Fluorescence chemical sensor for determining trace levels of nitroaromatic explosives in water based on conjugated polymer with guanidinium side groups

Selective Supramolecular Recognition of Nitroaromatics by a Fluorescent Metal-Organic Cage Based on a Pyridine-Decorated Dibenzodiaza-Crown Macrocyclic Co(II) Complex

Two isomorphous fluorescent (FL) lantern-shaped metal-organic cages 1 and 2 were prepared by coordination-directed self-assembly of Co(II) centers with a new aza-crown macrocyclic ligand bearing pyridine pendant arms (L_py). The cage structures were determined using single-crystal X-ray diffraction analysis, thermogravimetric, elemental microanalysis, FT-IR spectroscopy, and powder X-ray diffraction. The crystal structures of 1 and 2 show that anions (Cl^- in 1 and Br^- in 2) are encapsulated within the cage cavity. 1 and 2 bear two coordinated water molecules that are directed inside the cages, surrounded by the eight pyridine rings at the "bottom" and the "roof" of the cage. These hydrogen bond donors, π systems, and the cationic nature of the cages enable 1 and 2 to encapsulate the anions. FL experiments revealed that 1 could detect nitroaromatic compounds by exhibiting selective and sensitive fluorescence quenching toward p-nitroaniline (PNA), recommending a limit of detection of 4.24 ppm. Moreover, the addition of 50 μL of PNA and o-nitrophenol to the ethanolic suspension of 1 led to a significant large FL red shift, namely, 87 and 24 nm, respectively, which were significantly higher than the corresponding values observed in the presence of other nitroaromatic compounds. The titration of the ethanolic suspension of 1, with various concentrations of PNA (>12 μM) demonstrated a concentration-dependent emission red shift. Hence, the efficient FL quenching of 1 was capable of distinguishing the dinitrobenzene isomers. Meanwhile, the observed red shift (10 nm) and quenching of this emission band under the influence of a trace amount of o- and p-nitrophenol isomers also showed that 1 could discriminate between o- and p-nitrophenol. Replacement of the chlorido with a bromido ligand in 1 generated cage 2 which was a more electron-donating cage than 1. The FL experiments showed that 2 was partially more sensitive and less selective toward NACs than 1.

A Poly(carbazole-alt-triazole) with Thiabendazole Side Groups as an "On-Off-On" Fluorescent Probe for Detection of Cu(II) Ion and Cysteine

A novel conjugated polymer PCZBTA-TBZ containing thiabendazole as recognition unit was synthesized via Suzuki coupling reaction, and its structural characterization, spectroscopic analysis and photophysical properties were investigated. In the metal ion response study, the addition of Cu²⁺ led to the occurrence of the photoinduced electron transfer (PET) mechanism, which significantly quenched the fluorescence of the polymer PCZBTA-TBZ with a quenching effect of 98%. Furthermore, I^- can significantly quench the fluorescence of the polymer, but other anions have no such effect. According to the density functional theory calculation, compared with other polycarbazoles or other alternative copolymers containing carbazole, with alternating carbazole and triazole enhances the electron mobility and reduces the energy band gap of the polymer. Due to the strong coordination ability between Cu²⁺ and Cys, the adding Cys competes the Cu²⁺ in the [PCZBTA-TBZ-Cu²⁺] complex, blocking the occurrence of PET, and the fluorescence intensity of PCZBTA-TBZ is restored. The addition of other amino acids caused almost no change. The polymer is expected to be used for dual fluorescence detection of specific metal ions and Cys.

Influence of Air Flow on Luminescence Quenching in Polymer Films towards Explosives Detection Using Drones

Explosive detection has become an increased priority in recent years for homeland security and counter-terrorism applications. Although drones may not be able to pinpoint the exact location of the landmines and explosives, the identification of the explosive vapor present in the surrounding air provides significant information and comfort to the personnel and explosives removal equipment operators. Several optical methods, such as the luminescence quenching of fluorescent polymers, have been used for explosive detection. In order to utilize sensing technique via unmanned vehicles or drones, it is very important to study how the air flow affects the luminescence quenching. We investigated the effects of air flow on the quenching efficiency of Poly(2,5-di(2′-ethylhexyl)-1,4-ethynylene) (PEE) by TNT molecules. We treated the TNT molecules incorporated into the polymer film as non-radiative recombination centers, and found that the time derivative of the non-radiative recombination rates was greater with faster air flows. Our investigations show that relatively high air flow into an optical sensing part is crucial to achieving fast PL quenching. We also found that a “continuous light excitation” condition during the exposure of TNT vapor greatly influences the PL quenching.

