Copper(I)-2-(2′-pyridyl)benzimidazole catalyzed N-arylation of indoles

Direct C3-Selective Arylation of N-Unsubstituted Indoles with Aryl Chlorides, Triflates, and Nonaflates Using a Palladium-Dihydroxyterphenylphosphine Catalyst

A palladium-dihydroxyterphenylphosphine (DHTP) catalyst was successfully applied to the direct C3-arylation of N-unsubstituted indoles with aryl chlorides, triflates, and nonaflates. This catalyst showed C3-selectivity, whereas catalysts with other structurally related ligands exhibited N1-selectivity. Complex formation between the lithium salts of the ligand and the indole is assumed to accelerate the arylation at the C3 position. Reactions using 3-alkylindoles afforded 3,3-disubstituted indolenines, which can be further converted to the corresponding indoline derivatives.

Visible-light-induced aerobic C3–H fluoroalkoxylation of quinoxalin-2(1H)-ones with fluoroalkyl alcohols

A novel and efficient method of visible-light-induced C3–H fluoroalkoxylation of quinoxalin-2(1H)-ones with fluoroalkyl alcohols is developed. This approach uses readily available fluoroalkyl alcohols as fluoroalkoxylation reagents and displays a wide substrate scope, providing the fluoroalkoxylated products in moderate to good yields. Compared with the previous method, such a transformation uses oxygen as an oxidant, which avoids the utilization of plenty of PhI(TFA)₂. In addition, this strategy also gives a practical tool for the rapid synthesis of histamine-4 receptor antagonist and new N-containing bidentate ligands. A radical mechanism was suggested according to the results of control experiments.

A visible-light-induced aerobic C3–H fluoroalkoxylation of quinoxalin-2(1H)-ones with fluoroalkyl alcohols was reported, providing a green access to fluoroalkoxylated quinoxalin-2(1H)-ones.

Cu(i) based catalysts derived from bidentate ligands and studies on the effect of substituents for N-arylation of benzimidazoles and indoles

Four Cu(i) complexes [Cu(L^1–4)(Cl)(PPh₃)] (C1–C4) were synthesized, characterized and crystal structure of C1 was determined. Complexes were utilized as catalysts for N-arylation reaction. Probable mechanism for N-arylation reaction was proposed.

Palladium nanoparticles supported on modified single-walled carbon nanotubes: a heterogeneous and reusable catalyst in the Ullmann-type N-arylation of imidazoles and indoles

Application of SWCNT-Met/Pd as an efficient and heterogeneous catalyst in the Ullmann coupling of imidazoles and indoles with aryl iodides.

N-(1-Oxy-2-picolyl)oxalamic acids as a new type of O,O-ligands for the Cu-catalyzed N-arylation of azoles with aryl halides in water or organic solvent

A new type of chelators was identified as efficient ligands for promoting Cu-catalyzed N-arylation of azoles with applicability to different solvents.

Copper(I) complexes with trispyrazolylmethane ligands: synthesis, characterization, and catalytic activity in cross-coupling reactions

Three novel Cu(I) complexes bearing tris(pyrazolyl)methane ligands, Tpm(x), have been prepared from reactions of equimolar amounts of CuI and the ligands Tpm, (HC(pz)(3)), Tpm*, (HC(3,5-Me(2)-pz)(3)), and Tpm(Ms), (HC(3-Ms-pz)(3)). X-ray diffraction studies have shown that the Tpm and Tpm(Ms) derivatives exhibit a 2:1 Cu:ligand ratio, whereas the Tpm* complex is a mononuclear species in nature. The latter has been employed as a precatalyst in the arylation of amides and aromatic thiols with good activity. The synthesis of a Tpm*Cu(I)-phthalimidate, a feasible intermediate in this catalytic process, has also been performed. Low temperature (1)H NMR studies in CDCl(3) have indicated that this complex exists in solution as a mixture of two, neutral and ionic forms. Conductivity measurements have reinforced this proposal, the ionic form predominating in a very polar solvent such as DMSO. The reaction of Tpm*Cu(I)-phthalimidate with iodobenzene afforded the expected C-N coupling product in 76% yield accounting for its role as an intermediate in this transformation.