Zones of representation for PM10 measurements along the US/Mexico border

Spectral imaging and passive sampling to investigate particle sources in urban desert regions

Two types of electron microscopy analyses were employed along with geographic information system (GIS) mapping to investigate potential sources of PM2.5 and PM10 (airborne particulate matter smaller than 2.5 and 10 μm, respectively) in two urbanized desert areas known to exhibit PM excursions. Integrated spectral imaging maps were obtained from scanning electron microscopy/energy-dispersive X-ray spectroscopy (SEM/EDS) analyses of 13 filters collected in Imperial Valley, California. Seven were from 24 h PM10 Federal Reference Method (FRM) samplers and six were from PM2.5 FRM samplers. This technique enabled extraction of information from particles collected on complex filter matrices, and indicated that all samples exhibited substantial proportions of crustal particles. Six Imperial PM2.5 and PM10 filters selected from unusually high-PM days exhibited more large particles (2.5-15 and 10-30 μm, respectively) than did filters from low-PM days, and were more consistent with soils analyzed from the region. High winds were present on three of the six high-PM days. One of the high-PM2.5 filters also exhibited substantial fine carbonaceous soot PM, suggesting significant contributions from a combustion source. Computer-controlled SEM/EDS (CCSEM/EDS) was conducted on PM collected with UNC Passive samplers from Phoenix, Arizona. The passive samplers showed good agreement with co-located FRM PM10 and PM2.5 measurements (μg m(-3)), and also enabled detailed individual particle analysis. The CCSEM/EDS data revealed mostly crustal particles in both the Phoenix fine and coarse PM10 fractions. GIS maps of multiple dust-related parameters confirm that both Imperial Valley and Phoenix possess favorable conditions for airborne crustal PM from natural and anthropogenic sources.

Investigation of time-resolved atmospheric conditions and indoor/outdoor particulate matter concentrations in homes with gas and biomass cook stoves in Nogales, Sonora, Mexico

This paper reports findings from a case study designed to investigate indoor and outdoor air quality in homes near the United States-Mexico border During the field study, size-resolved continuous particulate matter (PM) concentrations were measured in six homes, while outdoor PM was simultaneously monitored at the same location in Nogales, Sonora, Mexico, during March 14-30, 2009. The purpose of the experiment was to compare PM in homes using different fuels for cooking, gas versus biomass, and to obtain a spatial distribution of outdoor PM in a region where local sources vary significantly (e.g., highway, border crossing, unpaved roads, industry). Continuous PM data were collected every 6 seconds using a valve switching system to sample indoor and outdoor air at each home location. This paper presents the indoor PM data from each home, including the relationship between indoor and outdoor PM. The meteorological conditions associated with elevated ambient PM events in the region are also discussed. Results indicate that indoor air pollution has a strong dependence on cooking fuel, with gas stoves having hourly averaged median PM3 concentrations in the range of 134 to 157 microg m(-3) and biomass stoves 163 to 504 microg m(-1). Outdoor PM also indicates a large spatial heterogeneity due to the presence of microscale sources and meteorological influences (median PM3: 130 to 770 microg m(-3)). The former is evident in the median and range of daytime PM values (median PM3: 250 microg m(-3), maximum: 9411 microg m(-3)), while the meteorological influences appear to be dominant during nighttime periods (median PM3: 251 microg m(-3), maximum: 10,846 microg m(-3)). The atmospheric stability is quantified for three nighttime temperature inversion episodes, which were associated with an order of magnitude increase in PM10 at the regulatory monitor in Nogales, AZ (maximum increase: 12 to 474 microg m(-3)). Implications: Regulatory air quality standards are based on outdoor ambient air measurements. However, a large fraction of time is typically spent indoors where a variety of activities including cooking, heating, tobacco smoking, and cleaning can lead to elevated PM concentrations. This study investigates the influence of meteorology, outdoor PM, and indoor activities on indoor air pollution (IAP) levels in the United States-Mexico border region. Results indicate that cooking fuel type and meteorology greatly influence the IAP in homes, with biomass fuel use causing the largest increase in PM concentration.

An aerosol climatology for a rapidly growing arid region (southern Arizona): Major aerosol species and remotely sensed aerosol properties

This study reports a comprehensive characterization of atmospheric aerosol particle properties in relation to meteorological and back trajectory data in the southern Arizona region, which includes two of the fastest growing metropolitan areas in the United States (Phoenix and Tucson). Multiple data sets (MODIS, AERONET, OMI/TOMS, MISR, GOCART, ground-based aerosol measurements) are used to examine monthly trends in aerosol composition, aerosol optical depth (AOD), and aerosol size. Fine soil, sulfate, and organics dominate PM_2.5 mass in the region. Dust strongly influences the region between March and July owing to the dry and hot meteorological conditions and back trajectory patterns. Because monsoon precipitation begins typically in July, dust levels decrease, while AOD, sulfate, and organic aerosol reach their maximum levels because of summertime photochemistry and monsoon moisture. Evidence points to biogenic volatile organic compounds being a significant source of secondary organic aerosol in this region. Biomass burning also is shown to be a major contributor to the carbonaceous aerosol budget in the region, leading to enhanced organic and elemental carbon levels aloft at a sky-island site north of Tucson (Mt. Lemmon). Phoenix exhibits different monthly trends for aerosol components in comparison with the other sites owing to the strong influence of fossil carbon and anthropogenic dust. Trend analyses between 1988 and 2009 indicate that the strongest statistically significant trends are reductions in sulfate, elemental carbon, and organic carbon, and increases in fine soil during the spring (March-May) at select sites. These results can be explained by population growth, land-use changes, and improved source controls.

