Toughening of polypropylene by different elastomeric systems

Impact Modification of Isotactic Polypropylene with Ethylene-Propylene Diene Monomer Rubber

The present work was done to improve the impact property of isotactic polypropylene (PP), especially at low temperatures, by incorporating ethylene propylene diene monomers (EPDM). This was done by ensuring compatibility between the two polymers with phase modifiers polyethylene grafted with maleic anhydride (PE-g-MA) and initiator dicumyl peroxide (DCP). In addition, attempts were also made to understand the fundamentals of impact toughening as well as fracture toughness, and to correlate the results with that of morphological evidences obtained from scanning electron microscopy (SEM) and X-ray diffraction (XRD) methods. Varying the ratios of all blend composition, mechanical properties were studied. It was observed that as the rubber fraction increased, the impact property as well as fracture toughness increased. All these tests also showed promising results when PE-g-MA was added, leading to more improvement in all the mechanical properties including increase in crystallite size. It had shown plasticization effect on the compositions, which could be further confirmed by differential scanning calorimetry (DSC) compared to the uncompatibilized ones. But when DCP was added, it behaved like an initiator which directly reacted with the PP matrix, decreasing the molecular weight of the blend with decreasing size of the crystallites.

Largely improved fracture toughness of an immiscible poly(l-lactide)/ethylene-co-vinyl acetate blend achieved by adding carbon nanotubes

Through the bridging effect of CNTs, the fracture toughness of the immiscible PLLA/EVA blend was greatly improved.

Propriedades mecânicas e morfologia de blendas de polipropileno com Tpes

Blendas de polipropileno e elastômeros termoplásticos (TPEs), estireno-b-butadieno-b-estireno (SBS) e estireno-b-etileno-co-butileno-b-estireno(SEBS) foram preparadas com o objetivo de avaliar a influência do tipo e da concentração do elastômero nas propriedades mecânicas e na morfologia das blendas. Foram utilizados dois tipos de polipropileno, um homopolímero de propileno (PP-H) e um copolímero randômico de propileno-etileno (PP-R), sendo avaliado também o efeito das características da matriz termoplástica. O elastômero termoplástico aumentou a resistência ao impacto do PP, e a variação da rigidez das blendas foi dependente somente da quantidade de TPE adicionada, sendo estas comparativamente mais rígidas que aquelas com igual teor de elastômero convencional, tipo EPDM e EPR. A blenda com melhor balanço rigidez-impacto foi aquela de PP-R com 10% de SEBS. As blendas do copolímero de propileno-etileno com os TPEs apresentaram maior deformação do que aquelas com o homopolímero, devido à natureza menos cristalina da matriz do copolímero de propileno. As blendas tanto do homo quanto do copolímero de propileno com SEBS ficaram mais homogêneas em função da maior afinidade do bloco central poliolefínico EB (etileno-co-butileno) do primeiro com a região amorfa da matriz, sendo esta mais significativa no PP-R.