Electron microscopic cytochemical study of cell-wall polysaccharides in Bacillus subtilis and two strains of Bacillus megaterium

ClpE, a novel member of the HSP100 family, is involved in cell division and virulence of Listeria monocytogenes

We identified, in the facultative intracellular pathogen Listeria monocytogenes, a previously unknown Clp ATPase, unique among the HSP100 proteins because of the presence of a short N-terminal region with a potential zinc finger motif. This protein of 726 amino acids is highly homologous to ClpE of Bacillus subtilis, and is a member of a new subfamily of HSP100/Clp ATPases. The clpE gene is transcribed as a monocistronic mRNA from a typical consensus sigma A promoter. clpE is not stimulated by various stresses, but is upregulated in a clpC mutant. This is the first example of cross-regulation between Clp ATPases. By constructing a clpE mutant of L. monocytogenes, we found that ClpE is required for prolonged survival at 42 degrees C and is involved in the virulence of this pathogen. A double mutant deficient in both ClpE and ClpC was avirulent in a mouse model and completely eliminated in the liver. Electron microscopy studies did not show any morphological alterations in clpE or clpC mutants. In the clpE-clpC double mutant, however, cell division was affected, indicating that ClpE acts synergistically with ClpC in cell septation. These results show that the Clp chaperones play a crucial role in both cell division and virulence of L. monocytogenes.

Transformation efficiency of EMS-induced mutants of Streptococcus mutans of altered cell shape

Some Streptococcus mutans strains change shape from bacillary to coccal or ellipsoid form in response to the ratio of bicarbonate to potassium or of borate to potassium in growth media. So that insight into determinants of shape of these streptococci could be gained, and future genetic studies facilitated, the shapes of a series of transformable and nontransformable strains of S. mutans were studied and attempts made to isolate a mutant of augmented transformability. Several strains were mutagenized by ethylmethane sulfonate and mutants with altered colonial and cellular morphologies isolated. Cell shapes were studied by Gram stain and Nomarski interference microscopy, and by scanning and transmission electron microscopy. Diverse shape-altered mutants were isolated from seven transformable and two nontransformable strains of S. mutans. Among these, length-to-width ratios ranged from > 10 to about 0.25. Regulation of timing of cell division, septum formation, or septum completion events may have been altered in these mutants. While most mutants substantially or completely lost transformability, mutant LT11 had transformation efficiency of 1.3 x 10(-4) to 2.3 x 10(-3), more than two to three orders of magnitude greater than its parental UA159 and the well-known transformable strain GS5(HK), respectively. There was no evidence of production of competence factor by LT11. Competence of LT11 was maintained for at least six months upon storage at -70 degrees C, facilitating its use for genetic studies. While the morphologies of several shape-altered mutants were no longer responsive to changes of the bicarbonate/potassium, unlike those of their parentals, the morphology of LT11 persisted in its response to this condition.(ABSTRACT TRUNCATED AT 250 WORDS)

Factors influencing cell shape in the mutans group of streptococci

Electron and light microscopic and growth studies of representatives of the diverse species of mutans streptococci revealed the cells to be either bacillary or coccoid in shape. Some strains changed from bacillary to coccoid if the HCO3-/K+ ratio of the media was increased and from coccoid to bacillary if the ratio was decreased. Doubling times of rods and cocci were the same despite an HCO3-/K+ ratio change between 0.008 and 2.84. For strain 10449S, no tested anions or cations substituted for HCO3- or K+ to produce this effect, except for B4O7(2-). Strain 10449S grown at a high B4O7(2-)/K+ ratio became ellipsoid, and this phenomenon was associated with slower doubling times. Up to three incomplete septa could be observed in one rod, but no more than one incomplete septum could be observed in either ellipsoid or spherical cells. Interseptal distances were greatest in rods, shorter in spheres, and shortest in ellipses. All of the above differences were statistically significant (P less than 0.001).

Ultrastructural localization of carbohydrates on thin sections of Staphylococcus aureus with silver methenamine and wheat germ agglutinin-gold complex

Postembedding staining of intracellular carbohydrates on thin sections of Staphylococcus aureus was studied by the silver methenamine and the wheat germ agglutinin-gold techniques. Staining of silver grains was observed on both the cell wall and the cross wall. The staining was interpreted to be due to teichoic acid. Labeling by wheat germ agglutinin-gold particles was observed on both the cell wall and the cross wall, and the staining pattern resembled that of silver methenamine staining. Therefore, the labeling was considered to be due to N-acetylglucosamine of teichoic acid. The combination of two types of cytochemical techniques was useful to localize and characterize the carbohydrates of the bacterial cell.

Cytochemical localization of lipopolysaccharides during peptidoglycan degradation of Escherichia coli cells

The cytochemical reaction of Thiery [J. P. Thiery, J. Microsc. (Paris) 6:987-1018, 1976] was applied to several Escherichia coli strains having different lipopolysaccharide molecular structures. The granular deposit obtained strongly suggested that part of the R core exposed on the outer membrane was responsible for the staining. As this procedure specifically stains the outer membrane, it was possible to demonstrate that, in E. coli K-12, changes in lipopolysaccharide distribution occurred during autolysis and lysozyme treatment.

Correlation between degradation and ultrastructure of peptidoglycan during autolysis of Escherichia coli

The kinetics of peptidoglycan degradation were examined under different conditions of autolysis of Escherichia coli. With cephaloridine- or moenomycin-induced autolysis, degradation did not exceed 25 to 35%, whereas in EDTA-induced autolysis it rapidly reached 65 to 70%. When nonautolyzing cells were fixed overnight with glutaraldehyde, followed by an osmium fixation, and thin sections were stained by the phosphotungstic acid method, a dark, 15-nm-thick layer of uniform appearance and constant width occupied the whole area between the inner and outer membranes of the envelope. The stained material was tentatively identified with peptidoglycan. Ultrastructural changes in this phosphotungstic acid-stained periplasmic space were investigated at different time intervals after induction of autolysis. In all cases, breakdown proceeded over the whole cell surface. During antibiotic-induced autolysis a progressive thinning down limited to the inner side of the layer was observed. During EDTA-induced autolysis, the rapid decrease in thickness correlated well with the important loss of material labeled with [3H]diaminopimelic acid. Considering these changes and the insufficient amounts of peptidoglycan (1.3 U/nm2) necessary to account for a regularly structured polymer occupying the whole 15-nm layer, it was speculated that peptidoglycan might be unevenly distributed throughout the periplasmic space.