Evaluation of levels, sources and distribution of toxic elements in PM10 in a suburban industrial region, Rio de Janeiro, Brazil

The Oswaldo Cruz Foundation Campus (FIOCRUZ), in a suburban region of the city of Rio de Janeiro, was selected as a case study to assess the pollution released from vehicle and industrial facilities in Basin III, the most polluted area of the city. Concentrations of particulate matter (PM10) and trace metals in airborne particles were determined in an intensive field campaign. The samplings were performed every six days for 24 h periods, using a PM10 high volume sampler, from September 2004 to August 2005. PM10 mass concentrations were determined gravimetrically and the metals by ICP-OES. For PM10, the arithmetic mean for the period is 169 +/- 42 microg m(-3) which is 3.4 times the national recommended standard of 50 microg m(-3). Additionally, 51% of the samplings exceeded the recommended 24 h limit of 150 microg m(-3). Ca, Mg, Fe, Zn and Al were the metals that presented the higher concentrations. The correlation matrix gave two main clusters and three significant principal components (PC). Both PC1 and PC2 are associated to crustal, vehicular and industrial emissions while PC3 is mainly associated to geological material. Enrichment factors for Zn, Cu, Cd and Pb indicate that for these elements, anthropic sources prevail over natural inputs. PM10 levels showed a good correlation with hospital admissions for respiratory diseases in children and elderly people.

Exposure to PM2.5 and PAHs from the Tong Liang, China epidemiological study

Chemically speciated PM2.5 and particle-bound polycyclic aromatic hydrocarbon (PAH) measurements were made at three sites near urban Tong Liang, Chongqing, a Chinese inland city where coal combustion is used for electricity generation and residential purposes outside of the central city. Ambient sampling was based on 72-hr averages between 3/2/2002 and 2/26/2003. Elevated PM2.5 and PAH concentrations were observed at all three sites, with the highest concentrations found in winter and the lowest in summer. This reflects a coupling effect of source variability and meteorological conditions. The PM2.5 mass estimated from sulfate, nitrate, ammonium, organics, elemental carbon, crustal material, and salt corresponded with the annual average gravimetric mass within +/-10%. Carbonaceous aerosol was the dominant species, while positive correlations between organic carbon and trace elements (e.g., As, Se, Br, Pb, and Zn) were consistent with coal-burning and motor vehicle contributions. Ambient particle-bound PAHs of molecular weight 168-266 were enriched by 1.5 to 3.5 times during the coal-fired power plant operational period. However, further investigation is needed to determine the relative contribution from residential and utility coal combustion and vehicular activities.

Levels of selected metals in ambient air PM10 in an urban site of Zaragoza (Spain)

An assessment of the air quality of Zaragoza (Spain) was performed by determining the trace element content in airborne PM10 in a sampling campaign from July 2001 to July 2002. Samples were collected in a heavy traffic area with a high volume air sampler provided with a PM10 cutoff inlet. The levels of 16 elements (Al, Ba, Ca, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, Pb, Sr, V, and Zn) were quantified after collecting the PM10 on Teflon-coated glass fiber filters (GFF). Regarding the PM10, 32% exceedance of the proposed PM10 daily limit was obtained, some of them corresponding to summer and autumn periods. The limit values of toxic trace elements from US-EPA, WHO, and EC were not exceeded, considering Zaragoza as a moderately polluted city under the current air quality guidelines. The contribution of anthropogenic sources to atmospheric elemental levels was reflected by the high values of enrichment factors for Zn, Pb, and Cu compared to the average crustal composition. Statistical analyses also determined the contribution of different sources to the PM10, finding that vehicle traffic and anthropogenic emissions related to combustion and industrial processes were the main pollutant sources as well as natural sources associated with transport of dust from Africa for specific dates. Regarding the influence of meteorological conditions on PM10 and trace elements concentrations, it was found that calm weather conditions with low wind speed favor the PM10 collection and the pollution for trace elements, suggesting the influence of local sources.

Designing monitoring networks to represent outdoor human exposure

Measurements of outdoor human exposure to suspended particulate matter (PM) are always constrained by available resources. An effective network design requires tradeoffs between variables measured, the number of sampling locations, sample duration, and sampling frequency. Sampling sites are needed to represent neighborhood and urban spatial scales with minimal influences from nearby sources. Although most PM measurements for determining compliance with standards are taken over 24-h periods every third to sixth day, outdoor human exposure assessment requires measurements taken continuously throughout the day, preferably over durations of 1 h or less. More detailed particle size and chemistry data are also desirable, as smaller size fractions and specific chemicals may be better indicators of adverse health effects than total mass samples.

