Preparation of an IMI dye (imidazole functional group) containing a 4-(N,N-dimethylaminosulfonyl)-2,1,3-benzoxadiazole fluorophore for labeling of phosphomonoesters

Capillary electrophoretic method for nucleotide analysis in cells: application on inherited metabolic disorders

Purine and pyrimidine nucleotides influence many metabolic pathways and their analogs have been widely used in medicine. A capillary electrophoretic method was developed for measuring intracellular nucleotides. The final BGE consisted of 40 mM citric acid with addition of 0.8 mM CTAB titrated by gamma-aminobutyric acid to pH 4.4. The electrophoretic separations were carried out in an uncoated silica capillary (id/od - 75/375 microm; effective/total length - 90/97 cm). The method allows a complete separation of 21 nucleotides and deoxynucleotides within 15 min with separation efficiencies up to 400,000 theoretical plates per meter. Due to the use of an acidic separation medium, the method offers a high selectivity toward the studied analytes versus possible interferences from matrices. Sample preparation was optimized in order to shorten work-time and prevent analyte degradation. The method was applied for analyzing nucleotides in human erythrocytes and Chinese hamster ovary cells. Diagnostic potential for inherited metabolic disorders of nucleotide metabolism is presented.

Detection and separation of nucleoside-5'-monophosphates of DNA by conjugation with the fluorescent dye BODIPY and capillary electrophoresis with laser-induced fluorescence detection

We investigated the separation and detection of the 5'-monophosphates of 2'-deoxynucleosides selectively conjugated with 4,4-difluoro-5,7-dimethyl-4-bora-3a,4a-diaza-s-indacene-3-propionyl ethylene diamine hydrochloride (BODIPY FL EDA) at the 5'-phosphate group using capillary electrophoresis with laser-induced fluorescence detection (CE-LIF). BODIPY conjugates of the four common deoxynucleoside-5'-monophosphates (2'-deoxyguanosine-5'-monophosphate, 2'-deoxyadenosine-5'-monophosphate, 2'-deoxycytidine-5'-monophosphate, and thymidine-5'-monophosphate) were prepared and subjected to CE-LIF to serve as standard compounds for peak assignment and to develop separation conditions for the analysis of DNA. BODIPY conjugates were detected and resolved by CE-LIF after digestion of DNA or an oligonucleotide to 5'-monophosphates by nuclease P1 (NP 1) and fluorescence labeling without further purification step. Comparative analyses of calf-thymus DNA digested either with micrococcal nuclease/spleen phosphodiesterase to 3'-monophosphates or with NP 1 to 5'-monophosphates showed that both versions of the fluorescence postlabeling assay were equally efficient and sensitive. Moreover, using the same assay, 2'-deoxyuridine and 2'-deoxy-5methylcytidine were identified in bisulfite treated DNA after NP 1 digestion indicating that fluorescence postlabeling of 2'-deoxyribonucleoside-5'-monophosphates with BODIPY FL EDA and detection by CE-LIF has the potential to determine DNA damage and genomic DNA methylation.

Investigation of fractions present in the stem bark of Annickia kummeriae on their P-glycoprotein inhibitory pump activity

Using MCF-7R cells and rhodamine 6G as the fluorescent probe, a bioassay-targeted purification process was pursued in order to isolate the active P-gp inhibitory fractions from Annickia kummeriae. Of 24 fractions obtained in the first preparative liquid chromatography (p-LC) run, only fraction 1 exhibited activity. Further p-LC fractionation led to the separation of fraction 1 into fractions 1.1-1.8. Fractions 1.4, 1.5 and 1.6 proved to be active by inducing a significant accumulation of rhodamine 6G by 3.3-, 4.5- and 4.9-fold at 10 microg/mL, and by 5.3-, 6.3- and 6.8-fold at 100 microg/mL, respectively. Fraction 1.6 was separated into several fractions by using an analytical liquid chromatography (a-LC) system. Fractions 1.6.18, 1.6.19 and 1.6.20 were active and they induced an accumulation of rhodamine 6G by 3.0-, 1.8- and 3.5-fold at 1x microg/mL and by 4.8-, 6.7- and 6.8-fold at 10x microg/mL, respectively. Afterwards, 28.3 mg of fraction 1.6 was processed by a-LC, and fractions 1.6.18, 1.6.19 and 1.6.20 were collected separately and dried. The amounts of materials recovered were 6.2, 7.4 and <1 mg, corresponding to 21.9%, 26.1% and <3.5% of fraction 1.6, respectively. From the total amount injected and the relative masses represented by these fractions, it can be calculated that the 1x microg/mL level corresponded to ca. 35, 42 and <5 microg/mL, respectively. Fluorescence microscopy revealed that incubation of the cells with rhodamine 6G alone did not show any fluorescence, whereas cells which were incubated in medium containing rhodamine 6G together with fraction 1.4, 1.6 or reserpine, clearly indicated accumulation of the dye intracellularly. This is an indication that the active compounds effected high intracellular fluorescence by inducing accumulation of the dye in the cells through inhibition of the P-gp pump.

