Near-infrared fluorescent nanoprobes for highly sensitive cyanide quantification in natural waters

Spectroscopic and Theoretical Studies on the Selective Detection of Cyanide Ions by a Turn-On Fluorescent Chemo-Dosimeter and its Application in Living Cell Imaging

A new chemo-dosimeter AK4 containing quinoline fluorophore has rationally been designed, synthesised and characterized using 1H and 13C NMR and mass spectral techniques. The probe senses explicitly CN- ion through a dramatic enhancement in fluorescence over other commonly coexistent anions in H2O:DMSO (9:1 v/v) medium over a broad pH range (4-10). 1H NMR titration revealed the deprotonation followed by nucleophilic addition reaction of CN-, which was supported by 13C NMR and mass spectral examinations. The Job's continuous variation method indicated the formation of a 1:1 adduct between AK4 and CN- with a binding constant of 1.62 × 104 M-1. A limit of detection (LOD) towards CN- of 0.69 µM has been determined, which is much lower than the World Health Organization (WHO) recommended limit of CN- in drinking water (1.9 µM). The changes in the optical properties of AK4 upon reaction with CN- were delineated using Density Functional Theory (DFT) and Time-Dependent Density Functional Theory (TD-DFT) calculations. Moreover, fluorescence microscopic studies established that AK4 could be an effective probe for imaging intracellular CN- in HeLa cells.

Determination of cyanide based on a dual-emission ratiometric nanoprobe using silver sulfide quantum dots and silicon nanoparticles

A novel ratiometric fluorescent nanoprobe was designed for the sensitive determination of cyanide anion (CN^-) by the electrostatic attraction between positively charged silicon nanoparticles (Si NPs) and negatively charged silver sulfide quantum dots (Ag₂S QDs). The nanoprobe exhibited two well-resolved emission peaks at 446 nm and 540 nm under a single excitation wavelength (360 nm). In the presence of CN^-, the fluorescence of Ag₂S QDs at 540 nm was remarkably quenched, while the fluorescence of the Si NPs at 446 nm remained constant, establishing the desired conditions for ratiometric fluorescence detection. Under optimal conditions, the ratiometric fluorescence assay showed good linearity (R² = 0.9921) within the range 0.05-15 μM, and the limit of detection was calculated to be 56 nM (at an S/N ratio of 3). The proposed Ag₂S QD/Si NP nanoprobe has been successfully used to determine CN^- in water and sprouting potato samples with satisfactory recoveries in the range 97-110.5%.

A salicylaldehyde benzoyl hydrazone based near-infrared probe for copper(ii) and its bioimaging applications

Developing highly sensitive and selective methods for Cu²⁺ detection in living systems is of great significance in clinical copper-related disease diagnosis. In this work, a near infrared (NIR) fluorescent probe, CySBH, with a salicylaldehyde benzoyl hydrazone group as a selective and sensitive receptor for Cu²⁺ was designed and synthesized. The specific coordination of the salicylaldehyde benzoyl hydrazone group in CySBH with Cu²⁺ can induce a distinct quench of the fluorescence intensity, allowing for real-time tracking of Cu²⁺. We have demonstrated that CySBH could rapidly recognize Cu²⁺ with good selectivity and high sensitivity. Moreover, on the basis of low cell cytotoxicity, the probe was used to visualize Cu²⁺ in two cell lines by fluorescence imaging. Furthermore, CySBH can also be used to monitor Cu²⁺in vivo due to its NIR emission properties. These overall results illustrate that the NIR fluorescent probe CySBH provides a novel approach for the selective and sensitive monitoring of Cu²⁺ in living systems.

A near infrared fluorescent probe utilizing the salicylaldehyde benzoyl hydrazone group as the Cu²⁺ receptor was developed and used to selectively and sensitively monitor Cu²⁺ in living systems.

Photoluminescent Nanoparticles for Chemical and Biological Analysis and Imaging

Research related to the development and application of luminescent nanoparticles (LNPs) for chemical and biological analysis and imaging is flourishing. Novel materials and new applications continue to be reported after two decades of research. This review provides a comprehensive and heuristic overview of this field. It is targeted to both newcomers and experts who are interested in a critical assessment of LNP materials, their properties, strengths and weaknesses, and prospective applications. Numerous LNP materials are cataloged by fundamental descriptions of their chemical identities and physical morphology, quantitative photoluminescence (PL) properties, PL mechanisms, and surface chemistry. These materials include various semiconductor quantum dots, carbon nanotubes, graphene derivatives, carbon dots, nanodiamonds, luminescent metal nanoclusters, lanthanide-doped upconversion nanoparticles and downshifting nanoparticles, triplet-triplet annihilation nanoparticles, persistent-luminescence nanoparticles, conjugated polymer nanoparticles and semiconducting polymer dots, multi-nanoparticle assemblies, and doped and labeled nanoparticles, including but not limited to those based on polymers and silica. As an exercise in the critical assessment of LNP properties, these materials are ranked by several application-related functional criteria. Additional sections highlight recent examples of advances in chemical and biological analysis, point-of-care diagnostics, and cellular, tissue, and in vivo imaging and theranostics. These examples are drawn from the recent literature and organized by both LNP material and the particular properties that are leveraged to an advantage. Finally, a perspective on what comes next for the field is offered.

