Mechanistic analysis of cavitation assisted transesterification on biodiesel characteristics

Ultrasound combined with SDF-1α chemotactic microbubbles promotes stem cell homing in an osteoarthritis model

Osteoarthritis (OA) is a common joint disease in the middle and old age group with obvious cartilage damage, and the regeneration of cartilage is the key to alleviating or treating OA. In stem cell therapy, bone marrow stem cell (BMSC) has been confirmed to have cartilage regeneration ability. However, the role of stem cells in promoting articular cartilage regeneration is severely limited by their low homing rate. Stromal cell‐derived factor‐1α (SDF‐1α) plays a vital role in MSC migration and involves activation, mobilization, homing and retention. So, we aim to develop SDF‐1α‐loaded microbubbles MB(SDF‐1α), and to verify the migration of BMSCs with the effect of ultrasound combined with MB(SDF‐1α) in vitro and in vivo. The characteristics of microbubbles and the content of SDF‐1α were examined in vitro. To evaluate the effect of ultrasound combined with chemotactic microbubbles on stem cell migration, BMSCs were injected locally and intravenously into the knee joint of the OA model, and the markers of BMSCs in the cartilage were detected. We successfully prepared MB(SDF‐1α) through covalent bonding with impressive SDF‐1α loading efficacy loading content. In vitro study, ultrasound combined with MB(SDF‐1α) group can promote more stem cell migration with highest migrating cell counts, good cell viability and highest CXCR4 expression. In vivo experiment, more BMSCs surface markers presented in the ultrasound combined with MB(SDF‐1α) group with or without exogenous BMSCs administration. Hence, ultrasound combined with MB(SDF‐1α) could promote the homing of BMSCs to cartilage and provide a novel promising therapeutic approach for OA.

Ultrasonic, hydrodynamic and microwave biodiesel synthesis - A comparative study for continuous process

At this time biodiesel appears to be a viable proposition as a renewable energy source and an alternative to fossil-based fuels. Following many years of research, the use of process intensification techniques for the production of biodiesel is well documented. This work has focused more on a study of biodiesel production using continuous flow systems assisted by acoustic cavitation (ultrasonic or hydrodynamic) or microwaves. The target end user is the small or medium farm where such equipment could provide sufficient fuel for on-site agricultural machinery using renewable or waste green materials produced on site.

Harnessing cavitational effects for green process intensification

The impressive chemico-physical effects observed in sonochemistry are a result of cavitation, as ultrasonic and hydrodynamic cavitation does not interact with matter at the atomic and molecular levels. Bubble collapse leads to the quasi-adiabatic heating of the vapour inside bubbles, giving rise to local hot spots in the fluid. Cavitation thus transforms a mechanical energy into high kinetic energy, which is released in very short bursts that are exploited for green process intensification. This paper reviews relevant applications of hydrodynamic and acoustic cavitation with the aim of highlighting the particular advantages that these phenomena offer to the intensification of green chemical processes. Emulsification, biodiesel preparation, wastewater decontamination, organic synthesis, enzymatic catalysis and extractions are discussed among others. As a comparison, hydrodynamic cavitation technique is more advantageous in dealing with process intensification at large-scale, as well as the enhancement of mass transfer and heat transfer, while ultrasonic cavitation technique is more convenient to operate, easier to control in the studies at lab-scale, and exhibits more efficient in producing active free radicals and inducing the cleavage of volatile compounds.

Investigation of mass transfer intensification under power ultrasound irradiation using 3D computational simulation: A comparative analysis

This paper aims at investigating the influence of acoustic streaming induced by low-frequency (24kHz) ultrasound irradiation on mass transfer in a two-phase system. The main objective is to discuss the possible mass transfer improvements under ultrasound irradiation. Three analyses were conducted: i) experimental analysis of mass transfer under ultrasound irradiation; ii) comparative analysis between the results of the ultrasound assisted mass transfer with that obtained from mechanically stirring; and iii) computational analysis of the systems using 3D CFD simulation. In the experimental part, the interactive effects of liquid rheological properties, ultrasound power and superficial gas velocity on mass transfer were investigated in two different sonicators. The results were then compared with that of mechanical stirring. In the computational part, the results were illustrated as a function of acoustic streaming behaviour, fluid flow pattern, gas/liquid volume fraction and turbulence in the two-phase system and finally the mass transfer coefficient was specified. It was found that additional turbulence created by ultrasound played the most important role on intensifying the mass transfer phenomena compared to that in stirred vessel. Furthermore, long residence time which depends on geometrical parameters is another key for mass transfer. The results obtained in the present study would help researchers understand the role of ultrasound as an energy source and acoustic streaming as one of the most important of ultrasound waves on intensifying gas-liquid mass transfer in a two-phase system and can be a breakthrough in the design procedure as no similar studies were found in the existing literature.

Assessment of Various Pretreatment and Extraction Methods for the Extraction of Bioactive Compounds from Orthosiphon stamineus Leaf via Microstructures Analysis

The impacts of various methods such as mechanical grinding, ultrasonic-assisted extraction (UAE), microwave-assisted extraction (MAE), and also sample pretreatments using acid and alkali on the microstructure of plant sample were studied for the extraction of bioactive compounds from Orthosiphon stamineus leaf. From scanning electron microscopy (SEM) analysis of the extracted sample, UAE and MAE induced significant disruption on glandular trichomes structure, which is the main site for biosynthesis of plant secondary metabolites. This improves the diffusion of bioactive compound and resulted in approximately 86–95 % of the total extraction yield quantified by conventional Soxhlet extraction. Chemical pretreatments generally imparted weaker microstructures disruption thus slight improvement on the extraction yields was observed. In this case, acid reagent is more suitable for the pretreatment as the presence of alkali decomposes the bioactive compounds. In a nutshell, the performance of an extraction strongly depends on its degree of disruption on the plant sample microstructure.