Toxic effects following phosgene exposure of human epithelial lung cells in vitro using a CULTEX® system

How to use an in vitro approach to characterize the toxicity of airborne compounds

As part of the development of new approach methodologies (NAMs), numerous in vitro methods are being developed to characterize the potential toxicity of inhalable xenobiotics (gases, volatile organic compounds, polycyclic aromatic hydrocarbons, particulate matter, nanoparticles). However, the materials and methods employed are extremely diverse, and no single method is currently in use. Method standardization and validation would raise trust in the results and enable them to be compared. This four-part review lists and compares biological models and exposure methodologies before describing measurable biomarkers of exposure or effect. The first section emphasizes the importance of developing alternative methods to reduce, if not replace, animal testing (3R principle). The biological models presented are mostly to cultures of epithelial cells from the respiratory system, as the lungs are the first organ to come into contact with air pollutants. Monocultures or cocultures of primary cells or cell lines, as well as 3D organotypic cultures such as organoids, spheroids and reconstituted tissues, but also the organ(s) model on a chip are examples. The exposure methods for these biological models applicable to airborne compounds are submerged, intermittent, continuous either static or dynamic. Finally, within the restrictions of these models (i.e. relative tiny quantities, adhering cells), the mechanisms of toxicity and the phenotypic markers most commonly examined in models exposed at the air-liquid interface (ALI) are outlined.

Probe on Various Experimental Cigarette Smoke Subjection Structure

Different methods of subjection to smoke from experimental cigarettes are essential for understanding tobacco smoke. The major toxicants found in tobacco are acetaldehyde, acetone, acrolein, acrylonitrile, ammonia, benzene, cadmium, catechol, chromium, cyanide hydrogen, arsenic, nickel, nitric oxide, nicotine last but not least, mono-oxide gases. While experts say, cigarette smoke contains more than 4000 different compounds. These are substantially toxic and can destroy cells, and many of them are carcinogenic. Various smoke-exposure devices are used for in-vitro tobacco smoke generation, dilution, and distribution. Such devices are used widely by well-known manufacturers or can be tailor-made setups. We can set up different in-vitro models to better treat smoke-related diseases using these subjection structures. The fundamental goal will be to build a tobacco-free society of available subjection systems. Some have been identified and established as biological endpoints in some published scientific literature. In the scientific field, many new technologies are coming out and showing their presence. There are many systems of exposure to cigarette smoke in vitro which offer a more flexible approach to the challenges of exposure to tobacco smoke. This review covers some topics such as the description of available new subjection structures and reviews their work, setting up and application for Scenarios of in-vitro treatment. The benefits and disadvantages of both subjection mechanisms and the similarities between the setups and the data extracted from these structures. Measuring the smoke dose is also discussed here as an important field of research, particularly in the preclinical phase. Keywords: Cigarette smoke; Cigarette Subjection Structures; Cigarette Subjection Mechanisms; Cigarette Subjection Advantages; Cigarette Subjection Use; Cigarette Subjection Modern advancements.

Phosgene: toxicology, animal models, and medical countermeasures

Phosgene is a gas crucial to industrial chemical processes with widespread production (∼1 million tons/year in the USA, 8.5 million tons/year worldwide). Phosgene's high toxicity and physical properties resulted in its use as a chemical warfare agent during the First World War with a designation of CG ('Choky Gas'). The industrial availability of phosgene makes it a compound of concern as a weapon of mass destruction by terrorist organizations. The hydrophobicity of phosgene exacerbates its toxicity often resulting in a delayed toxidrome as the upper airways are moderately irritated; by the time symptoms appear, significant damage has occurred. As the standard of care for phosgene intoxication is supportive therapy, a pressing need for effective therapeutics and treatment regimens exists. Proposed toxicity mechanisms for phosgene based on human and animal exposures are discussed. Whereas intermediary components in the phosgene intoxication pathways are under continued discussion, generation of reactive oxygen species and oxidative stress is a common factor. As animal models are required for the study of phosgene and for FDA approval via the Animal Rule; the status of existing models and their adherence to Haber's Rule is discussed. Finally, we review the continued search for efficacious therapeutics for phosgene intoxication; and present a rapid post-exposure response that places exogenous human heat shock protein 72, in the form of a cell-penetrating fusion protein (Fv-HSP72), into lung tissues to combat apoptosis resulting from oxidative stress. Despite significant progress, additional work is required to advance effective therapeutics for acute phosgene exposure.