Electrochemical quantification of Ag2S quantum dots: evaluation of different surface coating ligands for bacteria determination

In this work, novel silver sulphide quantum dots (Ag₂S QD) are electrochemically quantified for the first time. The method is based on the electrochemical reduction of Ag⁺ to Ag⁰ at -0.3 V on screen-printed carbon electrodes (SPCEs), followed by anodic stripping voltammetric oxidation that gives a peak of currents at +0.06 V which represents the analytical signal. The optimized methodology allows the quantification of water-stabilized Ag₂S QD in the range of approximately 2 × 10⁹-2 × 10¹² QD·mL^-1 with a good reproducibility (RSD: 5%). Moreover, as proof-of-concept of relevant biosensing application, Ag₂S QD are evaluated as tags for Escherichia coli (E. coli) bacteria determination. Bacteria tagged with QD are separated by centrifugation from the sample solution and placed on the SPCE surface for quantitative analysis. The effect of two different Ag₂S QD surface coating/stabilizing agents on both the voltammetric response and the bacteria sensing is also evaluated. 3-mercaptopropionic acid (3-MPA) is studied as model of short length coating ligand with no affinity for the bacteria, while boronic acid (BA) is evaluated as longer length ligand with chemical affinity for the polysaccharides present in the peptidoglycan layer on the bacteria cells surface. The biosensing system allows to detect bacteria in the range 10^-1-10³ bacteria·mL^-1 with a limit of detection as low as 1 bacteria·mL^-1. This methodology is a promising proof-of-concept alternative to traditional laboratory-based tests, with good sensitivity and short time and low cost of analysis. Graphical abstractNovel silver sulphide quantum dots (Ag₂S QD) are electrochemically quantified for the first time. Moreover, Ag₂S QD are evaluated as tags for Escherichia coli bacteria determination. The effect of two different QD surface coating ligands is also evaluated.

CdSe quantum dots-sensitized chemiluminescence system and quenching effect of gold nanoclusters for cyanide detection

An efficient chemiluminescence resonance energy transfer (CRET) induced chemiluminescence (CL) system was developed for the sensitive determination of cyanide ion (CN^-) in environmental and biological samples. The selected CL reaction was hydrogen peroxide (H₂O₂)-bicarbonate (HCO₃^-) system with an ultra-weak emission at about 470 nm. It was found that glutathione-stabilized CdSe quantum dots (CdSe QDs) superbly increase the obtained CL intensity. The high performance CRET between the CL emitters and CdSe QDs with a broad absorption was mainly responsible for the observed improving effect. The absorption spectrum of QDs completely overlaps with the CL emission wavelength of H₂O₂-HCO₃^- system. Besides, CdSe QDs could also catalyze the CL reaction of H₂O₂-HCO₃^-, efficiently. On the other hand, it was observed that the gold nanoclusters (Au NCs) could prohibit the CRET system and turn off the CL emission. This diminishing effect can be useful for the analytical application. Herein, it was successfully exploited for the selective recognition of CN^-, using its leaching effect on Au NCs. After efficient dissolution of NCs, the CRET to CdSe QDs restored and the CL emission was again turned on. This strategy resulted in a high sensitive and reliable measurement of CN^- in the concentration range of 2-225 nM, with a detection limit of 0.46 nM.

A novel dithiourea-appended naphthalimide "on-off" fluorescent probe for detecting Hg2+ and Ag+ and its application in cell imaging

An effective dithiourea-appended 1,8-naphthalimide fluorescent probe was designed and synthesized. This probe could recognize Hg²⁺ and Ag⁺ sensitively and selectively in neutral and alkaline conditions. Moreover, the probe detected Hg²⁺ alone at pH between 2 and 6. The sensing ability of the probe was explored by UV-vis, fluorescence, FTIR and ¹H NMR spectroscopy. The probe was quenched by Hg²⁺ and Ag⁺ with 1:1 binding ratios in MeCN/H₂O (4/1, v/v) mixed solution with binding constants of 3.76 × 10⁴ L mol^-1 and 2.47 × 10⁴ L mol^-1, respectively. The linear concentration ranges for Hg²⁺ and Ag⁺ were 0-17 μmol L^-1 and 0-24 μmol L^-1 with detection limits of 0.83 μmol L^-1 and 1.20 μmol L^-1, respectively, which allowed for the quantitative determination of Hg²⁺ and Ag⁺. The new probe, 3a, was successfully applied to the fluorescence imaging of Hg²⁺ and Ag⁺ in HepG2 cells, demonstrating its potential application in biological science. Moreover, 3a was used to measure Hg²⁺ and Ag⁺ in tap water, drinking water and ultrapure water samples. The recoveries of Hg²⁺ and Ag⁺ in water samples were 96-99% and 98-103%, respectively. Therefore, the proposed method showed promising perspectives for its application, aimed at detecting Hg²⁺ and Ag⁺ in fluorescence imaging and real water samples.

The presence of a single-nucleotide mismatch in linker increases the fluorescence of guanine-enhanced DNA-templated Ag nanoclusters and their application for highly sensitive detection of cyanide

Fluorescence of DNA-templated silver nanoclusters can be enhanced by more than 100-fold by placing the nanoclusters in proximity to guanine-rich DNA sequences after hybridization. We found that the fluorescence of the guanine-enhanced silver nanoclusters is not increased with the guanine-rich DNA sequence closer to the silver nanoclusters. By studying the different numbers of mismatches in the linker sequences, we found that the presence of a single-nucleotide mismatch in the linker increases fluorescence more than the complementary nucleotide. Further study indicated the mismatch position of the linker sequence also affects the fluorescence of the hybridized DNA-Ag NCs. The evidence reported here indicated that the mismatch of the linker sequence affects the fluorescence enhancement of guanine-enhanced silver nanoclusters. We also found that DNA-Ag NCs is an excellent fluorescence sensor for cyanide, as cyanide effectively quenches the fluorescence of NCs at a very low concentration with high selectivity. Cyanide in the range from 0.10 μM to 0.35 μM could be linearly detected, with a detection limit of 25.6 nM.