Method validation for mycotoxin determinations in food and feedstuffs

Aflatoxin contamination in insect damaged seeds of horsegram under storage

Studies on one of the protein rich pulses, horsegram (Dolichos biflorus L.) were carried out to know how far these low risk pulses are free from aflatoxin contamination under severe insect infestation in storage. A total of 150 stored seed samples of horsegram were analyzed for the presence of aflatoxins by collecting 25 samples each of undamaged and insect damaged seeds of all the three varieties (PDM-1, PHG-1 and HG-96). More than 33% of insect damaged seed samples were contaminated with aflatoxin B1 and B2, whereas less than 8% of the undamaged seed samples contain only low levels of aflatoxin B2. Higher levels of aflatoxin B1 (up to 130 μg/kg) were reported in insect damaged seed samples of all the three varieties under study. The levels of aflatoxin B2 were always lower than aflatoxin B1 of the corresponding seed samples with insect damage. Aflatoxin B1 was reported in both the undamaged and insect damaged seed samples of all the three varieties of horsegram. It is evident from the varietal response studies that PDM-1 and HG-96 varieties of horsegram are highly vulnerable to aflatoxin contamination whereas, PHG-1 variety is relatively less susceptible to it. In general, insect infestation leads to increase in fungal invasion (including aflatoxigenic fungi) and this further enhances the levels of aflatoxin contamination in horsegram seeds.

Development of a simplified densitometer for the determination of aflatoxins by thin-layer chromatography

A simple, miniaturised and low power consuming (battery, fully semiconductor based) detector cell (SeBaDeC) was developed for the densitometric measurement of aflatoxins on TLC plates. A UV-light emitting diode (UV-LED) with a peak emission wavelength of 370 nm was used for fluorescence excitation, while a photo diode with a peak sensitivity of 440 nm in combination with a 418 nm cut-off filter was applied for detecting the fluorescence intensity. The resulting signal was further amplified by means of a commonly used operational amplifier integrated circuit (OA) and directly converted into a digital signal with a simple analogue-digital-converter (ADC). This signal was recorded at the serial (RS232) port of a portable PC and processed with a spreadsheet program. The software used for data recording is freeware and available in its source code, and the long lifetime of the UV-LED (up to 10 000 h) permits a maintenance free application of this device. This simplified device has shown to be able to detect concentrations of aflatoxins of 1 ng, thus offering a cheap and sensitive alternative to currently available TCL scanners.

Investigation of various extractants for the analysis of aflatoxin B1 in different food and feed matrices

Various extractants were investigated concerning their suitability for aflatoxin B1 determinations in different matrices including spices, infant formula and animal feed employing an immunoaffinity clean-up procedure. It was shown that the use of aqueous acetonitrile extractants was limited due to the fact that dry sample material can absorb significant amounts of water from the extractant. This can result in recoveries that are too high and therefore in incorrect values for the aflatoxin concentration if aliquots are taken for further analysis. A correction of the results by recovery calculation using spiked blank material is unsuitable, since material from the same group of food (e.g. paprika powder) or feed can vary significantly in the recovery values. Therefore it is recommended that aqueous methanol extractants are used, since no significant interaction with matrix constituents was observed. In addition, aqueous acetone extractants are a useful alternative with some limitations.