Infrared dichroism of amide I and amide II modes of alpha I- and alpha II-helix segments in membrane proteins

Specific and non-specific interactions between metal cations and zwitterionic alanine tripeptide in saline solutions reported by the symmetric carboxylate stretching and amide-II vibrations

The "specific" interaction between metal cations (Na⁺, Ca²⁺, Mg²⁺, and Zn²⁺) and the charged COO^- group, and the "non-specific" interaction between these cations and the peptide backbone of a zwitterionic trialanine (Ala3) in aqueous solutions were examined in detail, using linear infrared (IR) absorptions of the COO^- symmetric stretching and the amide-II (mainly the C-N stretching) modes as IR probes. Different IR spectral changes in peak positions and intensities of the two IR probes clearly demonstrate their sensitivities to nearby cation distributions in distance and population. Quantum chemistry calculations and molecular dynamics simulations were used to describe the cation-peptide interaction picture. These combined results suggest that Na⁺ and Ca²⁺ tend to bind to the COO^- group in the bidentate form, while Mg²⁺ and Zn²⁺ tend to bind to the COO^- group in the pseudo-bridging form. The results also show that while all three divalent cations indirectly interact with the peptide backbone with large population, Ca²⁺ and Mg²⁺ can be sometimes distributed very close to the backbone. Such a non-specific cation interaction can be moderately sensed by the C-N stretching of the amide-II mode when cations approach the polar amide C[double bond, length as m-dash]O group, and is also influenced by the NH₃⁺ charge group located at the N-terminus. The results suggest that the experimentally observed complication of the Hofmeister cation series shall be understood as a combined specific and non-specific cation-peptide interactions.

Direct Anionic Effect on Water Structure and Indirect Anionic Effect on Peptide Backbone Hydration State Revealed by Thin-Layer Infrared Spectroscopy

In this work, the anionic effect on water structure and on the peptide backbone and water interaction was investigated directly in aqueous solution using thin-layer transmission infrared spectroscopy. The chaotropic anions were found to weaken the water hydrogen-bonding strength and red shift the HOH bending frequency, while the kosmotropic anions were found to strengthen the water hydrogen-bonding network and blue shift the HOH bending frequency. The kosmotropes, especially F^-, blue shift the vibrational frequencies of both amide II and amide III bands of N-methylacetamide (NMA), indicating NMA is in the "salting-in" state; while the chaotropes (Cl^-, NO₃^-, Br^-, I^-, and SCN^-) red shift the frequencies of the two normal modes, indicating NMA is in the "salting-out" state. Furthermore, the changes of the vibrational frequencies of the HOH bending, amide II and III bands were found to generally follow the Hofmeister anionic series. Our results suggest that hydrated anion influences the peptide backbone mainly through the N-H group, but a weak and indirect effect through the amide C═O group also contributes. Thus, these amide modes can be used as vibrational measures of anionic influences on peptide backbone's hydration state. Our work also suggests that deuteration of the amide unit decreases the sensitivity of the amide II and III vibrational modes in this regard.

Orientation determination of interfacial beta-sheet structures in situ

Structural information such as orientations of interfacial proteins and peptides is important for understanding properties and functions of such biological molecules, which play crucial roles in biological applications and processes such as antimicrobial selectivity, membrane protein activity, biocompatibility, and biosensing performance. The alpha-helical and beta-sheet structures are the most widely encountered secondary structures in peptides and proteins. In this paper, for the first time, a method to quantify the orientation of the interfacial beta-sheet structure using a combined attenuated total reflectance Fourier transformation infrared spectroscopic (ATR-FTIR) and sum frequency generation (SFG) vibrational spectroscopic study was developed. As an illustration of the methodology, the orientation of tachyplesin I, a 17 amino acid peptide with an antiparallel beta-sheet, adsorbed to polymer surfaces as well as associated with a lipid bilayer was determined using the regular and chiral SFG spectra, together with polarized ATR-FTIR amide I signals. Both the tilt angle (theta) and the twist angle (psi) of the beta-sheet at interfaces are determined. The developed method in this paper can be used to obtain in situ structural information of beta-sheet components in complex molecules. The combination of this method and the existing methodology that is currently used to investigate alpha-helical structures will greatly broaden the application of optical spectroscopy in physical chemistry, biochemistry, biophysics, and structural biology.

