Influence of pressure and cell design on the production of ozone and organic degradation

Remediation of soils contaminated with methomyl using electrochemically produced gaseous oxidants

This prospective work focuses on the use of two different gaseous oxidants (chlorine dioxide and ozone) to remediate soil polluted with methomyl in two different applications: ex-situ and in-situ. In the first, the soil washing is integrated with the bubbling of the oxidant, while in the second, the gas was introduced by a perforated pipe located sub-superficially. Regarding the soil washing treatment, results demonstrate that direct use of ozone is not very efficient, although an important improvement is obtained following activation with hydrogen peroxide or UV light. In contrast, chlorine dioxide exhibited complete methomyl depletion from the soil, although with higher energy consumption and technical complexity compared to ozone. The direct dosing of the gaseous oxidants in perforated pipes is effective, achieving methomyl removals of 7.8 % and 9.2 % using ozone and chlorine dioxide, respectively. In these cases, soil conditions are not significantly modified, which becomes an important advantage of the technology as compared with other electrochemically assisted soil remediation process, in which large regions of the treated soil are affected by important changes in the pH or by depletion of ions. This lower impact makes these novel technologies more promising for further evaluations.

Cleaning technologies integrated in duct flows for the inactivation of pathogenic microorganisms in indoor environments: A critical review of recent innovations and future challenges

Pathogenic microorganisms are a major concern in indoor environments, particularly in sensitive facilities such as hospitals, due to their potential to cause nosocomial infections. This study evaluates the concentration of airborne bacteria and fungi in the University Hospital Complex of Albacete (Spain), comparing the results with recent literature. Staphylococcus is identified as the most prevalent bacterial genus with a percentage distribution of 35%, while Aspergillus represents the dominant fungal genus at 34%. The lack of high Technology Readiness Levels (TRL 6, TRL 7) for effective indoor air purification requires research efforts to bridge this knowledge gap. A screening of disinfection technologies for pathogenic airborne microorganisms such as bacteria and fungi is conducted. The integration of filtration, irradiation or and (electro)chemical gas treatment systems in duct flows is discussed to enhance the design of the air-conditioning systems for indoor air purification. Concerns over microbial growth have led to recent studies on coating commercial fibrous air filters with antimicrobial particles (silver nanoparticles, iron oxide nanowires) and polymeric materials (polyaniline, polyvinylidene fluoride). Promising alternatives to traditional short-wave UV-C energy for disinfection include LED and Far-UVC irradiation systems. Additionally, research explores the use of TiO2 and TiO2 doped with metals (Ag, Cu, Pt) in filters with photocatalytic properties, enabling the utilization of visible or solar light. Hybrid photocatalysis, combining TiO2 with polymers, carbon nanomaterials, or MXene nanomaterials, enhances the photocatalytic process. Chemical treatment systems such as aerosolization of biocidal agents (benzalkonium chloride, hydrogen peroxide, chlorine dioxide or ozone) with their possible combination with other technologies such as adsorption, filtration or photocatalysis, are also tested for gas disinfection. However, the limited number of studies on the use of electrochemical technology poses a challenge for further investigation into gas-phase oxidant generation, without the formation of harmful by-products, to raise its TRL for effectively inactivating airborne microorganisms in indoor environments.