Cobalt internal standard for Ni to assist the simultaneous determination of Mo and Ni in plant materials by high-resolution continuum source graphite furnace atomic absorption spectrometry employing direct solid sample analysis

Investigating the Discoloration of Leaves of Dioscorea polystachya Using Developed Atomic Absorption Spectrometry Methods for Manganese and Molybdenum

The Chinese yam (Dioscorea polystachya, DP) is promising for the food and pharmaceutical industries due to its nutritional value and pharmaceutical potential. Its proper cultivation is therefore of interest. An insufficient supply of minerals necessary for plant growth can be manifested by discoloration of the leaves. In our earlier study, magnesium deficiency was excluded as a cause. As a follow-up, this work focused on manganese and molybdenum. To quantify both minerals in leaf extracts of DP, analytical methods based on atomic absorption spectrometry (AAS) using the graphite furnace sub-technique were devised. The development revealed that the quantification of manganese works best without using any of the investigated modifiers. The optimized pyrolysis and atomization temperatures were 1300 °C and 1800 °C, respectively. For the analysis of molybdenum, calcium proved to be advantageous as a modifier. The optimum temperatures were 1900 °C and 2800 °C, respectively. Both methods showed satisfactory linearity for analysis. Thus, they were applied to quantify extracts from normal and discolored leaves of DP concerning the two minerals. It was found that discolored leaves had higher manganese levels and a lower molybdenum content. With these results, a potential explanation for the discoloration could be found.

The use of dried matrix spot for determination of Pb and Ni in automotive gasoline by solid sampling high-resolution continuum source graphite furnace atomic absorption spectrometry

In this work a simple and practical method for the determination of Pb and Ni in automotive gasoline by solid sampling high-resolution continuum source graphite furnace atomic absorption spectrometry was investigated. In the proposed method, disks of filter paper were used to pre-concentrate and store Pb, Ni and other trace elements from automotive gasoline samples. For this, a volume of sample was deposited and dried out on a filter paper disk previously adapted into a polytetrafluoroethylene mold, and then the gasoline-embedded filter paper was either cut into small pieces or pulverised and introduced directly into the graphite furnace for trace element determination. Temperature program, use of chemical modifier, chromatographic effect and volume of sample were investigated. Calibration curves using organic and inorganic standards of the analytes as well as external and internal calibration methods were evaluated. Using optimised conditions, characteristic masses and limits of detection of 6 and 11 pg, and 0.5 and 2.1 μg L^-1 were found for Pb and Ni, respectively. The accuracy of the method was evaluated with spike-recovery tests and a certified reference material of wear lubricant oil. The spike-recovery tests were accomplished for 9 samples and the best results were obtained with the pulverised filter paper. A second method that employs a transversely heated filter atomiser was applied as a comparative one. The filter paper was shown to be a simple and inexpensive tool for storage and transportation of gasoline samples, and it allowed the pre-concentration of the analytes, since a larger volume of sample can be dried out on it.

Traditional Calibration Methods in Atomic Spectrometry and New Calibration Strategies for Inductively Coupled Plasma Mass Spectrometry

Applications, advantages, and limitations of the traditional external standard calibration, matrix-matched calibration, internal standardization, and standard additions, as well as the non-traditional interference standard method, standard dilution analysis, multi-isotope calibration, and multispecies calibration methods are discussed.