Evaluation of sequential injection chromatography for reversed phase separation of triazine herbicides exploiting monolithic and core–shell columns

Enhanced Separation Capability of Sequential Injection Chromatography for Fluorimetric Determination of Intracellular Dissolved Free Amino Acids in Marine Microalgae

This chapter describes improvements in a sequential injection method to automate the fluorimetric determination of amino acids by pre-column derivatization with o-phthaldialdehyde in presence of 2-mercaptoethanol. Separation is achieved by reversed-phase liquid chromatography in a 50 × 4.6 mm C₁₈ silica-based monolithic column. The method is low-priced, and the separation is performed by stepwise gradient elution using six mobile phases. The mobile phase used for the first elution step is composed of methanol/tetrahydrofuran/10 mM phosphate buffer (pH 7.2) at volumetric ratio 8:1:91. Additional elution steps use mobile phases containing methanol and 10 mM phosphate buffer at volumetric ratios of 17.5:82.5, 25:75, 35:65, 50:50, and 65:35. Nineteen chromatographic peaks are observed in a mixture of twenty amino acids. The only complete co-elution is between tryptophan and methionine. The entire cycle of amino acid derivatization, chromatographic separation, and column conditioning at the end of separation lasts for 30 min. The method is successfully applied to quantify the major intracellular dissolved free amino acids in the marine microalgae Tetraselmis gracilis, Phaeodactium tricornutum, and Synechococcus elongatus.

Evaluation of flow injection analysis method with spectrophotometric detection for the determination of atrazine in soil extracts

A method for determining atrazine in soil extracts was evaluated by flow injection analysis with spectrophotometric detection. The method is based on the reaction of atrazine with pyridine in an acid medium followed by the reaction with NaOH and sulfanilic acid. Several analytical conditions were previously studied and optimized. Under the best conditions of analysis, the limits of detection and quantification were 0.15 and 0.45 mg L(-1), respectively, for a linear response between 0.50 and 2.50 mg L(-1), and a sampling throughput of 21 determinations per hour. Using the standard addition method, the maximum relative standard deviation of 17% and recovery values between 80 and 100% were observed for three extracts from soil samples with different composition. The proposed method is simple, low-cost and easy to use, and can be employed for studies involving atrazine in soil samples or for screening of atrazine in soils.