Preparation of monodisperse porous poly(glycidylmethacrylate-co-ethylenedimethacrylate) microspheres and their application as stationary phase for superheated water HPLC

Exploring the green frontier: Subcritical water chromatography for sustainable analytical practices

Water in the subcritical state is characterized by properties significantly different from water under standard conditions. These include low viscosity, low surface tension, and a much lower dielectric constant, increasing the solubility of nonpolar substances. For this reason, it can provide an alternative solvent and be used in chromatographic techniques-subcritical water chromatography (SBWC). SBWC appears to be one of the greenest analytical techniques until we unravel chromatography with pure water at room temperature. The versatility of SBWC is explored through its applications in the separation and analysis of a wide range of compounds, including pharmaceuticals, natural products, etc. The use of subcritical water as a mobile phase requires suitable stable stationary phases and special apparatus. Still, it makes it possible to conduct analyses without using organic solvents. When using this technique, it is important to remember that it suits the analysis of thermally stable substances. The following work is a critical review of developments in SBWC.

Underivatized Amino Acid Chromatographic Separation: Optimized Conditions for HPLC-UV Simultaneous Quantification of Isoleucine, Leucine, Lysine, Threonine, Histidine, Valine, Methionine, Phenylalanine, Tryptophan, and Tyrosine in Dietary Supplements

Amino acids (AAs) are considered as the building blocks of life. Unlike nonessential AAs, the human body cannot synthesize essential AAs and should be supplied in food or dietary supplements. The aim of the work is simultaneous HPLC-UV determination of 10 structurally related AAs without pre- or postderivatization in powdered dietary supplements (PDSs). This was challenging, especially because PDS has no standardized procedures for its quality control. HPLC-UV chromatograms of the 10 AAs were recorded using a gradient elution of the mobile phase on a CLC-C18 column at 225 nm. The elution started with 100% of phosphate buffer (pH 7.4, 10 mM) for 10 min; then, the concentration of acetonitrile increased linearly to reach 50% for another 15 min at room temperature. Good separation was achieved within a 25 min run time without pre- or postderivatization. The method was carefully validated according to the ICH guidelines over the linearity range of 100-200, 50-200, 20-150, 50-400, 20-250, 75-175, 50-250, 50-250, 50-300, and 5-100 μg/mL for l-lysine, l-threonine, l-histidine, l-valine, l-methionine, l-isoleucine, l-leucine, l-tyrosine, l-phenylalanine, and l-tryptophan, respectively, with mean recoveries ranges between 98.91 and 100.77. The method was found to be precise, and the relative standard deviation (RSD) was found to be between 0.28 and 1.92 with recoveries between 97.91 and 101.11. The method was found to be robust that resists deliberate changes in pH, flow rate, and mobile-phase percentages. It was successfully applied for the analysis of PDSs. The proposed method could be very useful for the quality control of the 10 structurally related AAs during their synthesis and for testing raw materials and pharmaceutical preparations.

The Novel Polymethacrylate Based Hydrophilic Stationary Phase for Ion Chromatography

Ion chromatography is widely used as a useful and powerful tool for the analysis of anionic and cationic components found in waters and aqueous media. The performance and selectivity of ion chromatography are based on the stationary phase column packed material. In this study, it is aimed to develop new column material with quaternary ammonium functional group based on monodisperse polymeric particles for ion chromatography and to investigate their chromatographic performance. For the analysis of inorganic anions by ion chromatography, new stationary phases macroporous monodisperse particles based on 3-chloro-2-hydroxy propylmethacrylate-co-ethylene dimethacrylate are obtained as column packing material. 3-chloro-2-hydroxy propylmethacrylate and ethylene glycol dimethacrylate are transformed to porous monodisperse particle form by using glycidyl methacrylate as the seed latex and ethyl benzene as the porogen solvent via micro-suspension polymerization technique. Then macroporous monodisperse particles surface is functionalized by triethylamine so strong anion exchange is obtained for ion chromatography packing material. A series of stationary phases prepared from polymer particles containing different amounts of porogen solvent were tested. The results show that column packing material is successful to separate inorganic anions mixture such as F−, Cl−, NO2−, Br−, NO3− by using the carbonate and bicarbonate solutions as mobile phases.

Rational Design of Pore Parameters in Monodisperse Porous Poly(glycidyl methacrylate-co-ethylene glycol dimethacrylate) Particles Based on Response Surface Methodology

Monodisperse porous poly(glycidyl methacrylate-co–ethylene glycol dimethacrylate) particles are widely applied in different fields, as their pore properties can be influenced and functionalization of the epoxy group is versatile. However, the adjustment of parameters which control morphology and pore properties such as pore volume, pore size and specific surface area is scarcely available. In this work, the effects of the process factors monomer:porogen ratio, GMA:EDMA ratio and composition of the porogen mixture on the response variables pore volume, pore size and specific surface area are investigated using a face centered central composite design. Non-linear effects of the process factors and second order interaction effects between them were identified. Despite the complex interplay of the process factors, targeted control of the pore properties was possible. For each response a response surface model was derived with high predictive power (all R2predicted > 0.85). All models were tested by four external validation experiments and their validity and predictive power was demonstrated.

