The effect of pH on the electrochemical polymerisation of pyrrole on aluminium

Switchable presentation of cytokines on electroactive polypyrrole surfaces for hematopoietic stem and progenitor cells

Hematopoietic stem cells are used in transplantations for patients with hematologic malignancies. Scarce sources require efficient strategies of expansion, including polymeric biomaterials mimicking architectures of bone marrow tissue. Tissue microenvironment and mode of cytokine presentation strongly influence cell fate. Although several cytokines with different functions as soluble or membrane-bound mediators have already been identified, their precise roles have not yet been clarified. A need exists for in vitro systems that mimic the in vivo situation to enable such studies. One way is to establish surfaces mimicking physiological presentation using protein-immobilization onto polymer films. However these films merely provide a static presentation of the immobilized proteins. It would be advantageous to also dynamically change protein presentation and functionality to better reflect the in vivo conditions. The electroactive polymer polypyrrole shows excellent biocompatibility and electrochemically alters its surface properties, becoming an interesting choice for such setups. Here, we present an in vitro system for switchable presentation of membrane-bound cytokines. We use interleukin IL-3, known to affect hematopoiesis, and show that when immobilized on polypyrrole films, IL-3 is bioavailable for the bone marrow-derived FDC-P1 progenitor cell line. Moreover, IL-3 presentation can be successfully altered by changing the redox state of the film, in turn influencing FDC-P1 cell viability. This novel in vitro system provides a valuable tool for stimuli-responsive switchable protein presentation allowing the dissection of relevant mediators in stem and progenitor cell behavior.

Solvent effects on electrosynthesis, morphological and electrochromic properties of a nitrogen analog of PEDOT

A new nitrogen analog of 3,4-ethylenedioxythiophene (EDOT), N-methyl-3,4-dihydrothieno[3,4-b][1,4]oxazine (MDTO), was electropolymerized in different solvents (deionized water, acetonitrile, and propylene carbonate) using LiClO4 as the electrolyte. The structure and performance of as-prepared PMDTO polymers were systematically studied by cyclic voltammetry, UV-vis spectroscopy, FT-IR, SEM, thermogravimetry, spectroelectrochemistry and electrochromic techniques. To our surprise, solvents had a major influence on the electropolymerization of MDTO and properties of the resultant polymers, including morphology, electrochemistry, electronic and optical properties, and electrochromics, etc. In aqueous solution, MDTO revealed the lowest onset oxidation potential (0.19 V) than in acetonitrile (0.48 V) and propylene carbonate (0.49 V). However, PMDTO films showed rather poor cycling stability in water, while outstanding stability in acetonitrile and propylene carbonate. Films prepared in propylene carbonate displayed a rather smooth morphology, lower band gap (1.65 eV), higher transparency (97.3%) and a contrast ratio (44.6%) at λ = 466 nm. PMDTO films obtained in acetonitrile showed significantly higher coloration efficiency (169.5 cm(2) C(-1)) than in other two solvents (∼ 97.6 cm(2) C(-1)) with a moderate contrast ratio (24.5%).