PVDF–ErGO–GRC electrode: A single setup electrochemical system for separation, pre-concentration and detection of lead ions in complex aqueous samples

Environmental Applications of Electromembrane Extraction: A Review

Electromembrane extraction (EME) is a miniaturized extraction technique that has been widely used in recent years for the analysis and removal of pollutants in the environment. It is based on electrokinetic migration across a supported liquid membrane (SLM) under the influence of an external electrical field between two aqueous compartments. Based on the features of the SLM and the electrical field, EME offers quick extraction, effective sample clean-up, and good selectivity, and limits the amount of organic solvent used per sample to a few microliters. In this paper, the basic devices (membrane materials and types of organic solvents) and influencing factors of EME are first introduced, and the applications of EME in the analysis and removal of environmental inorganic ions and organic pollutants are systematically reviewed. An outlook on the future development of EME for environmental applications is also given.

Sensitive Metal Oxide-Clay Nanocomposite Colorimetric Sensor Development for Aflatoxin Detection in Foods: Corn and Almond

The work reports on zinc oxide bentonite nanocomposite (ZnOBt) chemical route synthesis, characterization, and investigation of curcumin (Cur) functionalization for a label-free colorimetric detection of total aflatoxins (AFs) in foods. XRD of ZnO nanoparticles (NPs) confirmed the wurtzite structure (2θ = 36.2°) and that of ZnOBt showed the intercalated interlayer composite phase. The Debye-Scherrer relation calculated the crystallite size as 20 nm (ZnO) and 24.4 nm (ZnOBt). Surface morphology by SEM exhibited flower-like hexagonal, rod-shaped ZnO NPs on the bentonite surface. Colorimetric reaction involved two-stage redox reactions between ZnOBt and dye Cur followed by AFs phenolic group and Zn(Cur)OBt. Cur gets oxidized at its diketone moiety in the presence of ZnOBt to form a red colored complex Zn(Cur)OBt, which further scavenge protons from AFs phenolic group, and gets oxidized to AFs-Zn(Cur)OBt (yellow). Binding of AFs-Zn(Cur)OBt is characterized by FT-IR ascribed to C-H bending (1966.615 cm-1), O-H stretching (3256.974 cm-1), and C=O stretching (1647.362 cm-1). 1H NMR chemical shifts (δ) (ppm) showed an increase in proton at the aliphatic region (0 to 4.4) while removal of proton in ether at 4.4 to 6 regions. Job plot calculation using UV-Vis data resulted in a higher total AF binding coefficient of Zn(Cur)OBt (K a = 3.77 × 106 mol-1 L) compared to Zn(Cur)O (K a = 0.645 × 106 mol-1 L) as well as a molar ratio of 1:1 by the Benesi-Hildebrand plot equation. Corn and almond food samples showed the total AFs LOD of 2.74 and 4.34 ppb, respectively. The results are validated with standard LC/MS-MS in compliance with MRL value as per the regulatory standard (EU).The NP-based method is facile and rapid and hence can be utilized for onsite detection of total AFs in foods.

Role of nanocatalyst in the treatment of organochlorine compounds - A review

Since a few centuries ago, organochlorine compounds (OCs) become one of the threatened contaminants in the world. Due to the lipophilic and hydrophobic properties, OCs always discover in fat or lipid layers through bioaccumulation and biomagnification. The OCs are able to retain in soil, sediment and water for long time as it is volatile, OCs will evaporate from soil and condense in water easily and frequently, which pollute the shelter of aquatic life and it affects the function of organs and damage system in human body. Photocatalysis that employs the usage of semiconductor nanophotocatalyst and solar energy can be the possible alternative for current conventional water remediation technologies. With the benefits of utilizing renewable energy, no production of harmful by-products and easy operation, degradation of organic pollutants in rural water bodies can be established. Besides, nanophotocatalyst that is synthesized with nanotechnology outnumbered conventional catalyst with larger surface area to volume ratio, thus higher photocatalytic activity is observed. In contrast, disadvantages particularly no residual effect in water distribution network, requirement of post-treatment and easily affected by various factors accompanied with photocatalysis method cannot be ignored. These various factors constrained the photocatalytic efficiency via nanocatalysts which causes the full capacity of solar photocatalysis has yet to be put into practice. Therefore, further modifications and research are still required in nanophotocatalysts' synthesis to overcome limitations such as large band gaps and photodecontamination.

Occurrence, interactive effects and ecological risk of diclofenac in environmental compartments and biota - a review

Diclofenac, a nonsteroidal anti-inflammatory drug has turned into a contaminant of emerging concern; hence, it was included in the previous Watch List of the EU Water Framework Directive. This review paper aims to highlight the metabolism of diclofenac at different trophic levels, its occurrence, ecological risks, and interactive effects in the water cycle and biota over the past two decades. Increased exposure to diclofenac not only raises health concerns for vultures, aquatic organisms, and higher plants but also causes serious threats to mammals. The ubiquitous nature of diclofenac in surface water (river, lake canal, estuary, and sea) is compared with drinking water, groundwater, and wastewater effluent in the environment. This comprehensive survey from previous studies suggests the fate of diclofenac in wastewater treatment plants (WWTPs) and may predict its persistence in the environment. This review offers evidence of fragmentary available data for the water environment, soil, sediment, and biota worldwide and supports the need for further data to address the risks associated with the presence of diclofenac in the environment. Finally, we suggest that the presence of diclofenac and its metabolites in the environment may represent a high risk because of their synergistic interactions with existing contaminants, leading to the development of drug-resistant strains and the formation of newly emerging pollutants.

Heavy metal pollution in immobile and mobile components of lentic ecosystems-a review

With growing population and urbanization, there is an increasing exploitation of natural resources, and this often results to environmental pollution. In this review, the levels of heavy metal in lentic compartments (water, sediment, fishes, and aquatic plants) over the past two decades (1997-2017) have been summarized to evaluate the current pollution status of this ecosystem. In all the compartments, the heavy metals dominated are zinc followed by iron. The major reason could be area mineralogy and lithogenic sources. Enormous quantity of metals like iron in estuarine sediment is a very natural incident due to the permanently reducing condition of organic substances. Contamination of cadmium, lead, and chromium was closely associated with anthropogenic origin. In addition, surrounding land use and atmospheric deposition could have been responsible for substantial pollution. The accumulation of heavy metals in fishes and aquatic plants is the result of time-dependent deposition in lentic ecosystems. Moreover, various potential risk assessment methods for heavy metals were discussed. This review concludes that natural phenomena dominate the accumulation of essential heavy metals in lentic ecosystems compared to anthropogenic sources. Amongst other recent reviews on heavy metals from other parts of the world, the present review is executed in such a way that it explains the presence of heavy metals not only in water environment, but also in the whole of the lentic system comprising sediment, fishes, and aquatic plants.