Role of virgin coconut oil (VCO) as co-extractant for obtaining xanthones from mangosteen (Garcinia mangostana) pericarp with supercritical carbon dioxide extraction

Application of the Surface Regression Technique for Enhancing the Input Factors and Responses for Processing Coconut Oil under Vertical Compression

This study optimized the input processing factors, namely compression force, pressing speed, heating temperature, and heating time, for extracting oil from desiccated coconut medium using a vertical compression process by applying a maximum load of 100 kN. The samples' pressing height of 100 mm was measured using a vessel chamber of diameter 60 mm with a plunger. The Box-Behnken design was used to generate the factors' combinations of 27 experimental runs with each input factor set at three levels. The response surface regression technique was used to determine the optimum input factors of the calculated responses: oil yield (%), oil expression efficiency (%), and energy (J). The optimum factors' levels were the compression force 65 kN, pressing speed 5 mm min-1, heating temperature 80 °C, and heating time 52.5 min. The predicted values of the responses were 48.48%, 78.35%, and 749.58 J. These values were validated based on additional experiments producing 48.18 ± 0.45%, 77.86 ± 0.72%, and 731.36 ± 8.04 J. The percentage error values between the experimental and the predicted values ranged from 0.82 ± 0.65 to 2.43 ± 1.07%, confirming the suitability of the established regression models for estimating the responses.

Edible oils as a co-extractant for the supercritical carbon dioxide extraction of flavonoids from propolis

Propolis is a good source for flavonoids, however, their recovery is challenging, as it is a waxy material. This study investigated edible oils virgin coconut oil (VCO), corn oil (CO), and ghee (G) as co-extractants for the supercritical carbon dioxide (scCO₂) extraction of flavonoids from the propolis. The extraction of flavonoids using 20% VCO as co-extractant with scCO₂ (25 g/min) for 210 min at 150 bar and 50°C was found to be the most appropriate, yielding a total flavonoid content (TFC) of 11.7 mg/g and 25% TFC recovery. At a higher temperature (60°C) and pressure (250 bar and 350 bar), the propolis became softer and compressed causing the extractions to retrograde. The extraction curves correlated to the diffusion model with 1.6% (AARD). The matrix diffusivities increased from 4.7 × 10⁻¹¹ m²/s (scCO₂) to 6.9 × 10⁻¹¹–21.4 × 10⁻¹¹ m²/s upon the addition of edible oils. Thus, edible oils could be used with scCO₂ to improve the flavonoid extraction from propolis.