Cigarette filters as adsorbents of solid-phase extraction for determination of fluoroquinolone antibiotics in environmental water samples coupled with high-performance liquid chromatography

Method Validation and Measurement Uncertainty (MU) Evaluation on Enrofloxacin and Ciprofloxacin in the Aquatic Products

This study aimed to investigate a detection method of enrofloxacin and ciprofloxacin to be avail for strictly supervising the quality and safety of aquatic products. The results displayed that the optimal extraction conditions for enrofloxacin and ciprofloxacin were the following five aspects: 15 g dosages of Na2SO4 to dehydrate, 8‰ of acetonitrile and 50% hydrochloric acid to deproteinization, 2 mL dosages of n-hexane to degrease, 10 min of ultrasonic time, and 20 min of extraction (stand) time. Meanwhile, it was also obtained for the optimal detection performance indexes of the recovery, precision, and accuracy from the tests of shrimp, grass carp, and tilapia. In particular, the expanded uncertainties were 2.8601 and 0.8613, and the factors of both the calibration curves (Urel(C)) and the analysis of the experiment (Urel(E)) were the two MU main contributors for enrofloxacin and ciprofloxacin together with the results above 40%. Consequently, the developed novel method was suited for the determination of the enrofloxacin and ciprofloxacin residues in aquatic products and would contribute to reinforce in supervision and inspection of the quality and safety of aquatic products.

Partially carbonized cellulose filter paper as a green adsorbent for the extraction of pesticides from fruit juices

In this study, a new solid phase extraction method based on the use of a low-cost funnel-shaped partially carbonized cellulose filter paper as a sorbent has been developed. The sorbent is easily prepared by heating the folded filter paper wetted with sulfuric acid solution and can be reused for several times. It is combined with dispersive liquid-liquid microextraction and used for the extraction of some pesticide residues from fruit juice samples prior to their analysis by gas chromatography-flame ionization detection. In this work, limits of detection and quantification were in the ranges of 0.30-0.61 and 1.0-2.0 µg L^-1, respectively, and relative standard deviations ranged between 3 and 6% for intra- (n=5) and inter-day (n=5) precisions at a concentration of 25 µg L^-1 of each pesticide. The enrichment factors of 452-751 were achieved. Extraction recoveries were in the range of 45-75%. The calibration curves had wide linear ranges with a good linearity (coefficient of determination ≥ 0.994). Finally, efficiency of the method was apprised by determining the analytes in fruit juice samples and relative recoveries were found to be in the range of 85-101%.

Corncob Waste Based Adsorbent for Solid Phase Extraction of Tartrazine in Carbonated Drinks and Analytical Method using Ultra Performance Liquid Chromatography-Mass Spectrometry

Background :

A new method has been developed for the determination of food dye tartrazine in soft drinks. Tartrazine is determined by hyphenated technique Ultra Performance Liquid Chromatography coupled with Mass spectrometry. The solid-phase extraction was used for the extraction of tartrazine.

Methods:

For the LC-MS analysis of tartrazine acetonitrile, water (80:20) was used as a mobile phase whereas, the C-18 column was selected as the stationary phase. The chromatographic run was allowed for 1 min. The adsorbent of the solid-phase extraction was synthesized from the waste corn cob.

Results:

Method found to be linear in the range of 0.1 mg L-1 - 10 mg L-1, limits of detection and quantitation were found to be 0.0165 mgL-1 and 0.055 mgL-1, respectively. Tartrazine, in the real sample, was found to be 20.39 mgL-1 and 83.26 mgL-1.

Conclusion:

The developed UPLC-MS method is rapid, simple, precise and can be used for the quantitative analysis of tartrazine. The solid-phase extraction also involves a cost-effective procedure for extraction as it does not involve the commercial cartridge.

