Chapter 4 Sample handling and clean-up procedures II—new developments

Full Evaporative Vacuum Extraction─A Quantitative and Green Approach for Analysis of Semivolatile Organic Compounds in Drinking Water and Surface Water Using GC-MS

Full evaporative vacuum extraction (FEVE) was developed in this work for analysis of a broad range of semivolatile organic compounds (SVOCs) in drinking water and surface water. Sorbent pens are used in a two-stage process that first evaporates the sample matrix through sorbent beds under vacuum to recover the lighter SVOCs, followed by the application of a higher temperature and stronger vacuum to the sample vial to recover the remaining heavier SVOCs once the matrix has evaporated. After extraction, the sorbent pens are desorbed into a GC-MS using a uniquely designed "splitless" delivery system to maximize sensitivity. Critical extraction and desorption parameters that affect the method performance were optimized. After FEVE, the sorbent pens can be stored for 7-10 days at room temperature while maintaining a less than 15% loss in analyte recovery. As a proof of concept, 10 drinking water and surface water samples were analyzed using this method. 69 analytes were detected in these water samples, with the highest concentration of 1986 ng/L for bromacil. Heptachlor epoxide, chlorpyrifos, metolachlor, butachlor, and 2,3',4',5-tetrachlorobiphenyl were detected in four samples. None of the analytes were above the health and safety thresholds set by California Proposition 65.

Salting-out-assisted liquid-liquid extraction as a suitable approach for determination of methoxetamine in large sets of tissue samples

A new designer drug, a dissociative anesthetic, and a putative N-methyl-D-aspartate receptor antagonist, methoxetamine (MXE) noted by the EU Early Warning System has been already identified as a cause of several fatalities worldwide. The primary objective of this work was to develop a suitable sample preparation method allowing for isolation of MXE and its main metabolites in high yields from rat brain, liver, and lungs. For the purpose of the project, MXE and five metabolites were synthesized in-house, specifically O-desmethyl-normethoxetamine, O-desmethylmethoxetamine, dihydro-O-desmethylmethoxetamine, normethoxetamine, and dihydromethoxetamine. A sample preparation procedure consisted in the homogenization of the tissue applying salting-out-assisted liquid-liquid extraction (SALLE). A subsequent liquid chromatography-mass spectrometry (LC-MS) analysis was based on reversed-phased chromatography hyphenated with a triple quad MS system in a positive electrospray mode. Multiple reaction monitoring (MRM) was used for qualification and quantification of the analytes. The quantification was based on the application of an isotopically labeled internal standard, normethoxetamine-d3. The matrix-matched calibrations were prepared for each type of matrix with regression coefficients 0.9943-1.0000. The calibration curves were linear in the concentration range of 2.5-250 ng g(-1). Limits of quantification (LOQs) were estimated as 2.5 and 5 ng g(-1), respectively. Recovery (80-117%) and matrix effect (94-110%) at 100 ng g(-1) and intra- and inter-day accuracy and precision at low (2.5 ng g(-1)), middle (25 ng g(-1)), and upper (250 ng g(-1)) concentration levels for all the analytes in all three types of tissues were also determined. The developed analytical method was applied to a set of real samples gathered in toxicological trials on rats and MXE, and its metabolites were determined successfully.