Alkyl modified anionic siloxanes as pseudostationary phases for electrokinetic chromatography. I. Synthesis and characterization

Developments in the use of soluble ionic polymers as pseudo-stationary phases for electrokinetic chromatography and stationary phases for electrochromatography

This article reviews the development, characterization and application of soluble ionic polymeric materials as pseudo-stationary phases for electrokinetic chromatography and as stationary phases for electrochromatography since 1997. Polymeric pseudo-stationary phases for electrokinetic chromatography, including cationic polymers, anionic siloxane and acrylamide polymers, polymerized surfactants (micelle polymers), and chiral polymers are reviewed. Also reviewed are suspended molecularly imprinted polymer micro-particles. Application of polymeric pseudo-stationary phases with electrospray ionization mass spectrometric detection is presented. Recent progress in the development and characterization of physically adsorbed stationary phases for electrochromatography using polymers of the same or similar chemistry is also reviewed.

Conformational effects on the performance and selectivity of a polymeric pseudostationary phase in electrokinetic chromatography

The effect of the conformation of a polymeric pseudostationary phase on performance and selectivity in electrokinetic chromatography was studied using an amphiphilic pH-responsive polymer that forms compact intramolecular aggregates (unimer micelles) at low pH and a more open conformation at high pH. The change in conformation was found to affect the electrophoretic mobility, retention, selectivity, and separation efficiency. The low-pH conformer has higher electrophoretic mobility and greater affinity for most solutes. The unimer micelle conformation was also found to provide a solvation environment more like that of micelles and other amphiphilic self-associative polymers studied previously. It was not possible to fully characterize the effect of conformation on efficiency, but very hydrophobic solutes with long alkyl chains appeared to migrate with better efficiency when the unimer micelle conformation was employed. The results imply that polymers with a carefully optimized lipophilic-hydrophilic balance that allow self-association will perform better as pseudostationary phases. In addition, the results show that electrokinetic chromatography is a useful method for determining the changes in solvation environment provided by stimuli-responsive polymers with changes in the conditions.

(Micellar) electrokinetic chromatography: an interesting solution for the liquid phase separation dilemma

High-performance liquid chromatography (HPLC) is a well-established method in modern analysis. The method is simple, very robust and is applicable to the majority of components to be analyzed in contrast to gas chromatography. Low efficiency and small peak capacity are sore points of HPLC when complex mixtures have to be separated. The reason for this dilemma is the small diffusion coefficient of the analytes in the liquid mobile phase compared to a gaseous phase. This review, complemented by exemplary calculated data and some latest results of our own research, illustrates the dilemma of liquid phase chromatography to achieve high efficiencies under reasonable conditions. It is shown that (micellar) electrokinetic chromatography, offering fast and efficient separations, is a very promising solution for this dilemma. Additional features of this method are possibilities of on-line analyte concentration, coupling to mass spectrometry and the easy change of selectivities by applying various separation additives. The pros and cons of electrokinetic chromatography are pointed out and some application examples are given.

Characterization of the solvation environment provided by dilute aqueous solutions of novel siloxane polysoaps using the fluorescence probe pyrene

Solubilization environment afforded by several of the novel allyl glycidyl ether-modified methylhydrosiloxane polymers are investigated using a common polycyclic aromatic hydrocarbon fluorescence probe, pyrene. The backbone of the polymer has been modified by the addition of an alkyl chain of varying length (either C8, C12, or C18) and to differing degrees of substitution. The nomenclature adopted for the purposes of these studies is as follows: "AGENT" represents the backbone polymer with no alkyl substitution, and "OAGENT", "DAGENT", and "SAGENT" are substituted with n-octyl, n-dodecyl, and n-octadecyl, respectively. The percentage of alkyl substitution is designated as 10, 15, and 20%. The pyrene polarity scale (defined as the ratio of the intensity of peak I to peak III) was used to determine the relative dipolarity of the cybotactic region provided by approximately 1 w/w% aqueous polymer solutions compared to 10 mM sodium dodecylsulfate (SDS) micellar solution. Results indicate that 10-15% DAGENT afforded the most hydrophobic solubilization site, followed by 15% OAGENT and 15% SAGENT. In addition, as the degree of alkyl substitution of DAGENT increased from 10 to 20%, the cybotactic region appeared to become more hydrophobic. Furthermore, a deeper investigation into the relative size of the solubilization site revealed that all alkyl-substituted polymers promoted excimer formation at relatively low pyrene concentrations, indicating the possibility of localized concentration enhancement within the solvation pockets and/or compartmentalization of the solute molecules. The pyrene fluorescence excitation data strongly indicates ground-state heterogeneity that is most prominent in AGENT and decreases as the alkyl chain length is increased. This provides a relative sense of the size and shape of the solvation pockets afforded by each polymer solution. An overall analysis of the collected data indicated that these alkyl-substituted polymers may provide a more selective and efficient pseudostationary phase in electrokinetic chromatography with better solvation capacity for hydrophobic compounds compared to SDS.

Organically modified silica sol-mediated capillary electrophoresis

We describe in this paper the use of ormosil (organically modified silica) sols as additives to the run buffer for selectivity manipulations between solutes in capillary electrophoresis. CE systems that contain sol additives in the run buffer can be thought of as pseudocapillary electrochromatography. Three sols based on different types of silanes were studied. Methyltrimethoxysilane (MTMOS)-based sol was found to improve selectivities between various aromatic acids. Aminopropyltrimethoxysilane (APS) sol interacts differently with structural isomers of aromatic acids than does MTMOS. At low pH with APS sol in the run buffer, neutral solutes can be separated, as well. The separation of the neutral solutes seems to be facilitated by the formation of hydrogen bonds between the solutes and the APS sol. APS and N-[3-(trimethoxysilyl)propyl]-ethylenediamine (EDAS) affect the separation of the same compounds differently, thus indicating that even small changes of the functional groups of the sol have pronounced effect on the interactions between the sols and the solutes.

Novel alkyl-modified anionic siloxanes as pseudostationary phases for electrokinetic chromatography. III. Performance in organic-modified buffers

Anionic water-soluble siloxanes modified with different amounts of alkyl chains have been used as pseudostationary phases in electrokinetic chromatography. Ionic siloxane polymers with attached alkyl chains of C8 and C12 and having different alkyl chain densities have been employed previously to achieve selective and efficient separations with a range of electrophoretic mobilities and methylene selectivities. In this study, the performance of three alkyl-modified siloxanes is examined in different organic-modified buffers and at differing amounts of organic modifier. The organic modifiers used are acetonitrile and methanol. The siloxanes are stable in these organic solvents and show good mobility and good methylene selectivities even at high concentration of organic solvent. Siloxanes have also been used to separate a mixture of 14 polynuclear aromatic hydrocarbons in an acetonitrile-modified buffer.