Evaluation of an in vitro screening model to assess phosgene inhalation injury

Therapeutic development against exposure to toxic gases is hindered by the lack of appropriate models to evaluate candidate compounds prior to animal efficacy studies. In this study, an in vitro, air-liquid interface exposure model has been tested to examine its potential application for screening treatments for phosgene (carbonyl chloride)-induced pulmonary injury. Epithelial cultures on Transwell^® inserts, combined with a Vitrocell^® exposure apparatus, provided a physiologically relevant exposure environment. Differentiated human bronchial epithelial (16HBE) cultures were exposed for 8 min to phosgene ranging from 0 to 64 ppm and assessed for changes in transepithelial electrical resistance (TEER, epithelial barrier integrity), cellular viability (XTT) and post-exposure (PE) cellular metabolic energy status. Exposure to phosgene concentrations ≥8 ppm caused dose-dependent and significant decreases in TEER and XTT which did not recover within 24-h PE. In addition, at 64 ppm the rate of oxidative glutamine metabolism was significantly inhibited at 6 and 24 h after exposure. Glycolytic activities (glucose utilization and lactate production) were also inhibited, but to a lesser extent. Decreased glycolytic function can translate to insufficient energy sources to counteract barrier function failure. Consistent and sensitive markers of phosgene exposure were TEER, cell viability and decreased metabolism. As such, we have assessed an appropriate in vitro model of phosgene inhalation that produced quantifiable alterations in markers of lung cell metabolism and injury in human airway epithelial cells. Data indicate the suitability of this model for testing classes of anti-edemagenic compounds such as corticosteroids or phosphodiesterase inhibitors for evaluating phosgene therapeutics.

Transient receptor potential (TRP) channels as a therapeutic target for intervention of respiratory effects and lethality from phosgene

Phosgene (CG), a toxic inhalation and industrial hazard, causes bronchoconstriction, vasoconstriction and associated pathological effects that could be life threatening. Ion channels of the transient receptor potential (TRP) family have been identified to act as specific chemosensory molecules in the respiratory tract in the detection, control of adaptive responses and initiation of detrimental signaling cascades upon exposure to various toxic inhalation hazards (TIH); their activation due to TIH exposure may result in broncho- and vasoconstriction. We studied changes in the regulation of intracellular free Ca(2+) concentration ([Ca(2+)]i) in cultures of human bronchial smooth muscle cells (BSMC) and human pulmonary microvascular endothelial cells (HPMEC) exposed to CG (16ppm, 8min), using an air/liquid interface exposure system. CG increased [Ca(2+)]i (p<0.05) in both cell types, The CG-induced [Ca(2+)]i was blocked (p<0.05) by two types of TRP channel blockers, SKF-96365, a general TRP channel blocker, and RR, a general TRPV (vanilloid type) blocker, in both BSMC and HPMEC. These effects correlate with the in vivo efficacies of these compounds to protect against lung injury and 24h lethality from whole body CG inhalation exposure in mice (8-10ppm×20min). Thus the TRP channel mechanism appears to be a potential target for intervention in CG toxicity.

Application of a modified gaseous exposure system to the in vitro toxicological assessment of tobacco smoke toxicants

Tobacco smoke is a complex mixture of over 6,000 individual chemical constituents. Approximately 150 of these have been identified as 'tobacco smoke toxicants' due to their known toxicological effects. A number of these toxicants are present in the gaseous phase of tobacco smoke. This presents a technical challenge when assessing the toxicological effects of these chemicals in vitro. We have adapted a commercially available tobacco smoke exposure system to enable the assessment of the contribution of individual smoke toxicants to the overall toxicological effects of whole mainstream cigarette smoke (WS). Here we present a description of the exposure system and the methodology used. We use the example of a gaseous tobacco smoke toxicant, ethylene oxide (EtO), a Group 1 IARC carcinogen and known mutagen, to illustrate how this methodology can be applied to the assessment of genotoxicity of gaseous chemicals in the context of WS. In the present study we found that EtO was positive in Salmonella typhimurium strain YG1042, a strain that is sensitive to tobacco smoke. However, EtO did not increase the mutagenicity of the WS mixture when it was added at greatly higher concentrations than those found typically in WS. The findings presented here demonstrate the suitability of this exposure system for the assessment of the mutagenic potential of gases in vitro. Whilst we have focused on tobacco smoke toxicants, this system has broad application potential in studying the biological effects of exposure to a wide range of gaseous compounds that are present within complex aerosol mixtures.

The CULTEX RFS: a comprehensive technical approach for the in vitro exposure of airway epithelial cells to the particulate matter at the air-liquid interface

The EU Regulation on Registration, Evaluation, Authorization and Restriction of Chemicals (REACH) demands the implementation of alternative methods for analyzing the hazardous effects of chemicals including particulate formulations. In the field of inhalation toxicology, a variety of in vitro models have been developed for such studies. To simulate the in vivo situation, an adequate exposure device is necessary for the direct exposure of cultivated lung cells at the air-liquid interface (ALI). The CULTEX RFS fulfills these requirements and has been optimized for the exposure of cells to atomized suspensions, gases, and volatile compounds as well as micro- and nanosized particles. This study provides information on the construction and functional aspects of the exposure device. By using the Computational Fluid Dynamics (CFD) analysis, the technical design was optimized to realize a stable, reproducible, and homogeneous deposition of particles. The efficiency of the exposure procedure is demonstrated by exposing A549 cells dose dependently to lactose monohydrate, copper(II) sulfate, copper(II) oxide, and micro- and nanoparticles. All copper compounds induced cytotoxic effects, most pronounced for soluble copper(II) sulfate. Micro- and nanosized copper(II) oxide also showed a dose-dependent decrease in the cell viability, whereby the nanosized particles decreased the metabolic activity of the cells more severely.