Selective two-phase-hydrogenation of sorbic acid with novel water soluble ruthenium complexes

The daphniphyllum alkaloids: total synthesis of (-)-calyciphylline N

Presented here is a full account on the development of a strategy culminating in the first total synthesis of the architecturally complex daphniphyllum alkaloid, (-)-calyciphylline N. Highlights of the approach include a highly diastereoselective, intramolecular Diels-Alder reaction of a silicon-tethered acrylate; an efficient Stille carbonylation of a sterically encumbered vinyl triflate; a one-pot Nazarov cyclization/proto-desilylation sequence; and the chemoselective hydrogenation of a fully substituted diene ester.

[Cp*Ru]-catalyzed selective coupling/hydrogenation

Selective coupling and hydrogenation catalyzed by [Cp*Ru] have been achieved affording valuable polyfunctionalized cyclic enamide derivatives.

Water-soluble Mo3S4 clusters bearing hydroxypropyl diphosphine ligands: synthesis, crystal structure, aqueous speciation, and kinetics of substitution reactions

The [Mo(3)S(4)Cl(3)(dhprpe)(3)](+) (1(+)) cluster cation has been prepared by reaction between Mo(3)S(4)Cl(4)(PPh(3))(3) (solvent)(2) and the water-soluble 1,2-bis(bis(hydroxypropyl)phosphino)ethane (dhprpe, L) ligand. The crystal structure of [1](2)[Mo(6)Cl(14)] has been determined by X-ray diffraction methods and shows the typical incomplete cuboidal structure with a capping and three bridging sulfides. The octahedral coordination around each metal center is completed with a chlorine and two phosphorus atoms of the diphosphine ligand. Depending on the pH, the hydroxo group of the functionalized diphosphine can substitute the chloride ligands and coordinate to the cluster core to give new clusters with tridentate deprotonated dhprpe ligands of formula [Mo(3)S(4)(dhprpe-H)(3)](+) (2(+)). A detailed study based on stopped-flow, (31)P{(1)H} NMR, and electrospray ionization mass spectrometry techniques has been carried out to understand the behavior of acid-base equilibria and the kinetics of interconversion between the 1(+) and the 2(+) forms. Both conversion of 1(+) to 2(+) and its reverse process occur in a single kinetic step, so that reactions proceed at the three metal centers with statistically controlled kinetics. The values of the rate constants under different conditions are used to discuss on the mechanisms of opening and closing of the chelate rings with coordination or dissociation of chloride.

Synthesis, Crystal Structure, Aqueous Speciation, and Kinetics of Substitution Reactions in a Water-Soluble Mo3S4 Cluster Bearing Hydroxymethyl Diphosphine Ligands

The [Mo3S4Cl3(dhmpe)3]Cl ([1]Cl) cluster has been prepared from [Mo3S7Cl6]2- and the water-soluble 1,2-bis(bis(hydroxymethyl)-phosphino)ethane (dhmpe, L) ligand. The crystal structure has been determined by X-ray diffraction methods and shows the incomplete cuboidal structure typical of the M3Q4 clusters (M=Mo, W; Q=S, Se), with a capping sulfide ligand to the three metal centers and the other three sulfides acting as bridges between two Mo atoms. The octahedral coordination around each metal center is completed with a chlorine and two phosphorus atoms of one L ligand. The chemistry of aqueous solutions of [1]Cl is dominated by the formation of the [Mo3S4L(L-H)2(H2O)]2+ complex ([2]2+), where the three chlorides have been replaced by one water molecule and two alkoxo groups of two different dhmpe ligands, thus leading to a solution structure where the three metal centers are not equivalent. A detailed study based on stopped-flow, 31P{1H} NMR, and electrospray ionization mass spectrometry techniques has been carried out to understand the behavior of [2]2+ in aqueous solution. In this way, it has been established that the addition of an excess of X- (Cl-, SCN-) leads to [Mo3S4X3(dhmpe)3]+ complexes in three resolved kinetic steps that correspond to the sequential coordination of X- at the three metal centers. However, whereas the first two steps involve the opening of the chelate rings formed with the alkoxo groups of the dhmpe ligands, the third one corresponds to the substitution of the coordinated water molecule. These results demonstrate that the asymmetry introduced by the closure of chelate rings at only two of the three Mo centers makes the kinetics of the reaction deviate significantly from the statistical behavior typically associated with M3Q4 clusters. The results obtained for the reaction of [2]2+ with acid and base are also described, and they complete the picture of the aqueous speciation of this cluster.