Preliminary assessments of spatial influences in the Ambos Nogales region of the US-Mexican border

Ambient air measurements collected from 1994 to 1995 were used in a preliminary assessment of potential source and spatial influences in the Ambos Nogales border region (Nogales, Arizona, USA and Nogales, Sonora, Mexico). In this assessment, volatile organic compounds (VOC) and particulate matter (PM) species were used from four sites, two on either side of the border. An examination of median levels and principal component analysis indicated the dominance of soil dusts and mobile sources. Pairwise comparisons of sites for VOCs associated with mobile sources revealed statistically significant differences between sites in the central Nogales area vs. the two sites furthest from the border. Particulate lead at Mexican sites was higher and significantly different vs. US sites. Although further analyses are necessary, findings suggest that local and immediate mobile/other anthropogenic and soil dust influences are present throughout Nogales, with particulate lead from leaded motor vehicle exhaust or soldering operations being a possible influence on the Mexican side.

Potential particulate impacts at the Grand Canyon from northwestern Mexico

Project MOHAVE was a major air quality and visibility research program conducted from 1990 to 1999 to investigate the causes of visibility impairment in the Grand Canyon National Park region. At Meadview, a remote monitoring site just west of the Grand Canyon National Park, on September 1 and 2, 1992, the concentrations of sulfate (3.1 and 4.3 microg sulfate/m3) were the highest seen in 6 years of monitoring at this site. During this period, the concentrations of SO2 at Meadview were also abnormally high and approximately three times the sulfate concentrations, on a nmol/m3 basis. High concentrations of sulfate and SO2 extended south into southern Arizona and northwestern Mexico. Based on ambient atmospheric conditions, emissions from the Mohave Power Project (MPP) 110 km upwind of Meadview could not have been responsible for the majority of the regionally observed sulfur oxides. The geographical distribution of SO2 and sulfate, and available source information suggest that northwestern Mexico was a significant source of the unusually high observed sulfur oxides. A CMB model developed during Project MOHAVE was used to apportion sulfur oxides at Meadview and other sampling sites throughout the study region for August 31-September 2, 1992. The results indicate that the contribution of MPP to sulfate at Meadview was typical. However, the transport of SOx from northwestern Mexico was elevated throughout much of the region during this time period. This led to the large increase in sulfate concentrations at Meadview on September 1 and 2. These results indicate that emissions from Mexico can be a significant source of particulate material in the Grand Canyon.

Source characterization of major emission sources in the imperial and Mexicali Valleys along the US/Mexico border

Chemical profiles for particle emissions are needed for source apportionment studies using the chemical mass balance (CMB) receptor model. Source measurements of geological sources, motor vehicle exhaust, vegetative burning (e.g. asparagus, field burning, charbroil cooking), and industrial sources (e.g. oil-fueled glass plant, manure-fueled power plants) were acquired as part of the Imperial/Mexicali Valley Cross Border PM10 Transport Study in 1992. Six different source sampling techniques (i.e. hot- and diluted-exhaust sampling, ground-based source sampling, particle sweeping/grab sampling, vacuum sampling, and laboratory resuspension sampling) were applied to acquire filter samples of PM 2.5 and PM10 (particulate matter with aerodynamic diameters < 2.5 and 10 microm, respectively). Filter samples were analyzed for mass by gravimetry, elements (Na to U) by X-ray fluorescence, anions (Cl(-), NO3(-), SO4(=)) by ion chromatography, ammonium (NH4(+)) by automated colorimetry, soluble sodium (Na+) and potassium (K+) by atomic absorption spectrophotometry, and organic and elemental carbon (OC, EC) by thermal/optical reflectance. Concentration data were acquired for a total of approximately 50 chemical species. Elevated abundances of crustal components (Al, Si, K, Ca, Fe) from geological material, carbon (OC, EC) and trace elements (Br, Pb) from vehicle exhausts, carbon (OC, EC) and ions (K(+), Cl(-)) from vegetative burning, ions (SO4(=), NH4(+), Na(+), K(+), Cl(-)) and elements (Cl, Se) from a manure-fueled power plants, and sulfur and trace elements (Na(+), Pb, Se, Ni, V) from an oil-fueled glass plant were found in the resulting source profiles. Abundances of crustal species (e.g. Al, Si, Ca) in the Imperial/Mexicali Valley geological profiles are more than twice those found in central and southern California. Abundances of lead in motor vehicle exhausts indicate different vehicle fleets in border cities. Emission profiles from field burning and charbroil cooking specific to the border area show that a majority (>60%) of emissions are comprised of carbon, with high organic to total carbon ratios (0.93 to 0.97). Abundances of sulfate and ammonium account for nearly 60% of the manure-fueled power plant's emissions. Elevated levels of metals (Na(+), Pb, Cd, Se) and byproducts of petroleum combustion (S, Ni, V) were found in the oil-fueled glass plant's emissions.