Construction of 0D/2D CeO2/CdS direct Z-scheme heterostructures for effective photocatalytic H2 evolution and Cr(VI) reduction

New insight into the effects of p-benzoquinone on photocatalytic reduction of Cr(VI) over Fe-doped g-C3N4

It is of great significance to establish an effective method for removing Cr(VI) from wastewater. Herein, Fe-doped g-C3N4 (namely Fe-g-C3N4-2) was synthesized and then employed as photocatalyst to conduct the test of Cr(VI) reduction. Notably, the embedding of Fe ion in g-C3N4 can offer the Fe2+/Fe3+ redox couples, so reducing the interfacial resistance of charge transfer and suppressing the recombination of photogenerated electrons and holes. The impurity energy levels will form in g-C3N4 after the introduction of Fe ion, thereby boosting the light absorption capacity of catalyst. Thus, Fe-g-C3N4-2 showed good performance in photocatalytic Cr(VI) reduction, and the reduction efficiency of Cr(VI) can reach 39.9% within 40 min. Different with many previous studies, current work unexpectedly found that the addition of p-benzoquinone (BQ) can promote the Cr(VI) reduction, and the reduction efficiency of Cr(VI) over Fe-g-C3N4-2 was as high as 93.2% in the presence of BQ (1.5 mM). Further analyses showed that BQ can be reduced to hydroquinone (HQ) by photogenerated electrons, and UV light can also directly induce BQ to generate HQ by using H2O as the hydrogen donor. The HQ with reducing ability can accelerate the Cr(VI) reduction. In short, current work shared some novel insights into photocatalytic Cr(VI) reduction in the presence of BQ. Future research should consider possible reactions between photogenerated electrons and BQ. For the UV-induced photocatalysis, the suitability of BQ as the scavenger of O2•‒ must be given carefully consideration.

In-situ formation of SrTiO3/Ti3C2 MXene Schottky heterojunction for efficient photocatalytic hydrogen evolution

Surface and interface engineering of composite photocatalysts are effective ways to enhance the dynamics of photo-generated charge carriers. In this work, SrTiO3/Ti3C2 MXene (STO/TC) Schottky heterojunction is constructed by in-situ growth of SrTiO3 (STO) on Ti3C2 MXene (TC) through Sr(OH)2 etching the surfaces of TC. This in-situ growth strategy not only creates the tight chemically bonded interfaces by SrTiO3 nanoparticles uniformly anchoring on the surface of two-dimensional Ti3C2 MXene nanosheets for promoting the photo-generated charge carrier separation, but also introduces surface Ti vacancies as the efficient catalytic active sites to accelerate the charge carrier transfer process for efficient hydrogen production. The photocatalytic system constructed by interface and surface engineering optimizes the photo-generated charge carrier dynamics and refines the photocatalytic hydrogen evolution performance (6.8 times higher than pristine SrTiO3) and stability. This work is expected to provide an alternative strategy to construct highly efficient photocatalysts with hydrogen evolution.

Z-scheme MnO2/Mn3O4 heterojunctions with efficient peroxymonosulfate activation for organic pollutant removal

The exploration of efficient heterogeneous catalysts for persistent organic pollutant removal is extremely attractive. In the present work, MnO2/Mn3O4 photo-Fenton catalysts were designed by a facile hydrothermal route to activate peroxymonosulfate (PMS) under visible light irradiation for organic pollutant degradation. The optimized MnO2/Mn3O4 heterojunction shows excellent Rhodamine B (RhB) removal efficiency, whose apparent kinetic constant is 11.9 and 5.36 times as high as the MnO2 and Mn3O4. Meanwhile, there is a neglectable attenuation in catalytic performance after 5 recycling runs. Based on the active species trapping experiments, the non-radical process contributes more than the radical process during RhB degradation. Moreover, factors including the dosage of PMS, initial RhB concentration, initial pH, the presence of various anions, different organic pollutants, and water sources are investigated. Systematical characterizations reveal that the enlarged specific surface areas and the efficient charge separation aroused from the Z-scheme mechanism are attributed to the enhanced photo-Fenton performance. The present work contributes to the construction of the Mn-based photo-Fenton catalyst with efficient PMS activation capacity for environmental remediation.

Enhancement of CdS resistance to photocorrosion and photocatalytic removal of uranyl by complexation with N-deficient g-C3N4under aerobic conditions

The effect of oxygen on the reduction of uranyl and photocorrosion of CdS remains a pressing issue when CdS is used as a photocatalyst for the removal of uranyl in uranium-containing wastewater. In this study, composites (CdS/PCN) were prepared by designing N-deficient g-C₃N₄ composite with CdS for efficient photocatalytic reduction of uranyl under aerobic condition. Meanwhile, a series of characterizations of the CdS/PCN composites were carried out by XRD, FT-IR, XPS, EDS and UV-vis. Surprisingly, the CdS/PCN not only showed very high photocatalytic reduction activity for uranyl under aerobic condition, but also the photocorrosion of CdS by oxygen and h⁺ was inhibited. With a starting uranium (VI) concentration of 20 ppm, the uranium (VI) removal efficiency could reach 97.33% (dark: 30 min, light: 10 min). Interestingly, the removal efficiency was better in air condition than in pure nitrogen or 30% oxygen atmosphere, i.e. a proper amount of oxygen has accelerated the reduction reaction, while excess oxygen weakened the reduction. Finally, a new mechanism of reduction of uranyl by CdS/PCN photocatalyst was given under aerobic condit ions. This work presents a novel strategy for reduction of U(VI) by photocatalysis and the inhibition of photocorrosion of photocatalysts under aerobic conditions.

Highly photoactive novel NiS/BiOI nanocomposite photocatalyst towards efficient visible light organic pollutant degradation and carcinogenetic Cr (VI) reduction for environmental remediation

Heterojunction engineering in catalyst structures is a promising approach for solving the main restriction of the narrow photoabsorption range and quick recombination of photogenerated charge carriers in the photocatalysts. Herein, a simple, eco-friendly, non-toxic, and novel Z-scheme heterojunction of nanoflower-like NiS/BiOI was systematically designed using the low-temperature solvothermal and precipitation methods. The physicochemical and photo-electrochemical properties of the as-synthesized nanomaterials were characterized using XRD, FESEM, FT-IR, XPS, BET, UV-vis, PL, and EIS. NiS/BiOI nanomaterials exhibited a wide photoabsorption range (200-1000 nm), a narrow bandgap energy (1.76 eV), a large surface area (35.82 m² g^-1), and a low charge carrier recombination rate because of the synergistic effects of the NiS and BiOI photocatalysts, which could be the basis for superior photocatalytic efficiency. Particularly, the optimal 40% NiS/BiOI nanocomposite exhibited better stability and efficiency than the pure NiS and BiOI. The maximum degradation efficiency of rhodamine B (RhB) was 99.8% after 200 min, tetracycline (TC) was 96.3% after 140 min, and the photoreduction of Cr(VI) was 92.8% after 180 min rather than the pure NiS and BiOI under visible light irradiation. The constant rate (k) of RhB was approximately 10 and 4, TC was 12 and 4, and Cr(VI) was 10 and 8 times that of pristine NiS and BiOI, respectively. Radical trapping experiments and Tauc plot analysis proposed the design of the plausible Z-scheme reaction mechanism between NiS and BiOI, which has a crucial role in the rate of transportation and separation of electron/hole pairs. This investigation provides a venue for the design of a photoactive NiS-based nanocomposite for environmental remediation.