Electrokinetic chromatography with micelles, polymeric and monomeric additives with similar chemical functionality as pseudo-stationary phases

Development of a novel dual CD-MEKC system for the systematic flavonoid fingerprinting of Ligaria cuneifolia (R. et P.) Tiegh.-Loranthaceae-extracts

The present work deals with the development and validation of a novel dual CD-MEKC system for the systematic flavonoid fingerprinting of Ligaria cuneifolia (R. et P.) Tiegh.-Loranthaceae-extracts. The BGE consisted of 20 mM pH 8.3 borate buffer, 50 mM SDS, a dual CD system based on the combination of 5 mM β-CD and 2% w/v S-β-CD, and 10% v/v methanol. The proposed method has been successfully applied to the comparative analysis of extracts from aerial parts and different hosts, geographical areas, and extraction procedures in order to establish the flavonoid fingerprint of L. cuneifolia. The method was validated according to international guidelines. LOD and LOQ, intra and interday precision, and linearity were determined for catechin, epicatechin, procyanidin B2, rutin, quercetin-3-O-glucoside, quercetin-3-O-xyloside, quercetin-3-O-rhamnoside, quercetin-3-O-arabinofuranoside, quercetin-3-O-arabinopyranoside, and quercetin. The CD-MEKC methodology emerges as a suitable alternative to the traditional HPLC for quality control, fingerprinting, and standardization of L. cuneifolia extracts from different sources.

Simultaneous determination of natural and synthetic estrogens by EKC using a novel microemulsion

A novel microemulsion based on sodium bis(2-ethylhexyl) sulfosuccinate (AOT) was developed for the simultaneous determination of natural and synthetic estrogens by microemulsion EKC (MEEKC). The microemulsion system consisted of 1.4% w/w AOT, 1.0% w/w octane, 7.0% w/w 1-butanol and 90.6% w/w 20 mM sodium salt of 3-(cyclohexylamino)-2-hydroxy-1-propanesulfonic acid (CAPSO) and 10 mM phosphate buffer at pH 12.5. A baseline resolution in the separation of estrone, 17beta-estradiol, estriol, estradiol 17-hemisuccinate, etinilestradiol, estradiol 3-benzoate, and estradiol 17-valerate was achieved in comparison to the traditional MEEKC system with SDS in less than 15 min. The optimized electrophoretic conditions included the use of an uncoated-silica capillary of 60 cm of total length and 75 microm id, an applied voltage of 25 kV, a temperature of 25 degrees C and 214 UV-detection. Parameters of validation such as specificity, linearity, accuracy, LOD, LOQ and robustness were evaluated according to international guidelines. Due to its simplicity, accuracy, and reliability, the proposed method can be an advantageous alternative to the traditional methodologies for the analysis of natural and synthetic estrogens in different pharmaceutical forms.

Cationic and perfluorinated polymeric pseudostationary phases for electrokinetic chromatography

Separation selectivity in electrokinetic chromatography (EKC) is directly affected by the chemistry and solvent characteristics of the pseudostationary phase (PSP). The chemical selectivity of micellar PSPs has been previously demonstrated to vary significantly between anionic and cationic surfactants as well as between hydrocarbon and fluorocarbon surfactants. Polymeric PSPs have also been demonstrated to provide unique selectivity. In the current study, four cationic polymeric pseudo-stationary phases, two of which have perfluorinated pendant groups, are introduced and characterized as PSPs in EKC. Their performance and selectivity is compared to conventional micellar PSPs with similar structure. The solvation characteristics and selectivity of the four polymers most closely resemble those observed for cationic micelles. The polymers are all more cohesive and more polar than their hydrocarbon micellar counterparts. The fluorocarbon PSPs did show preferential interaction with fluorocarbon solutes, were somewhat more cohesive, and were stronger hydrogen bond donors. However, the presence of fluorocarbon moieties did not have as dramatic an effect on selectivity as was observed and published previously for fluorocarbon micelles. This may result from the selectivity being dominated by the presence of the cationic head groups or from the fluorocarbon character of the pendant groups being moderated by the presence of hydrocarbon functionality on the polymer backbones.

Developments in the use of soluble ionic polymers as pseudo-stationary phases for electrokinetic chromatography and stationary phases for electrochromatography

This article reviews the development, characterization and application of soluble ionic polymeric materials as pseudo-stationary phases for electrokinetic chromatography and as stationary phases for electrochromatography since 1997. Polymeric pseudo-stationary phases for electrokinetic chromatography, including cationic polymers, anionic siloxane and acrylamide polymers, polymerized surfactants (micelle polymers), and chiral polymers are reviewed. Also reviewed are suspended molecularly imprinted polymer micro-particles. Application of polymeric pseudo-stationary phases with electrospray ionization mass spectrometric detection is presented. Recent progress in the development and characterization of physically adsorbed stationary phases for electrochromatography using polymers of the same or similar chemistry is also reviewed.