Separation procedures capable of revealing DNA adducts

Detection and quantification of DNA adducts are very important in relation to diseases such as cancer. Both high sensitivity and high selectivity are required for the detection of DNA adducts because the content of adducts in DNA is very small compared with those of normal bases and only small amounts of DNA samples are available for analysis in general cases. In this paper are described separation procedures such as liquid chromatography, gas chromatography and capillary electrophoresis combined with a detection and identification method such as 32P-postlabeling, mass spectrometry, electrochemical detection, fluorescence detection and immunoassay. The merits and demerits of the procedures are also discussed.

Synthesis of probes with broad pH range fluorescence

Reaction of a rhodamine 2'-ester with an excess of alkyldiamines provides amino-functionalized rhodamine spirolactams, which when subsequently conjugated with carboxyfluorescein, provides probes which are fluorescent at acidic, neutral, and basic pH ranges.

Fluorogenic and fluorescent labeling reagents with a benzofurazan skeleton

Fluorogenic and fluorescent labeling reagents having a benzofurazan (2,1,3-benzoxadiazole) skeleton such as 4-fluoro-7-nitro-2,1,3-benzoxadiazole (NBD-F), 4-N,N-dimethylaminosulfonyl-7-fluoro-2,1,3-benzoxadiazole (DBD-F), 4-aminosulfonyl-7-fluoro-2,1,3-benzoxadiazole (ABD-F), ammonium 7-fluoro-2,1,3-benzoxadiazole-4-sulfonate (SBD-F), 4-hydrazino-7-nitro-2,1,3-benzoxadiazole (NBD-H), 4-N,N-dimethylaminosulfonyl-7-hydrazino-2,1,3-benzoxadiazole (DBD-H), 4-nitro-7-N-piperazino-2,1,3-benzoxadiazole (NBD-PZ), 4-N,N-dimethylaminosulfonyl-7-N-piperazino-2,1,3-benzoxadiazole (DBD-PZ), 4-(N-chloroformylmethyl-N-methyl)amino-7-N,N-dimethylaminosulfonyl-2,1,3-benzoxadiazole (DBD-COCl) and 7-N,N-dimethylaminosulfonyl-4-(2,1,3-benzoxadiazolyl) isothiocyanate (DBD-NCS) are reviewed in terms of synthetic method, reactivity, fluorescence characteristics, sensitivity and application to analytes.

Derivatization trends in capillary electrophoresis

This survey gives an overview of recent derivatization protocols, starting from 1996, in combination with capillary electrophoresis (CE). Derivatization is mainly used for enhancing the detection sensitivity of CE, especially in combination with laser-induced fluorescence. Derivatization procedures are classified in tables in pre-, on- and postcapillary arrangements and, more specifically, arranged into functional groups being derivatized. The amine and reducing ends of saccharides are reported most frequently, but examples are also given for derivatization of thiols, hydroxyl, carboxylic, and carbonyl groups, and inorganic ions. Other reasons for derivatization concern indirect chiral separations, enhancing electrospray characteristics, or incorporation of a suitable charge into the analytes. Special attention is paid to the increasing field of research using on-line precapillary derivatization with CE and microdialysis for in vivo monitoring of neurotransmitter concentrations. The on-capillary derivatization can be divided in several approaches, such as the at-inlet, zone-passing and throughout method. The postcapillary mode is represented by gap designs, and membrane reactors, but especially the combination of separation, derivatization and detection on a chip is a new emerging field of research. This review, which can be seen as a sequel to our earlier reported review covering the years 1991-1995, gives an impression of current derivatization applications and highlights new developments in this field.