A new ratiometric Ag+ fluorescent sensor based on aggregation-induced emission

Ampyrone appended 1,2,3-triazole as selective fluorescent Cu(II) ion sensor: DFT and docking findings

The present report describes the application of the 'Click Chemistry' pathway to synthesize a fluorescent probe (APT) based on ampyrone (4-aminoantipyrine), entailing two benzyl groups as the fluorophores coupled to the antipyrine structure through 1,2,3-triazole moieties. Infrared spectroscopy (IR), nuclear magnetic resonance (1H and 13C), and mass spectrometry were the standard spectroscopic methods used to characterize APT. The ion recognition potential of the probe was analyzed through absorption and emission spectroscopy employing a 4:1 combination of CH3CN and H2O, which demonstrated APT to be an efficient sensing agent for Cu(II) ions, wherein the absorption spectrum of the probe displayed a hypsochromic shift with a hyperchromic shift on gradually adding the metal ion solution of Cu(II), whereas quenching of the probe's fluorescence emission on Cu(II) addition was attributed to the chelation-enhanced fluorescence quenching (CHEQ), induced by the d9 electronic configuration of Cu(II). The stoichiometry of the complexation of APT with Cu(II) is indicative of a 1:1 ratio, while the detection limit (LOD) and quantification limit (LOQ) as estimated from the fluorescence titration results were 3.11 µM and 10.35 µM respectively. Furthermore, DFT analysis was also undertaken to yield the energy-optimized structures and HOMO-LUMO density plots of APT and its corresponding Cu(II) complex via the B3LYP/631G+(d,p) level of theory for APT, and LANL2DZ basis set for the APT-Cu(II) complex. Docking analysis of the probe with the synaptic vesicle protein (SV2A) gave glimpses about its anticonvulsant properties.

A Sensitive Near-Infrared Fluorescent Probe for Detecting Heavy Metal Ag⁺ in Water Samples

Silver is a common catalyst in industrial production, and the frequent use of Ag⁺ can cause water pollution. Thus, the detection of Ag⁺ in the environment is necessary to determine the level of pollution from silver. In this work, we designed a new, highly selective near-infrared (NIR) fluorescent probe QCy to detect Ag⁺. The probe exhibits "turn-off" fluorescence quenching responses at 760 nm towards Ag⁺ over other relevant cations, with outstanding sensitivity and a low detection limit (0.03 µM), which is considerably lower than the standard of the World Health Organization (WHO) for drinking water (0.9 µM). Meanwhile, QCy showed a very good linearity at a low concentration of Ag⁺ with a 'naked eye' visible color change of solution from blue to red. The probe has been applied successfully for the detection of Ag⁺ in real water samples.

A Fluorescent Turn-On Carbazole-Rhodanine Based Sensor for Detection of Ag+ Ions and Application in Ag+ Ions Imaging in Cancer Cells

Carbazole - Rhodanine conjugate is an effective fluorescent host for silver ions through fluorometric transformation from green to red color with a hyperchromic emission. An intramolecular charge transfer process derived from carbazole towards rhodanine favors interaction of thiocarbonyl S and carboxylic acid O of the rhodanine moiety towards Ag⁺ ion. Carbazole - rhodanine dyad accomplishes the lowest detection limit of 12.8 × 10^-9 M and high quantum efficiency. A fluorescence reversibility of the probe with I^- ion surges reutilization of sensor molecule as an Ag⁺ ion probe with minimal loss in the fluorescent efficiency. This fluorescent ligand is a biocompatible probe and is also a proficient candidate for fluorescent imaging of Ag⁺ ion in live cells.