Synthesis of Ruthenium(II) Complexes Containing Hydroxymethylphosphines and Their Catalytic Activities for Hydrogenation of Supercritical Carbon Dioxide

Ligand substitution of RuCl2[P(C6H5)3]3 and Cp*RuCl(isoprene) (Cp*=1,2,3,4,5-pentamethylcyclopentadienyl) complexes with hydroxymethylphosphines was investigated to develop new catalyst systems for CO2 hydrogenation. A reaction of P(C6H5)2CH2OH with RuCl2[P(C6H5)3]3 in CH2Cl2 gave Ru(H)Cl(CO)[P(C6H5)2CH2OH]3 (1), which was characterized by NMR spectroscopy and X-ray crystallographic analysis. An isotope labeling experiment using P(C6H5)213CH2OH indicated that the carbonyl moiety in complex 1 originated from formaldehyde formed by degradation of the hydroxymethylphosphine. Elimination of formaldehyde from PCy2CH2OH (Cy=cyclohexyl) was also promoted by treatment of RuCl2[P(C6H5)3]3 in ethanol to give RuCl2(PHCy2)4 under mild conditions. On the other hand, the substitution reaction using Cp*RuCl(isoprene) with the hydroxymethylphosphine ligands proceeded smoothly with formation of Cp*RuCl(L)2 [2a-2c; L=P(C6H5)2CH2OH, PCy(CH2OH)2, and P(CH2OH)3] in good yields. The isolable hydroxymethylphosphine complexes 1 and 2 efficiently catalyzed the hydrogenative amidation of supercritical carbon dioxide (scCO2) to N,N-dimethylformamide (DMF).

Substitution and derivatization reactions of a water soluble iron(ii) complex containing a self-assembled tetradentate phosphine ligand

Facile substitution reactions of the two water ligands in the hydrophilic tetradentate phosphine complex cis-[Fe{(HOCH2)P{CH2N(CH2P(CH2OH)2)CH2}2P(CH2OH)}(H2O)2](SO4) (abbreviated to [Fe(L1)(H2O)2](SO4), 1) take place upon addition of Cl-, NCS-, N3(-), CO3(2-) and CO to give [Fe(L1)X2] (2, X = Cl; 4, X = NCS; 5, X=N3), [Fe(L1)(kappa2-O(2)CO)], 6 and [Fe(L1)(CO)2](SO4), 7. The unsymmetrical mono-substituted intermediates [Fe(L1)(H2O)(CO)](SO(4)) and [Fe(L(1))(CO)(kappa(1)-OSO(3))] (8/9) have been identified spectroscopically en-route to 7. Treatment of 1 with acetic anhydride affords the acylated derivative [Fe{(AcOCH2)P{CH2N(CH2P(CH2OAc)2)CH2}2P(CH2OAc)}(kappa2-O(2)SO2)] (abbreviated to [Fe(L2)(kappa2-O(2)SO2)], 10), which has increased solubility over 1 in both organic solvents and water. Treatment of 1 with glycine does not lead to functionalisation of L1, but substitution of the aqua ligands occurs to form [Fe(L(1))(NH(2)CH(2)CO(2)-kappa(2)N,O)](HSO(4)), 11. Compound 10 reacts with chloride to form [Fe(L(2))Cl(2)] 12, and 12 reacts with CO in the presence of NaBPh4 to form [Fe(L2)Cl(CO)](BPh4) 13b. Both of the chlorides in 12 are substituted on reaction with NCS- and N3(-) to form [Fe(L2)(NCS)2] 14 and [Fe(L2)(N3)2] 15, respectively. Complexes 2.H2O, 4.2H2O, 5.0.812H2O, 6.1.7H2O, 7.H2O, 10.1.3CH3C(O)CH3, 12 and 15.0.5H2O have all been crystallographically characterised.

