4. Ultrasonic Chemical Relaxation Spectroscopy

Effect of intervening tissues on ultrasonic backscatter measurements of bone: An in vitro study

Ultrasonic backscatter techniques are being developed to diagnose osteoporosis. Tissues that lie between the transducer and the ultrasonically interrogated region of bone may produce errors in backscatter measurements. The goal of this study is to investigate the effects of intervening tissues on ultrasonic backscatter measurements of bone. Measurements were performed on 24 cube shaped specimens of human cancellous bone using a 5 MHz transducer. Measurements were repeated after adding a 1 mm thick plate of cortical bone to simulate the bone cortex and a 3 cm thick phantom to simulate soft tissue at the hip. Signals were analyzed to determine three apparent backscatter parameters (apparent integrated backscatter, frequency slope of apparent backscatter, and frequency intercept of apparent backscatter) and three backscatter difference parameters [normalized mean backscatter difference (nMBD), normalized slope of the backscatter difference, and normalized intercept of the backscatter difference]. The apparent backscatter parameters were impacted significantly by the presence of intervening tissues. In contrast, the backscatter difference parameters were not affected by intervening tissues. However, only one backscatter difference parameter, nMBD, demonstrated a strong correlation with bone mineral density. Thus, among the six parameters tested, nMBD may be the best choice for in vivo backscatter measurements of bone when intervening tissues are present.

Low-megahertz ultrasonic properties of bovine cancellous bone

Ultrasound offers a noninvasive means to detect changes that occur to the density of cancellous bone as a result of degenerative diseases such as osteoporosis. Techniques based on the velocity and frequency dependence of attenuation of ultrasonic pulses propagated through cancellous bone have proven sensitive to bone density. Most previous studies have investigated these two parameters in the frequency range of 0.1-1.0 MHz. The present study had two goals. The first was to measure three ultrasonic parameters: longitudinal mode velocity; broadband ultrasonic attenuation (BUA); and apparent integrated backscatter (AIB), at higher frequencies using a broadband 2.25 MHz measurement system. The second goal was to assess the dependence of these parameters on bone density. Twenty-one specimens of cancellous bone acquired from the proximal end of four bovine tibiae were investigated in this study. The apparent density of the specimens (determined with the bone marrow removed and the specimens thoroughly dry) ranged between 0.3 and 0.9 g/cm(3). Ultrasonic measurements were performed along three mutually perpendicular directions corresponding to the anteroposterior (AP), mediolateral (ML), and superoinferior (SI) axes of the tibia. A linear regression was used to analyze the results of these measurements as a function of apparent density. Velocity demonstrated a highly significant linear increase with density for all three directions (AP: p < 0.001; ML: p < 0.001; SI: p < 0.01). AIB decreased with density in all three directions; however, only the ML and SI directions demonstrated a significant linear correlation (AP: p = n.s.; ML: p < 0.05; SI: p < 0.05). In the frequency range 0.5-1.0 MHz, BUA exhibited a significant linear increase in the AP and ML directions, but not the SI direction (AP: p < 0.05; ML: p < 0.01; SI: p = n.s.). In contrast, in the frequency range 1.0-2.0 MHz, BUA exhibited a highly significant increase with density in the SI direction, but no significant change in the AP and ML directions (AP: p = n.s., ML: p = n.s., SI: p < 0.001).