and the changes of flocs. Cross-flow filtration was then carried out to explore the effect of operating parameters on permeate flux and assess the technical and economic feasibility. The optimum operating condition was to use 5 mg/L cationic polyacrylamide with 25 μm pore size and 0.1 m/s cross-flow velocity, under which a high harvesting efficiency of 95.2 %, a high average permeate flux of 55.5 m³/(m² h) and a volumetric reduction factor of 118.9 were achieved. Algal floc analysis revealed that flocs formed by ferric chloride and polyaluminium sulfate tended to partially deconstruct into smaller pieces during the filtration process. In contrast, flocs formed by cationic polyacrylamide tended to aggregate into bigger flocs, which, when paired with the effect of flocculant dosage and membrane pore size, could explain the difference in filtration performance and membrane permeance. No negative effect on downstream technology was observed for the combined process. A significantly lowered estimated total cost of 0.139 $/kg under optimum operating condition was obtained compared to filtration without flocculation assisted (0.206 $/kg).

Harvesting of Microcystis flos-aquae using dissolved air flotation: The inhibitory effect of carboxyl groups in uronic acid-containing carbohydrates

Harvesting algal biomass reduces nutrient loading in eutrophicated lakes and the protein-rich microalgal biomass could be recycled as feedstocks of feed and fertilizer. Due to the complexity of algogenic organic matter (AOM), the key components and functional groups in AOM that inhibit coagulation-based microalgal harvesting have not been disclosed thus far. This study quantitatively analysed the responsive compositions and functional groups of AOM involved in the dissolved air flotation (DAF) harvesting of M. flos-aquae with 1 × 10⁹ cell L^-1 density at coagulation pH 6.2. The results showed that harvesting efficiency dropped drastically from 95.5 ± 0.7% to 43 ± 0.7% in the presence of AOM (26.77 mg L^-1) at the coagulant dosage of 0.75 mg L^-1 and further deteriorated with increasing AOM concentration. Carbohydrates contributed 81% of the total composition of substances involved in the DAF, while the contribution of protein and humic-like substances were only 18% and 1%, respectively. Stoichiometric analysis of functional groups in carbohydrates, proteins, and humic-like substances using model components revealed that carboxyl groups in uronic acid-containing carbohydrates accounted for 76% of the total reduction in carboxyl groups, which was much higher than that in proteins (23%) and humic-like substances (1%), indicating that carboxyl groups in uronic acids containing carbohydrates were the major inhibitors. A conceptual model of charge competition was proposed to explain the inhibition mechanism of carboxyl functional groups in uronic acid-containing carbohydrates on microalgal DAF. Strategies such as preventing carboxyl deprotonation by pH reduction and employment of sweeping/bridging polymeric coagulants/flocculants were proposed for the to reduce the inhibitory effect of carboxyl functional groups.

A review on biodiesel production from microalgae: Influencing parameters and recent advanced technologies

Microalgae are the important part of carbon cycle in the nature, and they could utilize the carbon resource in water and soil efficiently. The abilities of microalgae to mitigate CO₂ emission and produce oil with a high productivity have been proven. Hence, this third-generation biodiesel should be popularized. This review firstly introduce the basic characteristics and application fields of microalgae. Then, the influencing parameters and recent advanced technologies for the microalgae biodiesel production have been discussed. In influencing parameters for biodiesel production section, the factors of microalgae cultivation, lipid accumulation, microalgae harvesting, and lipid extraction have been summarized. In recent advanced technologies for biodiesel production section, the microalgae cultivation systems, lipid induction technologies, microalgae harvesting technologies, and lipid extraction technologies have been reviewed. This review aims to provide useful information to help future development of efficient and commercially viable technology for microalgae-based biodiesel production.