Reducing residual silanol interactions in reversed-phase liquid chromatography

Experimental- and simulation-based investigations of coupling a mobile phase gradient with a continuous stationary phase gradient

This work seeks to explore and understand the effects of column orientation and degree of modification of continuous stationary phase gradient columns under a mobile phase gradient using both simulations and experiments. Peak parameters such as retention times, peak widths and resolution are obtained for five phenolic compounds on a C₁₈-silica gradient stationary phase. Simulations show that peak widths for the solutes are dependent upon the fractional composition of C₁₈ and orientation of the stationary phase gradient when coupled to a mobile phase gradient. Also, when compared to a simulated uniform mixed-mode column, peak widths reach a minimum on the gradient column with a coverage higher than 50% C₁₈ where the column is oriented to have the C₁₈ dense region at the end. Experimentally, continuous stationary phase gradients were fabricated to have a total C₁₈ composition of 78% of the original uniform column with an exponential profile using a previously described destructive controlled rate infusion method. Under gradient mobile phase conditions, experimental retention times for the gradient column showed a significant increase compared to the original 100% C₁₈ column. Simulations with a similar C₁₈ composition, however, predicted decreased retention times from the original C₁₈ column. A statistical increase in the retention time of protocatechuic acid and decrease in the peak width of tyrosol, caffeic acid, and coumaric acid were noted when the gradient column was oriented to have the C₁₈ dense region located near the detector. Collectively, combining gradients in both the mobile and stationary phases can yield interesting neighboring ligand effects and peak broadening/focusing effects.

Catalytic performance of gallium oxide based-catalysts for the propane dehydrogenation reaction: effects of support and loading amount

Ga₂O₃-based catalysts supported on different supports (ZSM-5, SBA-15, γ-Al₂O₃ and SiO₂) were prepared, and the effects of supports and Ga₂O₃ content (1–9 wt%) on their catalytic performance for the propane dehydrogenation reaction were discussed.

Ultrasonic-Assisted Synthesis of Twot-Butoxycarbonylamino Cephalosporin Intermediates on SiO2

Herein, we describe a facile and high efficient strategy for the synthesis of two forms of the 7β-t-butoxycarbonylamino-3-chloromethyl-3-cephem-4-carboxylates using ultrasonic irradiation. By SiO2as weak Lewis acid catalyst, 4-methoxybenzyl 7β-t-butoxycarbonylamino-3-chloromethyl-3-cephem-carboxylate (Boc-ACLE) and benzhydryl 7β-t-butoxycarbonylamino-3-chloromethyl-3-cephem-4-carboxylate (Boc-ACLH) were successfully synthesized through the efficient protection of theN-t-butoxycarbonyl (N-Boc), and the reactions occurred at low temperature requiring short reaction times and exhibiting excellent isolated yields (96% and 96.2%, resp.). The advantages of this reaction route including the usage of economical reagents and mild reaction conditions and high isolated yield make the two significantt-butoxycarbonylamino cephalosporin intermediates possible in large-scale production.

Sub 2-μm macroporous silica particles derivatized for enhanced lectin affinity enrichment of glycoproteins

A new, mechanically stable silica microparticle with macrosized internal pores (1.6 μm particles with 100 nm pores) has been developed for chromatography. The particles are characterized by an extensive network of interconnected macropores with a high intraparticle void volume, as observed by transmission electron microscopy (TEM). They are synthesized by an aerosol assembly technique called ultrasonic spray pyrolysis (USP). The particles have a high surface area for a macroporous material, ∼200 m(2)/g, making them suitable for large biomolecular separations. To demonstrate their potential for bioseparations, they have been functionalized with lectins for affinity enrichment of glycoproteins. The material was derivatized with two lectins, Concanavalin A (Con A) and Aleuria aurantia lectin (AAL), and binding properties were tested with standard glycoproteins. The columns exhibited excellent binding capacities for microaffinity enrichment: Con A was able to bind 75 μg of a standard glycoprotein in a 50 × 1 mm column. Following initial tests, the lectin microcolumns were utilized for enrichment of glycoproteins from 1 μL volumes of blood serum samples, performed in triplicate for each lectin. The enriched serum fractions were subjected to side-by-side glycomic and glycoproteomic profiling analyses with mass spectrometry to show that the new particles offer excellent sensitivity for microscale analyses of precious biological sample materials. The unique combination of the macroporous architecture and small particle diameter suggests the material may have advantages for conventional modes of chromatographic separation of macromolecules in an ultra-high-pressure liquid chromatography (UHPLC) format.

Annealing of silica to reduce the concentration of isolated silanols and peak tailing in reverse phase liquid chromatography

Non-porous, colloidal silica particles were annealed at three different temperatures, 800, 900 and 1050 °C. The adsorption of lysozyme, a probe of surface roughness, was consistent with progressively reduced surface roughness as temperature increased. The heat treated silica particles were rehydroxylated and then used to pack UHPLC columns. The cationic protein lysozyme was used to probe silanol activity, which exhibited progressively less tailing as the annealing temperature increased. FTIR spectroscopy confirmed that the abundance of isolated silanols on the surface was reduced by annealing at 900 °C or 1050 °C. FTIR also revealed that there was markedly increased hydrogen bonding of the isolated silanols to neighbors after rehydroxylation. These results combine to support the hypothesis that (a) isolated silanols on silica cause tailing in RP-LC and (b) nonplanar topography gives rise to isolated silanols.

