Analysis of light components in pyrolysis products by comprehensive two-dimensional gas chromatography with PLOT columns

Recent Advances in the Decontamination and Upgrading of Waste Plastic Pyrolysis Products: An Overview

Extensive research on the production of energy and valuable materials from plastic waste using pyrolysis has been widely conducted during recent years. Succeeding in demonstrating the sustainability of this technology economically and technologically at an industrial scale is a great challenge. In most cases, crude pyrolysis products cannot be used directly for several reasons, including the presence of contaminants. This is confirmed by recent studies, using advanced characterization techniques such as two-dimensional gas chromatography. Thus, to overcome these limitations, post-treatment methods, such as dechlorination, distillation, catalytic upgrading and hydroprocessing, are required. Moreover, the integration of pyrolysis units into conventional refineries is only possible if the waste plastic is pre-treated, which involves sorting, washing and dehalogenation. The different studies examined in this review showed that the distillation of plastic pyrolysis oil allows the control of the carbon distribution of different fractions. The hydroprocessing of pyrolytic oil gives promising results in terms of reducing contaminants, such as chlorine, by one order of magnitude. Recent developments in plastic waste and pyrolysis product characterization methods are also reported in this review. The application of pyrolysis for energy generation or added-value material production determines the economic sustainability of the process.

Baseline correction method for dynamic pressure gradient modulated comprehensive two-dimensional gas chromatography with flame ionization detection

A baseline correction method is developed for comprehensive two-dimensional (2D) chromatography (GC × GC) with flame-ionization detection (FID) using dynamic pressure gradient modulation (DPGM). The DPGM-GC × GC-FID utilized porous layer open tubular (PLOT) columns in both dimensions to focus on light hydrocarbon separations. Since DPGM is nominally a stop-flow modulation technique, a rhythmic baseline disturbance is observed in the FID signal that cycles with the modulation period (P_M). This baseline disturbance needs to be corrected to optimize trace analysis. The baseline correction method has three steps: collection of a background "blank" chromatogram and multiplying it by an optimized normalization factor, subtraction of the normalization-optimized background chromatogram from a sample chromatogram, and application of Savitzky-Golay smoothing. An alkane standard solution, containing pentane, hexane and heptane was used for method development, producing linear calibration curves (r² > 0.991) over a broad concentration range (7.8 ppm - 4000 ppm). Further, the limit-of-detection (LOD) and limit-of-quantification (LOQ) were determined for pentane (LOD = 2.5 ppm, LOQ = 8.2 ppm), hexane (LOD = 0.9 ppm, LOQ = 3.0 ppm), and heptane (LOD = 1.9 ppm, LOQ = 6.4 ppm). A natural gas sample separation illustrated method applicability, whereby the DPGM produced a signal enhancement (SE) of 30 for isopentane, where SE is defined as the height of the tallest ²D peak in the modulated chromatogram for the analyte divided by the height of the unmodulated ¹D peak. The 30-fold SE resulted in about a 10-fold improvement in the signal-to-noise ratio (S/N) for isopentane. Additional versatility of the baseline correction method for more complicated samples was demonstrated for an unleaded gasoline sample, which enabled the detection (and visual appearance) of trace components.