Orientation determination of protein helical secondary structures using linear and nonlinear vibrational spectroscopy

In this paper, we systematically presented the orientation determination of protein helical secondary structures using vibrational spectroscopic methods, particularly, nonlinear sum frequency generation (SFG) vibrational spectroscopy, along with linear vibrational spectroscopic techniques such as infrared spectroscopy and Raman scattering. SFG amide I signals can be collected using different polarization combinations of the input laser beams and output signal beam to measure the second-order nonlinear optical susceptibility components of the helical amide I modes, which are related to their molecular hyperpolarizability elements through the orientation distribution of these helices. The molecular hyperpolarizability elements of amide I modes of a helix can be calculated based on the infrared transition dipole moment and Raman polarizability tensor of the helix; these quantities are determined by using the bond additivity model to sum over the individual infrared transition dipole moments and Raman polarizability tensors, respectively, of the peptide units (or the amino acid residues). The computed overall infrared transition dipole moment and Raman polarizability tensor of a helix can be validated by experimental data using polarized infrared and polarized Raman spectroscopy on samples with well-aligned helical structures. From the deduced SFG hyperpolarizability elements and measured SFG second-order nonlinear susceptibility components, orientation information regarding helical structures can be determined. Even though such orientation information can also be measured using polarized infrared or polarized Raman amide I signals, SFG has a much lower detection limit, which can be used to study the orientation of a helix when its surface coverage is much lower than a monolayer. In addition, the combination of different vibrational spectroscopic techniques, for example, SFG and attenuated total reflectance Fourier transform infrared spectroscopy, provides more measured parameters for orientation determination, aiding in the deduction of more complicated orientation distributions. In this paper, we discussed two types of helices, the alpha-helix and 3-10 helix. However, the orientation determination method presented here is general and thus can be applied to study other helices as well. The calculations of SFG amide I hyperpolarizability components for alpha-helical and 3-10 helical structures with different chain lengths have also been performed. It was found that when the helices reached a certain length, the number of peptide units in the helix should not alter the data analysis substantially. It was shown in the calculation, however, that when the helix chain is short, the SFG hyperpolarizability component ratios can vary substantially when the chain length is changed. Because 3-10 helical structures can be quite short in proteins, the orientation determination for a short 3-10 helix needs to take into account the number of peptide units in the helix.

FTIR spectroscopy of secondary-structure reorientation of melibiose permease modulated by substrate binding

Analysis of infrared polarized absorbance spectra and linear dichroism spectra of reconstituted melibiose permease from Escherichia coli shows that the oriented structures correspond mainly to tilted transmembrane alpha-helices, forming an average angle of approximately 26 degrees with the membrane normal in substrate-free medium. Examination of the deconvoluted linear dichroism spectra in H(2)O and D(2)O makes apparent two populations of alpha-helices differing by their tilt angle (helix types I and II). Moreover, the average helical tilt angle significantly varies upon substrate binding: it is increased upon Na(+) binding, whereas it decreases upon subsequent melibiose binding in the presence of Na(+). In contrast, melibiose binding in the presence of H(+) causes virtually no change in the average tilt angle. The data also suggest that the two helix populations change their tilting and H/D exchange level in different ways depending on the bound substrate(s). Notably, cation binding essentially influences type I helices, whereas melibiose binding modifies the tilting of both helix populations.