Interpol review of detection and characterization of explosives and explosives residues 2016-2019

This review paper covers the forensic-relevant literature for the analysis and detection of explosives and explosives residues from 2016-2019 as a part of the 19th Interpol International Forensic Science Managers Symposium. The review papers are also available at the Interpol website at: https://www.interpol.int/Resources/Documents#Publications.

Comparative Study on the Effect of Protonation Control for Resistive Gas Sensor Based on Close-Packed Polypyrrole Nanoparticles

Conducting polymers are often used as sensor electrodes due to their conjugated chain structure, which leads to high sensitivity and rapid response at room temperature. Numerous studies have been conducted on the structures of conducting polymer nanomaterials to increase the active surface area for the target materials. However, studies on the control of the chemical state of conducting polymer chains and the modification of the sensing signal transfer with these changes have not been reported. In this work, polypyrrole nanoparticles (PPyNPs), where is PPy is a conducting polymer, are applied as a sensor transducer to analyze the chemical sensing ability of the electrode. In particular, the protonation of PPy is adjusted by chemical methods to modify the transfer sensing signals with changes in the polymer chain structure. The PPyNPs that were modified at pH 1 exhibit high sensitivity to the target analyte (down to 1 ppb of NH3) with short response and recovery times of less than 20 s and 50 s, respectively, at 25 °C.

A recyclable fluorescent probe for picric acid detection in water samples based on inner filter effect

1-Aminopyrene@ZIF-8 composite was synthesized as the fluorescent probe for picric acid (PA) based on inner filter effect. The probe displayed selective response toward PA within 10s, and a linear range was obtained from 1 to 150μM with detection limit of 0.3μM, which is much lower than the permissible level of PA in drinking water reservoir (0.5mgL^-1/2.2μM) set by China's State Environmental Protection Administration (GB3838-2002). Most importantly, the probe possessed excellent recyclability and could be recycled for at least six times. It was further applied to the detection of PA in water samples, and satisfactory recoveries were obtained in the range of 96.0-104.0%.

A Conjugated Polymer Fluorescent Sensor for Continuous Identification of Copper(II) and Pyrophosphate in Blood Serum and Synovial Fluid

A novel "on-off-on" super-sensitive conjugated polymer fluorescence sensor (PPE-DPA) was developed and it was applied to realize the continuous recognition of Cu²⁺ and pyrophosphate (PPi). The fluorescence intensity decreased linearly with the change of Cu²⁺ from 0.05 to 5.0 μmol L^-1 and the limit of detection was 24 nmol L^-1. The fluorescence intensity was linearly enhanced with the increase of PPi from 0.5 to 12.0 μmol L^-1 and the limit of detection was 230 nmol L^-1. In addition, this method was applied to detect PPi in the blood serum and synovial fluid of patients with arthritis and satisfactory results were obtained. Thus, the PPE-DPA is not only an effective tool for detecting Cu²⁺ and PPi in samples, but also presents a potential way to diagnose arthritis.

A silicon-cored tetraphenyl benzene derivative with aggregation-induced emission enhancement as a fluorescent probe for nitroaromatic compounds detection

Two benzene with multiple contiguous phenyl substituent derivatives, namely, 1, 2, 3, 4-tetraphenyl benzene (TPB) and bis(1,2,3,4-tetraphenylbenzene-yl) diphenylsilane (TPB-Si), were synthesized by the Knoevenagel/Diels-Alder method. TPB and TPB-Si both showed aggregation-induced emission enhancement (AIEE) properties in tetrahydrofuran/water mixtures. The fluorescence-quenching behaviors of the two compounds with different nitroaromatic compounds were also investigated. TPB and TPB-Si both showed low detection limit, high sensitivity, and high quenching efficiency in detecting nitroaromatic compounds. Furthermore, the two compounds in aggregate state exhibited much better detection abilities than in THF solution. And TPB-Si exhibited better detection ability than TPB in both solution and aggregate state. The reason could be attributed to the special tetrahedral molecular structure of TPB-Si, which was demonstrated by theoretical calculations and crystal structures. Moreover, TPB-Si in solid film also exhibited excellent detection performance to nitroaromatic explosive vapor. This work may serve as a basis for designing new organic materials with great efficiency and sensitivity in fluorescence detection.

A silicone polymer modified by fluoranthene groups as a new approach for detecting nitroaromatic compounds

In this work, fluoranthene-modified polysiloxane (FMPS) was synthesized via the Diels–Alder reaction.

The development of unimolecular conjugated polymeric micelles for the highly selective detection and recovery of gold from electronic waste

Gold recycling is a sustainable development strategy that will save a large amount of carbon dioxide emissions. In this work, we have developed a conjugated polymer, that can not only detect Au content in e-waste but also extract Au from e-waste.