Stationary Phases for Green Liquid Chromatography

Industrial research, including pharmaceutical research, is increasingly using liquid chromatography techniques. This involves the production of large quantities of hazardous and toxic organic waste. Therefore, it is essential at this point to focus interest on solutions proposed by so-called “green chemistry”. One such solution is the search for new methods or the use of new materials that will reduce waste. One of the most promising ideas is to perform chromatographic separation using pure water, without organic solvents, as a mobile phase. Such an approach requires novel stationary phases or specific chromatographic conditions, such as an elevated separation temperature. The following review paper aims to gather information on stationary phases used for separation under purely aqueous conditions at various temperatures.

A review of the design of packing materials for ion chromatography

The development of ion chromatography has made remarkable progress in the past few decades, and it is now widely used for the analysis of common ions and organic compounds. Ion chromatography has many advantages, such as fast, high sensitivity, good selectivity and support for simultaneous analysis of multiple ionic compounds. In order to meet the high requirements of material analysis, new packing materials for ion chromatography with higher sensitivity and selectivity have been developed. In this paper, a lot of knowledge of ion chromatography is reviewed, and the development of ion chromatographic packings in recent years, especially in the last five years, is summarized.

Studies on Preparation, Characterization and Application of Porous Functionalized Glycidyl Methacrylate-Based Microspheres

A one-step swelling and polymerization technique was used in the synthesis of porous glycidyl methacrylate (GMA) and ethylene glycol dimethacrylate (EGDMA) monodisperse polymeric microspheres. The polystyrene (PS) seed obtained in the dispersion polymerization was used as a shape template. The presence of epoxide rings in the chemical structure of microspheres enables their post-polymerization chemical modifications involving: the Diels-Alder reaction with sodium cyclopentadienide and maleic anhydride, the reaction with 4,4′-(bismaleimido)diphenylmethane, and the thiol-Michael reaction with methacryloyl chloride and 2-mercaptopropionic acid. Changing the reaction mixture composition—the amounts of crosslinking monomer and PS seed as well as the type and concentration of porogen porous microspheres of different porous structures were obtained. Their porous structures were characterized in the dry and swollen states. The copolymers obtained from the equimolar monomers mixture modified in the above way were applied as the column packing materials and tested in the reverse-phase HPLC (High-Performance Liquid Chromatography). A few factors influencing morphology and porous structure of microspheres were studied.

Microporous poly(glycidyl methacrylate-co-ethylene glycol dimethyl acrylate) microspheres: synthesis, functionalization and applications

As a new kind of functional material, micron-sized porous polymer microspheres are a hot research topic in the field of polymer materials.

Stability and Extraction of Vanillin and Coumarin under Subcritical Water Conditions

In order to facilitate the development of the green subcritical water chromatography technique for vanillin and coumarin, the stability of the compounds under subcritical water conditions was investigated in this work. In addition, their extraction from natural products was also studied. The stability experiments were carried out by heating the mixtures of vanillin and water or coumarin and water at temperatures ranging from 100 °C to 250 °C, while subcritical water extractions (SBWE) of both analytes from vanilla beans and whole tonka beans were conducted at 100 °C to 200 °C. Analyte quantification for both stability and extraction studies was carried out by HPLC. After heating for 60 min, vanillin was found to be stable in water at temperatures up to 250 °C. While coumarin is also stable at lower temperatures such as 100 °C and 150 °C, it undergoes partial degradation after heating for 60 min at 200 °C and higher. The results of this stability study support green subcritical water chromatographic separation and extraction of vanillin and coumarin at temperatures up to 150 °C. The SBWE results revealed that the extraction efficiency of both analytes from vanilla beans and tonka beans is significantly improved with increasing temperature.

Preparation of the monodispersed carboxyl-functionalized polymer microspheres with disproportionated rosin moiety and adsorption of methylene blue

Carboxyl-functionalized polymer microspheres with a rosin moiety were prepared through dispersion polymerization using styrene, disproportionated rosin ester, and methylacrylic acid as raw materials. The effects of dispersion medium (ethanol/water) ratio, monomer mass proportion and initiator concentration on the polymer microspheres were studied. Scanning electron microscopy, laser particle size analysis, thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the microspheres, and their carboxyl contents were determined by the conductance titration method. The adsorption of methylene blue of the microspheres was also investigated. The results showed that rosin-based carboxyl-functionalized polymer microspheres were successfully synthesized. The microspheres exhibited smooth, spherical shapes with good monodispersity and high thermal stability. The carboxyl content of the microspheres prepared under optimum conditions was 0.089 mmol·g−1, with the average particle size approximately 950 nm. With increasing carboxyl contents of the polymer microspheres, their methylene blue adsorption capacities increased. The maximum methylene blue adsorption capacity of the microspheres was 59.55 mg·g−1 in the highest carboxyl content.

Diazoresin modified monodisperse porous poly(glycidylmethacrylate-co-divinylbenzene) microspheres as the stationary phase for high performance liquid chromatography

Diazoresin modified monodisperse porous PGMA–DVB microspheres were used as a novel tool for the separation and purification of the N-vinyl-1,2,4-triazole product from its by-product was developed.