High background in Luminex® assay for HLA antibody screening: Interest of Adsorb Out™

Photocleavage-based affinity purification of biomarkers from serum: Application to multiplex allergy testing

Multiplex serological immunoassays, such as implemented on microarray or microsphere-based platforms, provide greater information content and higher throughput, while lowering the cost and blood volume required. These features are particularly attractive in pediatric food allergy testing to facilitate high throughput multi-allergen analysis from finger- or heel-stick collected blood. However, the miniaturization and microfluidics necessary for creating multiplex assays make them highly susceptible to the “matrix effect” caused by interference from non-target agents in serum and other biofluids. Such interference can result in lower sensitivity, specificity, reproducibility and quantitative accuracy. These problems have in large part prevented wide-spread implementation of multiplex immunoassays in clinical laboratories. We report the development of a novel method to eliminate the matrix effect by utilizing photocleavable capture antibodies to purify and concentrate blood-based biomarkers (a process termed PC-PURE) prior to detection in a multiplex immunoassay. To evaluate this approach, it was applied to blood-based allergy testing. Patient total IgE was purified and enriched using PC-PURE followed by multiplex microsphere-based detection of allergen-specific IgEs (termed the AllerBead assay). AllerBead was formatted to detect the eight most common pediatric food allergens: milk, soy, wheat, egg, peanuts, tree nuts, fin fish and shellfish, which account for >90% of all pediatric food allergies. 205 serum samples obtained from Boston Children’s Hospital were evaluated. When PC-PURE was employed with AllerBead, excellent agreement was obtained with the standard, non-multiplex, ImmunoCAP^® assay (average sensitivity above published negative predictive cutoffs = 96% and average Pearson r = 0.90; average specificity = 97%). In contrast, poor ImmunoCAP^®-correlation was observed when PC-PURE was not utilized (average sensitivity above published negative predictive cutoffs = 59% and average Pearson r = 0.61; average specificity = 97%). This approach should be adaptable to improve a wide range of multiplex immunoassays such as in cancer, infectious disease and autoimmune disease.

Reason and Resolution of High Negative Control Beads in Solid-Phase Immunoassay

OBJECTIVES

The Luminex technology is the most sensitive diagnostic method for HLA antibody detection and identification. However, the interpretation of immunoassays is commonly affected by the artifact, and non-specific background. Sera from some patients show high negative control bead (NC) value, which makes assessing and interpretation of HLA antibodies difficult. In this study, we evaluated the effect of Adsorb Out reagent, dithiothreitol (DTT), and Ethylenediaminetetraacetic acid (EDTA) on the NC median fluorescence intensity value by comparing treated versus untreated patient sera. In addition, we wanted to identify whether kidney disease and administered medication influenced high NC median fluorescence intensity values by comparing patient versus control results.

MATERIALS AND METHODS

HLA antibody screening was performed on 3500 serum samples. Sera were analyzed using the standard protocol for Luminex antibody screening. Sera with high NC values were preincubated with Adsorb Out, DTT, and EDTA. Screening of these sera was then performed.

RESULTS

We found that 4% of samples showed high NC values. Adsorb Out, DTT, and EDTA decreased the NC values at 723.5 (299.25-1443) versus 85 (34-218; P < .001), at 723.5 (299.25-1443) versus 184 (106-597; P < .001), and at 723.5 (299.25-1443) versus 455 (131-1177; P = .004). These succeeded in bringing back NC values to normal range in 69.2%, 43%, and 30% of treated sera, respectively. In addition, the differences of corticoids, immunosuppressive, and heparin drugs between patients and controls were statistically significant (P < .001, < .001, and = .043). However, presence of kidney disease was not significant between these groups.

CONCLUSIONS

All pretreatments had an important effect in decreasing negative control values, with Adsorb Out having highest efficiency. Serum-specific components could contribute to high negative control bead median fluorescence intensity values. Further studies are needed to determine the adequate pretreatment of patient sera.