Structural and functional implications of the instability of the ADP/ATP transporter purified from mitochondria as revealed by FTIR spectroscopy

The ADP/ATP transporter shows a high instability when solubilized, making it difficult to obtain functional protein with sufficient purity for long-term spectroscopic studies. When solubilized in the detergent dodecyl maltoside the protein is in equilibrium between the so-called CATR and BA conformations and in a few hours it becomes nonfunctional, unable to bind either its inhibitors or its substrates. By Fourier transform infrared spectroscopy, we studied the structural changes involved in this denaturation process. To do so, the carboxyatractyloside-inhibited protein was used as a structural model for the protein in the CATR conformation and its spectrum was compared with that of the unliganded time-inactivated protein. From the difference spectra of the amide I, amide II, and amide A bands combined with dichroism spectra of the carboxyatractyloside-inhibited protein, we concluded that few structural differences exist between both states, affecting as few as 11 amino acids (3.5% of the protein); the structural changes consisted in the disappearance of large loop structure and the appearance of aggregated strands. We hypothesize that some mitochondrial loop (tentatively loop M1) shows a high tendency to aggregate, being responsible for the observed features. The functional consequences of this hypothesis are discussed.

Orientation of the infrared transition moments for an alpha-helix

Appropriate values for the orientation of the amide transition dipoles are essential to the growing use of isotopically edited vibrational spectroscopy generally in structural biology and to infrared dichroism measurements on membrane-associated alpha-helices, in particular. The orientations of the transition moments for the amide vibrations of an alpha-helix have been determined from the ratio of intensities of the A- and E(1)-symmetry modes in the infrared spectra of poly(gamma-methyl-L-glutamate)(x)-co-(gamma-n-octadecyl-L-glutamate)( y) oriented on silicon substrates. Samples possessing a high degree of alignment were used to facilitate band fitting. Consistent results were obtained from both attenuated total reflection and transmission experiments with polarized radiation, yielding values of Theta(I) = 38 degrees, Theta(II) = 73 degrees, and Theta(A) = 29 degrees, relative to the helix axis, for the amide I, amide II, and amide A bands, respectively. The measurements are discussed both in the context of the somewhat divergent older determinations, and in relation to the helix geometry and results on model amide compounds, to resolve current uncertainties in the literature.

Membrane helix orientation from linear dichroism of infrared attenuated total reflection spectra

Oriented multilamellar systems containing phospholipids and peptides have been formed on a germanium internal reflection element. Attenuated total reflection infrared spectra have been recorded and the linear dichroism of peptide amide I and amide II bands measured. Using peptides for which the orientation had been previously studied under similar experimental conditions by 15N solid-state nuclear magnetic resonance spectroscopy, important conclusions were drawn on the approach to be used to derive secondary structure orientation in a membrane from dichroic ratios. In particular, it is shown that the influence of the film thickness and refractive index on the orientation determination can be evaluated from the value of RATRiso, i.e., the dichroic ratio of a dipole oriented at the magic angle or with isotropic mobility. A series of peptides was used to test the validity of our suggestions on various helix orientations in the membrane. These include magainin 2 and hydrophobic (hPhi20) model peptides, the transmembrane segment of glycophorin (GLY), and LAH4, a designed peptide antibiotic that changes between a transmembrane and an in-plane orientation in a pH-dependent manner.

Helical and reverse turn changes in the BR->N transition of bacteriorhodopsin

Fourier transform infrared deconvoluted spectra of bacteriorhodopsin and the N intermediate were compared with the N/BR infrared difference spectrum. In the amide I, clear changes in the bands at 1666 cm-1, assigned to alpha II helices, 1659 cm-1, assigned to alpha I and alpha II helices, and 1652 cm-1, assigned to both alpha I helices and unordered structures, were found. These changes could arise from conversion of some alpha II and alpha I helices. Variations in the bands at 1692 and 1683 cm-1, corresponding to reverse turns, were also detected. The side chains of Tyr (band at 1517 cm-1) and Phe (band at 1498 cm-1) were found to change in going from BR to N. In the carboxylate region, no band was detected at 1737 cm-1 in the deconvoluted spectra that could correspond to the peak observed in the difference spectrum. It is argued that resolution-enhancement methods used along with difference spectra provide more detailed insights into the conformational changes occurring between photocycle intermediates.