Single-Molecule Probing of Adsorption and Diffusion on Silica Surfaces

Single-molecule spectroscopy has emerged as a valuable tool in probing kinetics and dynamic equilibria in adsorption because advances in instrumentation and technology have enabled researchers to obtain high signal-to-noise ratios for common dyes at room temperature. Single-molecule spectroscopy was applied to the study of an important problem in chromatography: peak broadening and asymmetry in the chromatograms of pharmaceuticals, peptides, and proteins. Using DiI, a cationic dye that exhibits the same problematic chromatographic behavior, investigators showed that the adsorption sites that cause chromatographic problems are located at defects on the silica crystal surface.

Unusual retention behaviour of 4-substituted piperidines on polybutadiene and polystyrene coated zirconia by comparison to reverse phase silica

The retention properties of a range of N-methylated and N-des-methyl 4-substituted piperidines on polybutadiene (PBD) and polystyrene (PS) coated zirconia have been studied and compared to those of Xterra RP(18) and Genesis C(18) silica. The effect of buffer type and pH are investigated with regard to the elution order on all three stationary phases. The change in the elution order is linked to the degree of substitution of the piperidine nitrogen and appears to be independent of the rest of the structure, indicating that this moiety is most heavily involved in the separation mechanism on the zirconia phases.

Surface-deposited acid/base on glass microfibers in formation of (3-aminopropyl)triethoxysilane-[2-(3,4-epoxycyclohexyl)ethyl]heptaisobutyloctasilsesquioxane bioverlay

Silanization of macroporous glass microfiber filters with (3-aminopropyl)triethoxysilane (APTES) and subsequent binding of [2-(3,4-epoxycyclohexyl)ethyl]heptaisobutyloctasilsesquioxane (E-POSS) to the amine-terminated surface of microfibers was studied. Prior to the silanization, minute quantities of concentrated aqueous solutions of hydrochloric acid or ammonia were adsorbed in the filters while attachment of E-POSS molecules to APTES overlay was not specially catalyzed. Analysis of DRIFT, XPS, and 13C CP/MAS NMR spectra has shown that the formation of APTES overlay is affected differently by the surface-deposited acid or base. It was proved by XPS that microfibers with the adsorbed acid take up higher amounts of covalently attached APTES by 42% and, subsequently, of E-POSS by 65% than microfibers with the adsorbed ammonia. The molecular mechanics model calculations, which were made using silica as a template, have shown that approximately two-layered APTES coating can be built on the model surface if complete hydrolysis of ethoxy groups and vertical condensation of APTES species are assumed.

Investigation of factors affecting the adsorption of functional molecules onto gel silicas

Flow microcalorimetry and infrared spectroscopy were used to study the surface structure and adsorptive properties of a series of calcined and uncalcined porous silicas. The adsorbates DL-menthol, (R)-(+)-limonene, (+/-)-citronellal and carvone were selected for their functionality, that included carbonyl, vinylic and hydroxyl groups. The amounts of probe retained by the silicas together with the energy exchange involved in the adsorption/desorption process were determined by flow microcalorimetry. The functional groups involved in these interactions were studied by means of infrared spectroscopy. It was observed that the strongest interactions with the silica surface took place through hydrogen bonding onto the surface silanol. The most retentive probes were found to be those with a carbonyl group in their structure. Adsorption onto calcined silicas was found to be less energetic than onto the equivalent calcined samples. The adsorption densities were compared with theoretical predictions based on molecular models. In all cases apart from citronellal monolayer coverage were not observed due to steric effects.

Combining capillary electrophoresis with mass spectrometry for applications in proteomics

Mass spectrometry (MS)-based proteomics is currently dominated by the analysis of peptides originating either from digestion of proteins separated by two-dimensional gel electrophoresis (2-DE) or from global digestion; the simple peptide mixtures obtained from digestion of gel-separated proteins do not usually require further separation, while the complex peptide mixtures obtained by global digestion are most frequently separated by chromatographic techniques. Capillary electrophoresis (CE) provides alternatives to 2-DE for protein separation and alternatives to chromatography for peptide separation. This review attempts to elucidate how the most promising CE modes, capillary zone electrophoresis (CZE) and capillary isoelectric focusing (CIEF), might best be applied to MS-based proteomics. CE-MS interfacing, mass analyzer performance, column coating to minimize analyte adsorption, and sample stacking for CZE are considered prior to examining numerous applications. Finally, multidimensional systems that incorporate CE techniques are examined; CZE often finds use as a fast, final dimension before ionization for MS, while CIEF, being an equilibrium technique, is well-suited to being the first dimension in automated fractionation systems.

Probing Strong Adsorption of Solute onto C18-Silica Gel by Fluorescence Correlation Imaging and Single-Molecule Spectroscopy under RPLC Conditions

Understanding molecular adsorption at a chromatographic interface is of great interest for addressing the tailing problem in chemical separations. Single-molecule spectroscopy and confocal fluorescence correlation imaging are used to study the adsorption sites of C(18) silica beads under RPLC chromatographic conditions. The experiments show that cationic molecule rhodamine 6G laterally diffuses through the chromatographic interface of a C(18) hydrocarbon monolayer and acetonitrile with occasional reversible strong adsorptions. Fluorescence correlation imaging extracts the rare strong adsorption events from large data sets, revealing that the strong adsorption sites are randomly distributed throughout the silica beads. Virtually every imaging pixel of silica beads adsorbs molecules. Single-molecule spectroscopy of the 584 strong adsorption events observed indicates that the strong adsorptions persist on the time scales from several milliseconds to seconds, having an average desorption time of 61 ms. The strong adsorption events are rare, comprising 0.3% of the total observation time. The sizes of strong adsorption sites are within the optical resolution of confocal imaging.