Collection and Separation of Fleroxacin and Ciprofloxacin in Ultrasound-Assisted Ionic Liquid Salting-Out Microextraction System

An ultrasound-assisted ionic liquid (IL) salting-out microextraction system was developed and applied for the extraction of quinolone antibiotics from urine. A precipitate was formed from the salt and IL, and it acted as the sorbent for the analytes. The precipitate containing the analyte was separated by filtration, redissolved, and the solution then was evaporated. The resulting extract was redissolved for high-performance liquid chromatographic analysis. Several parameters, including type and volume of IL, the type and amount of salts, sample pH, temperature and extraction time were optimized. Under the optimal experimental conditions, the limits of detection for fleroxacin and ciprofloxacin were 3.12 and 4.97 μg L-1, respectively. When the present method was applied to real urine sample analysis, the analyte recoveries ranged from 82.3 to 106.8%. This ultrasound-assisted IL salting-out microextraction system had the characteristics of high recoveries, shorter separation time and easy-to-perform collection procedure, which yielded the method to have potential for wide application.

Immobilized imidazolium-based ionic liquids in C18 for solid-phase extraction

In this work, two solid-phases based on imidazolium-based ionic liquids were obtained and characterized for solid-phase extraction of fluoroquinolones. The process of immobilization was performed replacing a toxic reagent by UV-irradiation to get a harmless process. The obtained solid-phases were characterized by nuclear magnetic resonance spectroscopy and elemental analysis. Each solid-phase was packed in a cartridge and was used in solid-phase extraction processes for norfloxacin and ciprofloxacin, after the optimization of some parameters such as the elution solvent, the eluent volume and, the sample volume to be used during the loading step. The developed solid-phases with immobilized ionic liquids were successfully implemented for the studied compounds and indicate high probabilities to be useful in solid-phase extractions of other fluoroquinolones.

Application of activated carbon-decorated polyacrylonitrile nanofibers as an adsorbent in dispersive solid-phase extraction of fluoroquinolones from wastewater

A cheap and simple sample preparation method, consisting of a dispersive solid-phase method and an adsorbent, activated carbon decorated PAN nanofibers, was employed and used for the extraction of antibiotics (ciprofloxacin, danofloxacin, and enrofloxacin) in wastewater. Electrospun PAN nanofibers that were decorated with activated carbon produced from waste tires were used as the solid phase and the antibiotics analyzed by using high-performance liquid chromatography. Parameters such as pH, mass of adsorbent (MA), extraction volume (EV), and extraction time (ET) were optimized owing to their potential effect on the extraction of antibiotics from water. The recovery of all antibiotics was satisfactory, in the range of 90%–99%. The limits of detection and quantification were 0.05, 0.11, 0.20, and 0.53, 1.21, 2.17 µg/L, respectively. The precision was determined from the repeatability and reproducibility and expressed as the intra-day (n = 20) and inter-day (n = 5) precision. The intra-day and inter-day precision was reported in terms of the percentage relative standard deviation, which was 3% and 4%, respectively. The adsorption capacity of the activated carbon-decorated PAN nanofibers was satisfactory, and the reusability of the adsorbent was impressive when reused ten times. The accuracy of the dispersive solid phase extraction (DSPE) was validated by spike recovery tests; the results proved the reliability and efficiency of adsorbing antibiotics from wastewater. Finally, the proposed method was applied to wastewater samples collected from a wastewater treatment plant, which included influent, secondary, and effluent wastewater.

Rapid detection of taste and odor compounds in water using the newly invented chemi-ionization technique coupled with time-of-flight mass spectrometry

Taste and odor (T&O) compounds are widespread in water environments and have attracted considerable public attention. Nowadays, the standard detections of these chemicals rely mainly on off-line methods such as GC-MS or evaluation by trained analysts' senses. In this study, we report a method for the rapid detection of T&O compounds in water by exploiting a newly invented chemi-ionization source, in combination with headspace vapor measurement at room temperature. The calibrated limits of detection (LODs) of 2-methylbutyraldehyde, methyl tert-butyl ether (MTBE), methyl methacrylate (MMA), 2-isobutyl-3-methyoxypyrazine (IBMP), and 2-isopropyl-3-methoxypyrazine (IPMP) are in the range of 3.5-50.2 ng L^-1, and the estimated LODs of 2-methylisoborneol (2-MIB) and geosmin (GSM) are 0.25 and 0.77 ng L^-1, respectively. The calibration results reveal that the instrumental LODs for 2-methylbutyraldehyde, MTBE, MMA, β-cyclocitral, 2-MIB, and GSM are 1-2 orders of magnitude better than the odor thresholds of humans. The accuracy, precision, recovery, and linearity (R²) of the method are tested. Water samples from city tap water and three rivers in Beijing are assessed using this technique, and the typical T&O compositions are observed with concentrations ranging from 0.2 to 297 ng L^-1. The new ultra-sensitive rapid detection method shows comparable sensitivities to the existing off-line technique and displays great potential for real-time detection of T&O pollution in water environments.

