Rapid determination of trans-fatty acids in human adipose tissue. Comparison of attenuated total reflection infrared spectroscopy and gas chromatography

Physicochemical parameter based estimation of discarding points for frying oil using data interpolation and principal component transformation

Data interpolation and principal component transformation (PCT) were used to compute the discarding points of a frying oil by measuring the physicochemical parameters-acid value, carbonyl value, and total polar compounds. Herein, the discarding point refers to the time point (associated with the value of each physicochemical parameter) at which the frying oil should be discarded. First, a primary visual analysis was performed for the obtained data by using line charts. Second, a curve interpolation method was used to compute the discarding points for each parameter and thus determine the discarding points for the frying oil. At 190, 205, and 220°C, the frying oil reached the discarding points at 22.1, 17.7, and 13 hr, respectively. The discarding area was also visualized on the corresponding surfaces for the originally obtained data and the interpolated data to investigate the discarding points. Third, the PCT was conducted for the three parameters at each temperature; the discarding point estimation for the three parameters could be reduced to the estimation from the first principal component (FPC), thereby simplifying this process. At 190, 205, and 220°C, the frying oil reached the discarding points when the FPCs were 10.4524, 6.2881, and -1.7629 at the time points 22.1, 17.7, and 13 hr, respectively. Finally, a verification experiment revealed that the correlation between the results obtained by our interpolation method or PCT and the verified data was higher than 0.98, which demonstrates the effectiveness of our method.

Semiautomated depositor for infrared microspectrometry

The measurement of minute samples is desirable in many areas of research and analysis, including biological, environmental, and forensic sciences. The use of manual solution direct deposition, combined with surface evaporation, is a very useful and convenient method for the transfer of many analytes to a spectroscopic sampling window. For Fourier transform infrared (FT-IR) spectrometric analysis, high quality attenuated total reflection (ATR) and transmission analyses are possible with suitable solution deposits. If the sample area is very small, placement of the analyte deposit on the active area of the sampling accessory must be done carefully. To achieve this, a novel direct deposition system has been developed. This system, a series of valves attached to a glass nebulizer, generates deposits that are reproducible, and placement of the deposits is precise. The valves allow the sample to be loaded, helium airflow to expel the sample, and the nebulizer to be cleaned after deposition. To help contain the sample to a small area once deposition has taken place, a vacuum line is attached to the nebulizer. This simple semiautomated deposition system allows for higher sensitivity and run-to-run reproducibility for minute sample analysis.