Influence of the unpacked section on the chromatographic performance of duplex strong anion-exchange columns in capillary electrochromatography

Combination of chiral capillary electrochromatography with electrospray ionization mass spectrometry: method development and assay of warfarin enantiomers in human plasma

The hyphenation of chiral capillary electrochromatography (CEC) with electrospray ionization mass spectrometry (ESI-MS) is very challenging but promising due to the fact that it combines sensitivity with high specificity and selectivity. In this work, CEC capillaries packed with (3R,4S)-Whelk-O1 chiral stationary phase were used for simultaneous enantioseparation of (+/-)-warfarin and its internal standard, (+/-)-coumachlor. Furthermore, both the chiral CEC separation and MS detection parameters were examined in detail. First, the influence of different column fabrication was investigated. Second, enantioseparation was optimized by varying CEC parameters, including acetonitrile concentration, buffer pH, and ionic strength. Under the optimum chiral CEC conditions, ESI-MS parameters such as sheath liquid pH and composition, sheath liquid flow rate, drying gas flow rate, drying gas temperature, nebulizer pressure, and fragmentor voltage were investigated to achieve maximum MS signals of the separated enantiomers. Finally, using solid-phase extraction as sample preparation method, (+/-)-warfarin spiked in 100-microL human plasma samples were analyzed. The calibration curves showed good linearity for both (R)-warfarin (R = 0.9979) and (S)-warfarin (R = 0.9978) enantiomers. The experimental limit of detection was approximately 25 ng/mL for both enantiomers. Even though the data are still preliminary, we can state with confidence that chiral CEC-ESI-MS has the potential to establish itself as a very powerful technique for the determination of enantiomeric ratios in human body fluid.

Butyl acrylate porous polymer monoliths in fused-silica capillaries for use in capillary electrochromatography

Capillary electrochromatography incorporates features of both capillary electrophoresis and liquid chromatography. Butyl acrylate polymers, cast in-situ with heat initiated polymerization and no retaining frits have been made. Van Deemter plots of chrysene have been examined at a variety of operating temperatures to examine column behavior. Hmin moves to faster flow-rates and increases slightly in magnitude as temperature is increased. The longevity and reproducibility of the columns have been examined with a homologous series. Performance is very reproducible between two different columns of different diameters, operated on different systems and prepared from the same polymeriation batch. The relative standard deviation of retention factors is a maximum of 3.1% with most values calculated at less than 1%. The uniformity of the polymers as a function of length has also been studied with a series of polycyclic aromatic hydrocarbons, and the columns have proved to be very uniform across their length as measured by the consistency of retention factors with a maximum relative standard deviation of 3.4% and most values calculated between 1 and 2%. Plate numbers of between 65000 and 80000 plates/m have been attained for compounds with retention factors of 3 to 12. These columns have proved easy to make, are quite reproducible, and long lived.