Reactivity of Oxide Precursor States on Ru(0001)

Smooth and defect-rich Ru(0001) surfaces prepared under ultrahigh-vacuum (UHV) conditions have been loaded with oxygen under high-pressure (p </= 1 bar) and low-temperature (T < 550 K) conditions. On these surfaces the CO oxidation reaction has been investigated by means of thermal desorption spectroscopy (TDS), ultraviolet photoelectron spectroscopy (UPS) and reactive molecular beam scattering (RMBS). Both surfaces are oxide-free and exhibit a high reactivity. The maximum CO/CO(2) conversion probability observed for a defect-rich Ru(0001) surface amounts to 6 x 10(-3) and is comparable to that of a surface covered with rutile RuO(2)(110) domains. RMBS experiments led to the identification of three different reaction channels. The first and second channel is related to CO adsorbing at oxygen-free defect sites and follow the Langmuir-Hinshelwood mechanism. Whereas the first reaction channel is already observed at room temperature, the second is thermally activated, contributing to the CO(2) yield only for reaction temperatures above 400 K. The third channel is due to the recombination of CO molecules with oxygen atoms located in smooth areas of the surface undisturbed by defects. This reaction channel is thermally activated as well.

Water-soluble ruthenium(ii) catalysts [RuCl2(η6-arene){P(CH2OH)3}] for isomerization of allylic alcohols and alkyne hydration

The novel water-soluble ruthenium(II) complexes [RuCl(2)(eta(6)-arene)[P(CH(2)OH)(3)]]2a-c and [RuCl(eta(6)-arene)[P(CH(2)OH)(3)](2)][Cl]3a-c have been prepared in high yields by reaction of dimers [[Ru(eta(6)-arene)(micro-Cl)Cl](2)](arene = C(6)H(6)1a, p-cymene 1b, C(6)Me(6)1c) with two or four equivalents of P(CH(2)OH)(3), respectively. Complexes 2/3a-c are active catalysts in the redox isomerization of several allylic alcohols into the corresponding saturated carbonyl compounds under water/n-heptane biphasic conditions. Among them, the neutral derivatives [RuCl(2)(eta(6)-C(6)H(6))[P(CH(2)OH)(3)]]2a and [RuCl(2)(eta(6)-p-cymene)[P(CH(2)OH)(3)]]2b show the highest activities (TOF values up to 600 h(-1); TON values up to 782). Complexes 2/3a-c also catalyze the hydration of terminal alkynes.

Ionic Liquids-New "Solutions" for Transition Metal Catalysis

Ionic liquids are salts that are liquid at low temperature (<100 degrees C) which represent a new class of solvents with nonmolecular, ionic character. Even though the first representative has been known since 1914, ionic liquids have only been investigated as solvents for transition metal catalysis in the past ten years. Publications to date show that replacing an organic solvent by an ionic liquid can lead to remarkable improvements in well-known processes. Ionic liquids form biphasic systems with many organic product mixtures. This gives rise to the possibility of a multiphase reaction procedure with easy isolation and recovery of homogeneous catalysts. In addition, ionic liquids have practically no vapor pressure which facilitates product separation by distillation. There are also indications that switching from a normal organic solvent to an ionic liquid can lead to novel and unusual chemical reactivity. This opens up a wide field for future investigations into this new class of solvents in catalytic applications.