Preparation and characterization of a composite based on polyaniline, polypyrrole and cigarette filters: adsorption studies and kinetics of phenylbutazone in aqueous media

PAni–PPy–CFs composite was prepared by a static one-step triple-phase interfacial reaction, in which the PAni and PPy particles were formed and aggregated on CFs resulting in a composite with fibrous domains and good adsorption proprieties.

Selective extraction and determination of fluoroquinolones in bovine milk samples with montmorillonite magnetic molecularly imprinted polymers and capillary electrophoresis

A sensitive and selective method for separating fluoroquinolones (FQs) from bovine milk samples was successfully developed using montmorillonite magnetic molecularly imprinted polymers (MMMIPs) as adsorbents. MMMIPs were prepared using montmorillonite as carrier, fleroxacin (FLE) as template molecule, and Fe3O4 magnetite as magnetic component. MMMIPs possessed high adsorption capacity of 46.3 mg g(-1) for FLE. A rapid and convenient magnetic solid-phase extraction procedure coupled with capillary electrophoresis was established with MMMIPs as adsorbents for simultaneous and selective extraction of four FQs in bovine milk samples. Limits of detection ranged between 12.9 and 18.8 μg L(-1), and the RSDs were between 1.8% and 8.6%. The proposed method was successfully applied to spike bovine milk samples with recoveries of 92.7%-108.6%.

Analysis of Five Earthy-Musty Odorants in Environmental Water by HS-SPME/GC-MS

The pressing issue of earthy and musty odor compounds in natural waters, which can affect the organoleptic properties of drinking water, makes it a public health concern. A simple and sensitive method for simultaneous analysis of five odorants in environmental water was developed by headspace solid-phase microextraction (HS-SPME) coupled to chromatography-mass spectrometry (GC-MS), including geosmin (GSM) and 2-methylisoborneol (2-MIB), as well as dimethyl trisulfide (DMTS), β -cyclocitral, and β -ionone. Based on the simple modification of original magnetic stirrer purchased from CORNING (USA), the five target compounds can be separated within 23 min, and the calibration curves show good linearity with a correlation coefficient above 0.999 (levels = 5). The limits of detection (LOD) are all below 1.3 ng L(-1), and the relative standard deviation (%RSD) is between 4.4% and 9.9% (n = 7) and recoveries of the analytes from water samples are between 86.2% and 112.3%. In addition, the storage time experiment indicated that the concentrations did not change significantly for GSM and 2-MIB if they were stored in canonical environment. In conclusion, the method in this study could be applied for monitoring these five odorants in natural waters.

Orthogonal Design Study on Factors Affecting the Determination of Common Odors in Water Samples by Headspace Solid-Phase Microextraction Coupled to GC/MS

Geosmin and 2-MIB are responsible for the majority of earthy and musty events related to the drinking water. These two odorants have extremely low odor threshold concentrations at ng L(-1) level in the water, so a simple and sensitive method for the analysis of such trace levels was developed by headspace solid-phase microextraction coupled to gas chromatography/mass spectrometry. In this study, the orthogonal experiment design L32 (4(9)) was applied to arrange and optimize experimental conditions. The optimum was the following: temperatures of extraction and desorption, 65°C and 260°C, respectively; times of extraction and desorption, 30 min and 5 min, respectively; ionic strength, 25% (w/v); rotate-speed, 600 rpm; solution pH, 5.0. Under the optimized conditions, limits of detection (S/N = 3) were 0.04 and 0.13 ng L(-1) for geosmin and 2-MIB, respectively. Calculated calibration curves gave high levels of linearity with a correlation coefficient value of 0.9999 for them. Finally, the proposed method was applied to water samples, which were previously analyzed and confirmed to be free of target analytes. Besides, the proposal method was applied to test environmental water samples. The RSDs were 2.75%~3.80% and 4.35%~7.6% for geosmin and 2-MIB, respectively, and the recoveries were 91%~107% and 91%~104% for geosmin and 2-MIB, respectively.