A reversible fluorescent probe for monitoring Ag(I) ions

Silver-containing nanomaterials are of interest for their antibiotic properties, for a wide range of applications from medicine to consumer products. However, much remains to be learnt about the degradation of such materials and their effects on human health. While most analyses involve measurement of total silver levels, it is important also to be able to measure concentrations of active free Ag(I) ions. We report here the preparation of a coumarin-based probe, thiocoumarin silver sensor 1 (TcAg1), that responds reversibly to the addition of silver ions through the appearance of a new fluorescence emission peak at 565 nm. Importantly, this peak is not observed in the presence of Hg(II), a common interferent in Ag(I) sensing. To establish the utility of this sensor, we prepared silver-doped phosphate glasses with demonstrated bactericidal properties, and observed the Ag(I) release from these glasses in solutions of different ionic strength. TcAg1 is therefore a useful tool for the study of the environmental and medical effects of silver-containing materials.

Tetraphenylethylene-Based AIE-Active Probes for Sensing Applications

This Review provides a comprehensive analysis of recent development in the field of aggregation-induced emission (AIE)-active tetraphenylethylene (TPE) luminophores and their applications in biomolecular science. It begins with a discussion of the diverse range of structural motifs that have found particular applications in sensing, and demonstrates that TPE structures and their derivatives have been used for a diverse range of analytes such as such as H⁺, anions, cations, heavy metals, organic volatiles, and toxic gases. Advances are discussed in depth where TPE is utilized as a mechanoluminescent material in bioinspired receptor units with specificity for analytes for such as glucose or RNA. The rapid advances in sensor research make this summary of recent developments in AIE-active TPE luminophores timely, in order to disseminate the advantages of these materials for sensing of analytes in solution, as well as the importance of solid and aggregated states in controlling sensing behavior.

Fluorescent organic nanoparticles with enhanced fluorescence by self-aggregation and their application for detection of Fe3+ ions

The chemosensor L has a detection limit of 5.57 nM for Fe³⁺ in a DMF/H₂O (9 : 1, v/v) mixture.

Enantioselective recognition of carboxylic acids by novel fluorescent triazine-based thiazoles

Hydrogen bonding and π-π interactions take special part in the enantioselectivity task. In this regard, because of having both hydrogen acceptor and hydrogen donor groups, melamine derivatives become more of an issue for enantioselectivity. In the light of such information, triazine-based chiral, fluorescence active novel thiazole derivatives L1 and L2 were designed and synthesized from (S)-(-)-2-amino-1-butanol and (1S,2R)-(+)-2-amino-1,2-diphenylethanol. The structural establishment of these compounds was made by spectroscopic methods such as FTIR, ¹ H, and ¹³ C NMR. While the solution of these compounds in DMSO did not show any fluorescence emission, it was observed that the emission increased 44-fold for L1 and 55-fold for L2 in 95% water, similar to the aggregation-induced emission (AIE) characterized compounds. In this regard, enantioselective capabilities of these compounds against carboxylic acids were tested, and in experiments carried out at a ratio of 40/60 DMSO/H₂ O, it was determined that R-2ClMA increased the fluorescence emission of L1 chiral receptor by 2.59 times compared to S-isomer.

Aggregation-induced emission active tetraphenylethene-based sensor for uranyl ion detection

A novel tetraphenylethene-based fluorescent sensor, TPE-T, was developed for the detection of uranyl ions. The selective binding of TPE-T to uranyl ions resulted in a detectable signal owing to the quenching of its aggregation-induced emission. The developed sensor could be used to visually distinguish UO2(2+) from lanthanides, transition metals, and alkali metals under UV light; the presence of other metal ions did not interfere with the detection of uranyl ions. In addition, TPE-T was successfully used for the detection of uranyl ions in river water, illustrating its potential applications in environmental systems.

A novel triple-mode fluorescent pH probe from monomer emission to aggregation-induced emission

A tetraphenylenlene (TPE)-based fluorescent probe could selectively monitor pH in THF–H₂O media in wide-range pH. From acidic to basic conditions, it displayed monomer emission, ratiometric fluorescence and aggregation-induced emission successively.

Fluorescence sensing systems for gold and silver species

Here, we provide an overview of the reported fluorescent detection systems for gold and silver species, and discuss their sensing properties with promising features.

