Transfer of foreign receptors to living cell surfaces: the bioelectrochemical approach

System for measuring planar lipid bilayer properties

We present a system for measuring planar lipid bilayer properties. The system is composed of a control unit, an output stage, an LCR meter, pumps for filling reservoirs, a bath with temperature regulation and a measurement chamber with four electrodes. The planar lipid bilayer is automatically formed using a folding method on apertures of different sizes. The automatization is assured by two syringes, which are clamped in actuators. Actuators are driven and controlled by a control unit via RS-232 communication. The temperature of the planar lipid bilayer can be regulated between 15 and 55 °C. The regulation is assured by insertion of the measurement chamber into the temperature-regulated bath. Different shapes of voltage- or current-clamp signals can be applied to the planar lipid bilayer. By measuring the response of the planar lipid bilayer to the applied signal, the capacitance and breakdown voltage of the planar lipid bilayer can be determined. The cutoff frequencies of the system output stage for voltage- and current-clamp methods are 11 and 17 kHz, respectively.

Kinetics of transmembrane transport of small molecules into electropermeabilized cells

The transport of propidium iodide into electropermeabilized Chinese hamster ovary cells was monitored with a photomultiplier tube during and after the electric pulse. The influence of pulse amplitude and duration on the transport kinetics was investigated with time resolutions from 200 ns to 4 ms in intervals from 400 micros to 8 s. The transport became detectable as early as 60 micros after the start of the pulse, continued for tens of seconds after the pulse, and was faster and larger for higher pulse amplitudes and/or longer pulse durations. With fixed pulse parameters, transport into confluent monolayers of cells was slower than transport into suspended cells. Different time courses of fluorescence increase were observed during and at various times after the pulse, reflecting different transport mechanisms and ongoing membrane resealing. The data were compared to theoretical predictions of the Nernst-Planck equation. After a delay of 60 micros, the time course of fluorescence during the pulse was approximately linear, supporting a mainly electrophoretic solution of the Nernst-Planck equation. The time course after the pulse agreed with diffusional solution of the Nernst-Planck equation if the membrane resealing was assumed to consist of three distinct components, with time constants in the range of tens of microseconds, hundreds of microseconds, and tens of seconds, respectively.

Techniques of signal generation required for electropermeabilization. Survey of electropermeabilization devices

Electropermeabilization is a phenomenon that transiently increases permeability of the cell plasma membrane. In the state of high permeability, the plasma membrane allows ions, small and large molecules to be introduced into the cytoplasm, although the cell plasma membrane represents a considerable barrier for them in its normal state. Besides introduction of various substances to cell cytoplasm, permeabilized cell membrane allows cell fusion or insertion of proteins to the cell membrane. Efficiency of all these applications strongly depends on parameters of electric pulses that are delivered to the treated object using specially developed electrodes and electronic devices--electroporators. In this paper we present and compare most commonly used techniques of signal generation required for electropermeabilization. In addition, we present an overview of commercially available electroporators and electroporation systems that were described in accessible literature.