Analysis of anticancer platinum(II)-complexes by microemulsion electrokinetic chromatography: separation of diastereomers and estimation of octanol-water partition coefficients

Microemulsion electrokinetic chromatography (MEEKC) was applied for the separation and lipophilicity estimation of oxaliplatin and eight novel anticancer oxaliplatin derivatives. Solubility and permeability have to be balanced in modern drug development, and the octanol-water partition coefficient (log P) still represents one of the most useful quantifiable parameters providing a reasonable estimation of a drug's lipophilicity. Therefore, the capacity factors from MEEKC were correlated to log P values derived by the traditional shake flask method. The MEEKC method was accomplished using a microemulsion of heptane/sodium dodecyl sulfate (SDS)/butanol in phosphate buffer at pH 7.4 and 37 degrees C with all analytes being in a neutral state during the run. This experimental setup allowed a baseline separation of all platinum complexes within 11 min. Remarkably, beside the very good resolution and precision of the measurements, separation of diastereomers of the complexes and quantification of the diastereomeric ratios could be achieved. Correlating the capacity factors with the corresponding log P values resulted in a linear dependency with a correlation factor of r = 0.9935. Consequently, the applied MEEKC method was found to be a highly valuable technique not only for the separation of platinum complexes but as well for the estimation of the octanol-water partition coefficient with many advantages in comparison to other methods.

Determination of critical micelle concentration of surfactants by capillary electrophoresis

Capillary electrophoresis (CE) has been proven to be a convenient and useful technique for the determination of the critical micelle concentration (CMC) of a surfactant in an electrophoretic system under operating conditions. In this review, methodological approaches to the determination of the CMC of surfactants by CE technique are described. The practical requirements for making such measurements and the CMC values of surfactants determined by CE methods are presented. In addition, difficulties and uncertainty, as well as misconceptions that may arise in the CMC determination are discussed.

Relation between retention factors of immunosuppressive drugs in microemulsion electrokinetic chromatography with biosurfactants and octanol–water partition coefficients

Retention (capacity) factors (k' values) of immunosuppressive drugs were determined in microemulsion electrokinetic chromatography (MEEKC) systems as a tool for the indirect estimation of partition coefficients (POW) between 1-octanol and water. The microemulsions were based on phosphatidylcholine (PC) and bile acids (BAs) as biosurfactants and isopropyl myristate (IPM) as oil. Immunosuppressants were azathioprine (AZA), mycophenolate mofetil (MMF), tacrolimus (FK506) and cyclosporine A (CyA). Capacity factors of the analytes were determined from electrophoretic mobilities using an aqueous phosphate buffer (20 mM; pH 7.5) for all the systems. Retention was compared with that in the most commonly used microemulsion based on sodium dodecyl sulphate (SDS). logPOW versus logk' calibration lines were constructed using reference compounds with known POW. In addition, data of logPOW of the immunosuppressants were determined by partitioning between octanol and water, and were calculated by the aid of computer program. A different sequence of logPOW for two analytes was found in the biosurfactant-based systems compared with the SDS-containing one. Excellent agreement was observed between the logPOW values derived from the microemulsions containing deoxycholate compared with the data determined by partitioning between octanol and water. It was concluded that the retention factors in the systems with biosurfactants are good estimators for the partitioning in biological systems.

Retention of bile salts in micellar electrokinetic chromatography: relation of capacity factor to octanol-water partition coefficient and critical micellar concentration

The capacity factors of 16 anionic cholates (from six bile salts, including their glyco- and tauro-conjugates) were determined in a micellar electrokinetic chromatography (MEKC) system consisting of buffer, pH 7.5 (phosphate-boric acid; 20 mmol/l) with 50 mmol/l sodium dodecyl sulfate (SDS) as micelle former and 10% acetonitrile as organic modifier. The capacity factors of the fully dissociated, negatively charged analytes (ranging between 0.2 and 60) were calculated from their mobilities, with a reference background electrolyte (BGE) without SDS representing "free" solution. For comparison, the capacity factors were derived for a second reference BGE where the SDS concentration (5 mmol/l) is close to the critical micellar concentration (CMC). The capacity factors are compared with the logarithm of the octanol-water partition coefficient, log Pow, as measure for lipophilicity. Clear disagreement between these two parameters is found especially for epimeric cholates with the hydroxy group in position 7. In contrast, fair relation between the capacity factor of the analytes and their CMC is observed both depending strongly on the orientation of the OH groups, and tauro-conjugation as well. In this respect the retention behaviour of the bile salts in MEKC seems to reflect their role as detergents in living systems, and might serve as model parameter beyond lipophilicity.