Quantitative and highly selective sensing of sodium houttuyfonate via long-aliphatic chains hydrophobic assembly and aggregation-induced emission

An α-cyanostilbene derivative was synthesized for the selective detection of sodium houttuyfonate via AIEE with an obvious fluorescence enhancement.

Fluorometric sensing of Hg2+ ions in aqueous medium by nano-aggregates of a tripodal receptor

Two new tripodal receptors (1–2) have been synthesized and characterized by various spectroscopic techniques. The nano-aggregates of 1 and 2 (N1 and N2) have been prepared by a re-precipitation method in aqueous medium and have shown different photo-physical properties. Nano-aggregates of 1 (N1) can selectively recognize Hg(2+) in aqueous medium in the presence of other metal ions with enhancement in fluorescent intensity. The response was linearly proportional to the concentration of Hg(2+) in the range 0–10 μM with a detection limit of 2.4 nM. The mechanism of selective binding of Hg(2+) by N1 has also been supported by theoretical studies. To the best of our knowledge, this work represents the first report on substituted thiourea based nano-aggregates for nano-molar detection of mercury in aqueous medium.

Aggregation-induced emission: the whole is more brilliant than the parts

"United we stand, divided we fall."--Aesop. Aggregation-induced emission (AIE) refers to a photophysical phenomenon shown by a group of luminogenic materials that are non-emissive when they are dissolved in good solvents as molecules but become highly luminescent when they are clustered in poor solvents or solid state as aggregates. In this Review we summarize the recent progresses made in the area of AIE research. We conduct mechanistic analyses of the AIE processes, unify the restriction of intramolecular motions (RIM) as the main cause for the AIE effects, and derive RIM-based molecular engineering strategies for the design of new AIE luminogens (AIEgens). Typical examples of the newly developed AIEgens and their high-tech applications as optoelectronic materials, chemical sensors and biomedical probes are presented and discussed.

Noncentrosymmetric Packings Influenced by Electronic Properties of Products of Click Reactions

Though 1,4-disubstituted 1,2,3-triazole rings have been utilized as electronic bridges in the solution phase, the use of a triazole ring to serve as an electronic bridge of small molecules in the crystalline state has been underdeveloped. Here two compounds with a central 1,4-disubstituted 1,2,3-triazole ring are synthesized to investigate the electronic bridging between terminal stilbazole and pyridine groups in the crystalline phase. The electronic properties of the molecules are characterized through solution phase UV-vis spectroscopy, single crystal X-ray diffractions, and density-of-state and gas-phase DFT calculations. We show that the electronic bridging behavior of a 1,4-disubstituted 1,2,3-triazole ring derived from a click reaction is maintained in the solid state by rare head-to-head (hh) packing in noncentrosymmetric crystal environments.

Ruthenium complexes of tripodal ligands with pyridine and triazole arms: subtle tuning of thermal, electrochemical, and photochemical reactivity

Electrochemical and photochemical bond-activation steps are important for a variety of chemical transformations. We present here four new complexes, [Ru(L(n) )(dmso)(Cl)]PF6 (1-4), where L(n) is a tripodal amine ligand with 4-n pyridylmethyl arms and n-1 triazolylmethyl arms. Structural comparisons show that the triazoles bind closer to the Ru center than the pyridines. For L(2) , two isomers (with respect to the position of the triazole arm, equatorial or axial), trans-2sym and trans-2un , could be separated and compared. The increase in the number of the triazole arms in the ligand has almost no effect on the Ru(II) /Ru(III) oxidation potentials, but it increases the stability of the RuSdmso bond. Hence, the oxidation waves become more reversible from trans-1 to trans-4, and whereas the dmso ligand readily dissociates from trans-1 upon heating or irradiation with UV light, the RuS bond of trans-4 remains perfectly stable under the same conditions. The strength of the RuS bond is not only influenced by the number of triazole arms but also by their position, as evidenced by the difference in redox behavior and reactivity of the two isomers, trans-2sym and trans-2un . A mechanistic picture for the electrochemical, thermal, and photochemical bond activation is discussed with data from NMR spectroscopy, cyclic voltammetry, and spectroelectrochemistry.